Having problems with your Dishwashers ?
Frigidaire dishwasher will only work in heavy duty cycle. The others it just shuts off. What could be the problem?
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Frigidaire dishwasher will only work in heavy duty cycle. The others it just shuts off. What could be the problem?
We have a KitchenAid dishwasher (KUDI01FLSS6) which has not been working properly for a long time. We have the dreaded green blinking light mystery. We understand that this could indicate several different problems. We have found that if we run the sink water until it is hot, then start the dishwasher, and then after ten minutes we open then shut the door, it will consistently run the full cycle perfectly. Does this give you any hint of what might be the problem component -sensor, element, the
... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher
I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the
Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher
Pld2560lcc1 Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.
Pulled the touch pad, go after the middle third with a very small screw driver, cleaned the flex circut with contact cleaner\015\012\015\012powered up fine seems to be working again ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher
PLD2560LCC1 Frigidaire Dishwasher...Control Panel shows 65 minutes left on lower rack, works for about 1 minute, shuts down. None of the buttons work. I changed the control (major circuit) board, same problem. I wonder if it's the control "panel"? I took that off and looked at it. Seems okay, but could the problem. I've heard this model has control problems, but I'm not sure if they mean the major control board or the control panel that has the buttons.
... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher
I have a whirlpool model KuDSO1FL and the clean light blinks and won't start after the cycle has been selected and the start button is pressed. I have tried canceling the cycle but it won't work. The dishwasher was working yesterday and today it drained once we cancelled the cycle and then pressed start but that is all that we could get done. I don't know what the problem is.
Your appliance's clean light blinking will require a service call. It could be several things indicating a problem that are not serviceable by the home owner. You can try turning the power off at the breaker box, then turn it back on and see if this ... Dishwashers
I have a SMEG dishwasher. Can't find the model number on dishwasher or manual. Had two flashing lights and referred to manual - indicates a blocked filter. Cleaned that out, but now when I try to put it on "light" cycle (indicated by wineglass symbol), that light flashes (but no others as would indicate a problem).. All the other cycles work fine. Any ideas? Thank you!
Hi.If only the crystal light is flashing and no other light is on, then that is not an error code. Problem can be a temporary malfunction, or a defective control module or keypad.The delicate (crystal) light flashing with last ... Smeg 24 in. STX2 Built-in Dishwasher
I bought this dishwasher 5 years ago and was kept in the box until last month. I installed it, turned on the water and no water is being pumped into the unit from the water release valve in the dishwasher. I then checked all the cycles and everything works except for the pump. Then I checked to see if any power/volts was going to the pump and there is none. Could it be a wiring problem or could it be the circuit board?? please help. thanks
You will have to check all the connections visually. Since you know how to use a meter, see where the current stops. See if there is current coming from the control board to the pump. the water inlet solenoid valve should "free flow" water into the m ... GE 24 in. Profile PDW7800 Built-in Dishwasher
I have a Maytag Quiet Series 300 dishwasher model number MDBH955AWW. When I press the wash cycle button it starts and then automatically jumps to the rinse cycle. After going thru the rinse cycle for a couple of minutes, it shuts off. After that,I can push the wash cycle agin and it works. Any idea what could be wrong?
HI. This will be a basic logic chip fault. It could possibly be solved by simply preforming a hard reset. You can do this by shutting down the power to the unit for five minutes. This shutdown will force the logic sector of your electronic control bo ... Maytag 24 in. MDB9750AW Dishwasher
I have a bosch smu 2000 series dishwasher. it has always worked well with no problems but then all of a sudden a week or so ago, the water stopped coming into the dishwasher to wash the dishes. the faucet and all other water areas continue to work w/o problems (i.e. bathroom, shower etc). in attempting to use the dishwasher, the entire cycle seems to be working, i initially hear what sounds like an initial water discharge when the cycle first starts and during the entire cycle it sounds like it
... Bosch Dishwashers
Neff dishwasher i have a slimline dishwasher. when turned on and door shut it sounds to be working but no water is getting in to clean . water valve is turned on .any ideas of what could be the problem?
Hi cewins,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: you have a slimline dishwasher. when turned on and door shut it sounds to be working but no water is getting in to clean . water valve ... Neff Dishwashers
Noisey maytag We have a maytag quiet series 300 with the 3 racks. Just recently we have been hearing alot of noise from our dishwasher while it is in the washing and rinsing mode. We have checked the arms to make sure they are moving but doesn't seem to be a problem. Thought maybe there is a liquid that we could pour into the washer to run through it's cycle? Of course we know nothing about the inter works of a dishwasher.
Hi, i had the same problem twice and both time there was some plastic stuff in the shredder. Remove the screw in the middle and remove the cap and you will probably find some pieces near the blades. ... Maytag 24 in. MDB5651A Built-in Dishwasher
I have a dishwasher that hasn't been draining properly. For a while I could hit cancel drain cycle again and it would clear 1/2-1 of water out. But now that doesn't always do it. Someone told me to take filter out and see if it needs to be cleaned. Otherwise we have no other sink/plumbing problems with other kitchen areas. Please help! one handyman told me no use to work on dishwashers they are just throwaway with parts/service being so expensive.
The advise you recieved is correct. You will need to pull the unit out of the cabinet and disconnect the drain hose from the rear. Then remove the cover, There is a filter inside. If its clean then its time for a replacement unit. You could have a ... Whirlpool Dishwashers
Problem for Kenmore 24 in. 15992 Built-in Dishwasher Previously answered by Ginko but have not had any responses since June 18 and problem not solved. No water flow into dishwasher. Actual model is Kenmore Elite undercounter dishwasher 665.15982990. Float is not stuck. Worked fine for 10 years until mid May. Display shows cycle is on and counting, for all the different cycles. No valve or motor sound when starting cycles, only a single electronic click. When cycle is canceled, motor does s
Hi.Sorry about your old query.If there is no power on black wire and no filling, then check and eventually replace the thermal fuse. The thermal fuse is attached to control board. If it is faulty it will read continuity, norma ... Kenmore 24 in. 15992 Built-in Dishwasher
My LG dishwasher is working perfectly, but it seems to be making a disturbing grinding sort of noise washing no matter which cycle I use. i frequently clean the filters, and if it needs oil or salt. What could be the problem???? I hope I get a quick reply. thankyou
Knmv;lkbncvgmj ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher
We have a Kenmore Ultra Wash Dishwasher, several years old. The lock light went on yesterday and we could not put it on wash or anything. We hit cancel, unplugged the machine, left the door open so it would stop the cycle...nothing worked. How do you get the lock off when it goes on like that? I just went into the kitchen, shut the door and the lock was off, strange.
There is a key (usually the dry key) that needs to be held for 4 seconds to turn the child lock on or off. If it comes on again try holding this key for 4 seconds.If it was pressed and held by mistake this could cause the lock to activate ... Kenmore Dishwashers
GE GSD4320Z00BB dishwasher drain pump not pumping down machine during normal cycle. The pump does work using test mode, therefore not a pump problem, no clogged lines (confirmed) what else could it be?
... GE Dishwashers
I have a ge profile pdw8200 dishwasher. it goes thru a patial cycle then shuts off. now i have no power to the control panel. could it be a problem with the control panel. if so are they expensive and difficult to replace?
... GE PDW8200NWW / PDW8200NBB Dishwasher
I have a Jenn aire jdb8910aww dishwasher and after every type of treatment and cleanser I still cannot get the powdery residue to go away. The only thing that works is white vinegar, but i have to use it in every cycle. I even have a water filtering system in our home. What could be the problem?. Thanks, Michelle
Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Jenn-Air 24 in. JDB8910 Built-in Dishwasher
I have a Beko DWD5410W dishwasher. It has been working well for a couple of years now. Last week is stopped during a wash cycle and now when you switch it on, it fills with water to the top of the filters (as normal?) and stops. Nothing further happens no matter how long I wait unless I switch the machine to drain mode. Do you have any idea what the problem could be or how I can go about investigating further? Many thanks in anticipation
Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...thank u rate me ... Dishwashers
Our Asko D3112 was not draining, so we had maintenance drain the hoses to clear any blockage but it did nothing. They said it must be our pump not working. I ran one more cycle to see if things went back to normal, however now our pump won't shut off. We have to unplug the machine just to get the pump to stop. We had a repair technician come to look at the dishwasher and he says that it is a problem with the control panel/computer system. Something tells me it is a merely a loose wire and that w
Check your manual to see if you have a drain pan at the bottom of the unit, and a 'float' that checks for water collecting there. On at least some Asko models, water collecting in the pan causes the float to rise, which then changes the operation of ... Asko 24 in. D3112 Free-Standing Dishwasher
I have a ESF1600 model of an Electrolux dishwasher and at present it works sometimes and then not at other times. When you put it on a cycle it does not allow water in the power light comes on and the dial moves but it does not fill up. Could you tell me where to get a manual from for this brand and let me know what the problem may be.
If you remove the bottom panel under the door, and look for the water inlet valve, I think you might find that the wires going to it are either not completely seated, or something like that.While down there, check and make sure the wires ... Electrolux Dishwashers
The top drawer of my fisher paykel dishwasher stops during the cycle and shows an icon of a tap with a line threw it (assume that means no or low water pressure). the bottom works fine so I assume water pressure is not the issue; is there a sensor that could be bad? Also, I did switch the controllers between drawers (good instructions on the fisherpaykelparts.net website) but the problem stayed with the drawer, ruling out the controller.
Did it fill with water? could be 1 of your water valves is faulty, or the little filter for the inlet water is blocked. please reply 4 more help. i"m sure i can fix this problem for you. good luck. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
I have whirlpool dishwasher 2007. everything works but the rinse cycle..it makes a gurgle noise and spits out a little water and thats it..what could the problem be?
Check the waste food drain sump below the screen,then chk the pump in the sump area,then chk that the house drain is clear where its hooked to ... Whirlpool 24 in. GU980SCG Built-in Dishwasher
My Amana dishwasher will not start anymore. The selection panel lights stopped turning on a few months ago, but we could still push the start button to start the cycle. Now that won't even work. Obviously an electrical panel problem, but what can I do to fix it?
... Amana 24 in. DWA22A Built-in Dishwasher