Having problems with your Dishwashers ?

Kenmore ultra wash dishwasher 665 - 1357 arm doesn't spin during wash


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Elite Ultra Wash Dishwasher - top rack arm not spinning


Hi: I just posted a similar problem, but found a solution. After taking the arm, etc. apart (and verifying no blockages), I thought maybe the lack of water pressure was being caused by the fact that there are TWO holes for the top spray arm (higher ... Dishwashers

Kenmore ultra wash dishwasher 665 - 1357 arm doesn't spin during wash


... Dishwashers

After about 2 yeares, my Kenmore Ultra Wash 13713K Dishwasher suddenly will not get the dishes in the top rack clean. Nothing seems to be clogging the tubing, and nothing is preventing the upper arm from spinning.


... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

We have a kenmore ultra wash dishwasher and my husband recently replaced the whole upper arm spin unit and and it working for a few weeks and now it's not working again. Any suggestions.


... Kenmore 24 in. 17512 Built-in Dishwasher

I have a Frigidaire Ultra Quiet Plus dishwasher. The top spray arm isn't spinning during wash. The bottom spins fine and I can spin the top freely by hand. It appears there is not enough water pressure gettig to the top spray arm. Any suggestions? Tanks, Sam


I may have the answer. I had what sounded to be the same problem. I found the dishes were dirty after they were cleaned, but I found there may have been a big pot lid blocking the upper arm. I decided to run the machine again, and after a bit open ... Frigidaire Dishwashers

How do you remove the lower spray arm on a Kenmore Ultra Wash (665.17019.402)? I was told to hold on to the plastic screw and spin the arm counterclockwise to remove, but I've been spinning and spinning, at leat 100 rotations, and it is not coming off. I've uploaded pics so you can see the apparatus. http://picasaweb.google.com/gregoryor/Dishwasher?feat=directlink


Hi, In the center of the spray arm is a threaded piece of plastic/bolt.\015\012Use pliers and turn that tab on the bolt. If it doesn't turn easy. Holt the bolt and try to turn the spray arm with you hand.\015\012It will release the spray ... Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore My dishwasher was in my home when I purchased my home. It is a Kenmore Ultra wash 2, I am not sure which settings to use for basic dishwashing. When I run it it runs for over 1 hour. I don't want it to run that long.


Make sure you run water in your sink until it is hot before you start the dishwasher. On the newer dishwashers they will fill and drain until the water is hot enough so it takes longer if it starts with cold water. Normal time for a basic wash coul ... Kenmore 15129 Built-in Dishwasher

The note by FixAllPhil entitled "Poor cleaning or noisy pump on Whirlpool or Kenmore dishwasher" has a significant error. The first step should be to "Remove the lower wash arm (1) by turning the nut CLOCKWISE (right)". I damaged the threads on my dishwasher nut by trying to turn it counterclockwise. Once that error is corrected, please remove this post.


Thank you! ... Whirlpool Dishwashers

My Kenmore Elite dishwasher doesn't wash dishes properly. I think that it is not getting enough water in the machine. It only allows about an inch of water to get into machine and then starts. I do not think that there is enough water to spin wash arms. I have 40 PSI coming into the house. I am on well water and found debris in the intake orfice. I did my best to flush. Could it still be bad?


I am having the same problem with my brand new Dishwasher. ... Kenmore Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

Sears kenmore dishwasher; model: 665.13763K600 (made by Whirlpool). Dishes have debris after washing in all cycles. Arms spin, water is running, dishwasher drains, and I removed the sump assembly to clean the chopper inlet. How do I diagnose it. I put it into diagnostics cycle and am unable to identify the issue.


... Kenmore 24 in. 16012 Built-in Dishwasher

I have a kenmore quiet guard dishwasher, model # 587.16252 400. It fills with water and goes through the cycles. The problem is the lower wash arm spins and shoots water, but the top arm won't. Any ideas?


... Kenmore 24 in. 16259 / 16254 / 16252 Built-in Dishwasher

Our Kenmore dishwasher 665.1726 doesnt seem to be cleaning as well. LAst time this happened a serviceperson cleaned out a filter where food debris had clogged the water flow. We were able to take off the bottom wash arm but couldn't figure out how to get the filter off (there are 4 screws holding it in place and one is under the plastic arm that caries water to the sprayer.


I had the same problem!\015\012\015\012The arm WILL come off....you have to pull the screen off. ... Kenmore 24 in. 15689 Built-in Dishwasher

Washer goes through complete cycle but doesnt totally drain. there is about 1 inch of dirty water left in washer. this washer is over 1 year old, kenmore ultra wash


Make sure your Drain Pipe is properly fixed . any Blockage in the Drain Pipe Creates the above mentioned Problem ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

I have a Kenmore Elite Ultra Wash Dishwasher 665.1319 and it uses all of the rinse aid added in 1 day. The setting inside is set at the factory set of 2. Any suggestions on how to fix that?


... Dishwashers

I see the pressure tower for a Kenmore Ultra Wash Quiet Guard dishwasher laying in the bottom of the dishwasher. I've just rented the house and haven't used the dishwasher yet. Does this pie


No, the designers put it in there for a reason; it won't work as well without it, as it would with it in. Probably the mounting tabs are broken or sprung. A new tower isn't very expensive. You can probably get one from SearsPartsDirect.com, Repair ... Kenmore Dishwashers

How to remove spray arm from Kenmore dishwasher ultra wash 665.1435


... Kenmore Dishwashers

I have a Kenmore Elite-not sure where to find the model number but the manual lists 665.160524, 1650594, 160534, 170524, etc. the problem is that the top dishes are not being washed. nothing is blocking the arm from spinning. Should water be coming down from the top? It doesnt appear that it is. Nothing seems to be reaching these dishes


Hello. The problem is most likely in the rear of the top drawer. Pull out the drawer and empty it of all dishes. In the very rear you will see a tube that will align with the water supply tube on the rear of the machine. there are little clips th ... Dishwashers

I have a kenmore elite smart ultra wash that used to be pretty quiet then got noisier and now it cycled thru very slowly but did not clean anything. the door for the detergent opened and the tablet dissolved but i dont think any water was used. both swing arms seem to be free and spin. water is going to the unit and it definitly has power.


Do u have hard water is so go to your local hardware and get that solution for it to remove hardwater stains and run it threw your system..it could be cloging up.. ... Kenmore Dishwashers

I have a Kenmore 17659 Ultra Wash III and when I run it, the water doesnt appear to be getting into the dishwasher. It turns on and goes thru the cycle but the dishes dont get cleaned.


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Tr ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

The green clean light is flashing on my Kenmore Elite Ultra Wash dishwasher. After the reset sequence, the washer will run only 1 part of it's washing/drying cycle, then flash the clean light again... I have only owned it about 14 months, and this is the first problem I have had.


You may just need to reset your control board. Go to the link and it will explain how to reset the control board as well as explain what might cause the issue and how to fix it.http://www.appliancerepairlesson.com/dishwasher-2/dishwasher ... Kenmore 24 in. 17032 Built-in Dishwasher

The dishwasher is not cleaning the dishes at all, so far I have done the following: Checked both sprayer arms and they move freely and do not appear to be clogged (I ran stiff wire thru holes in each The float is not stuck and moves up/down easily The water leavel in bottom of tub does appear to be low - so I added water filiing tub to heating coil - however this did not help and the water did not spray on lower or upper racks - this is an older model Kenmore Ultra Wash WHAT DO I NEED TO CHECK N


Heating element may have burned out. Check water temp during wash--should read between 130 to 140 F.If not the heating element,you may have to replace pump-motor assembly or wash impeller.Hope this helps. ... Kenmore Dishwashers

Help My Kenmore ultra wash quiet guard 1 dishwasher door will not open. There is power. All the cycles work.


Wow that could be a tough one there is no door lock on a dishwasher only a door latch what happens when you depress the door latch and can you send me a model number so i can pull up the blue prints and see if we can figure out a way to open it try p ... Kenmore 24 in. 15932 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2650 seconds