Having problems with your Dishwashers ?

Dishlex Global 300 the Economy light is flashing and the machine seems to be on but nothing is happening? Thanks Robert.


Answers :

Check for leaks or the drain pump may be faulty
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishlex Global 300 the Economy light is flashing and the machine seems to be on but nothing is happening? Thanks Robert.


Check for leaks or the drain pump may be faulty ... Dishwashers

Hi - My Electrolux ESL63010 dishwasher seems to be stuck mid programme. It was part way through a programme when we had a pipe burst. Pipe all sorted now but the dishwasher just makes a noise like it is asking for water but nothing happens. When you open the door, it makes three short beeps and the light flashes on the programme menu. Any ideas how to solve? It definitely is not the pipes as the washing machine feeds from the same pipe and is working fine. Help!


... Dishwashers

I have a Siemens Aqua Vario. The machine stopped in the middle of a program and there's water left in the bottom of the machine. The light's still on as if the machine was running, but nothing happens. I have tried to restart the machine, but nothing seems to happend. What can be the problem and what can I do?


... Dishwashers

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

FDW60 Hello, I have a Hotpoint FDW60 dishwasher. It seems to have the usual quality issues but the actual problem is different to most I see on here. The machine has only been used about 20 times, but yesterday the following happened, I loaded and selected intencive program, when I pressed start the machine made a shriek/chipping sound, it seemed to run for about 5 seconds then stopped with the power and prewash lights flashing erraticly for about 3 seconds then was totaly dead, no power light o


Tom,\015\012If your dishwasher is still under warranty, best thing will be to contact Hotpoint's service center for repair the problem. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a zanussi tempoline dishwasher, I have loaded this as I usually do, turn the knob to the right and select the 2nd programme the light next to this comes on, I have pressed this to start the machine although it seems as if it is going to start this light flashes and the top arrow on the right of this flashes intermitanly, but the machine does not start the wash programme. The 3hr delay button if I had pressed this by mistake which I am sure I have not would light up. When I found it did no


Hi Ruth.The machine can be in error mode. In this case one or more lights in the control pad will stay on or flash and the cycle will not start.One of the most common fault in your situation, and at start of the cycle is no wa ... Zanussi Dishwashers

The start button flashing continuously and the filter area seems to be full of water but when I take it out it is perfectly clean. I have switched the machine on and off several times but each time the start button indicates a fault. I have tried holding down the on button so as to stop the start button flashing so that I could select a program - this did work once and I selected my program but 10 mins in it stopped and started beeping... I have a ADG7460 machine - HELP! I'm going crazy!


Please clarify what you mean by "..but when I take it out it is perfectly clean.." are you saying the water in the filter area is clean. \015\012\015\012Turn the power off and take out all the water by hand using a small container. Turn t ... Whirlpool Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Model #PLD4555RFC0 The control panel lights on the front are all flashing and start cancel button will not change anything. flashing Er with wash, dry, clean, and and S showing. Top controls have China/Crystal light flashing and Low rinse agent light flashing. Nothing seems to work


... Frigidaire Dishwashers

Whirlpool dishwasher Model GU1200XTL 80, Serial #FM4515914. The two fans are not turning though the machine seems to be running but nothing happens besides the water will fill up then drain out. Nothing gets clean. There is nothing blocking the fans and it was working fine. Please advise - thanks.


... Whirlpool GU1200XTLS Stainless Steel Dishwasher

My problem was eco & prewash lights flashing so I followed instructions on Fix Ya to reset which seemed tomwork machine went through complete sequence but then reverted back to lights flashing aga


Hi, not sure if its relevent but we have a hotpoint aquarius DWF50 machine, light flashed same at times, sometimes push the switches would not operate properly to select a program. Lately the pump for emptying water at the end of a cycle would contin ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

Have whirlpool gold dishwasher made in Mexico, the control lock light stays on, when i push it and hold it just blinks three times and then stays on steady and then does the same over and over, before it did this I noticed the lights for different cycles flashing randomly, and even pushing cancel button once in a while would start the machine up....I have tried to unplug the machine and then plug back in, but nothing is helping....any ideas??


... Whirlpool Dishwashers

Machine doesnt start . when on button is pushed and regular wash button is pushed it goes to agent and cycle is at 0 flashing (both 0 and agent lites).have tried to shut it off and main switch and turned it on and off a few times. and still the same


Because the timer controls many operations, a faulty timer can cause many problems. The timer is a complex component, so you shouldn't attempt a do-it-yourself repair. Test the timer with a VOM set to the RX1 scale. To gain access to the timer, ... Bosch Dishwashers

Frigidair model FDB520rHB2 Bought this brand new dishwasher and had it professionally installed. The unit seems to cycle fine, but after it's done, there is always a pile of detergent on the machine floor from where it dropped out of the dispenser. Plus the dishes are somewhat clean, but not all the way. I've tried all the trouble shooting that I could come across, but nothing seems to work. We have tried liquid, tablet and powder detergent with all the same results. Any ideas? Thanks


... Dishwashers

Hi I have a Dishlex Global 300 that seems to stop at the end of a cycle and the red rinse light is flashing and there is still water in the bottom of the dishwasher, it doesn?t seem o be draining.


Since\015\012 the drain pump will pump the water out using the "cancel/drain" \015\012button, if it did not work then your problem is likely to be in the drain hose system or the \015\012garbage disposal downstream from ... Dishwashers

There is always condensation on the inside of the door and some water on the floor of the machine after washing. The main thing is the foul odor that is inside the machine after a day of sitting with dishes in it. I have checked for obstructions and there are none visible and I have washed the little basket. Nothing advised in the manuel seems to help, although the odor problem is not mentioned in the manuel. I HATE THIS DISHWASHER! I wish I had my former, much less expensive Maytag back.


Hi,Check your heating element.. A bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not Worki ... Bosch Dishwashers

I have a Whirlpool Gold Quiet Partner III (Model GU1200XTKB0). I have used it previously on "Normal" cycle and I always keep it on Air Dry. Last night I used the "Pots and Pans" cycle and it seemed to work fine. But this morning the Air Dry light is flashing and if I press a cycle key the Rinse Only light starts to flash as well. Nothing works. I have made sure that the console is not locked. Any suggestions? I do not have a Heated Dry button, only Air Dry. Thank you.


... Dishwashers

Our Miele 75 carat dishwasher won't drain. The red light comes on, but nothing seems to empty it. We've checked the drainage pipe, but the problem seems to be inside the machine. We've tried using a drain cleaner, but it has had no effect, even after 24 hours. Any ideas?


Just on the offchance, try the following. throw down an old towel, and tip the appliance right onto its side. If the anti-flooding switch has got stuck, you may be in luck this may reset it. (Have successfully used this technique several times on our ... Miele Dishwashers

Whirlpool ADG6962: The power light is flashing. When I push the power light and hold for a second, the machine seems to start it's drain cycle, but then stops and the power light continues to flash.


... Whirlpool Dishwashers

I have a Miele G 2470 scvi dishwasher. Machine displays F24 in display, lights flash, machine beeps and it won't run. Miele manuals seem to have no reference at all to error message displays. any thoughts?


... Miele Dishwashers

Our Whirlpool KUDP01ILBS2 dishwasher isn't working like it used to. Dishes seem to be getting partially clean, they aren't getting dry at all and it seems they may be being rinsed/washed with dirty water. There is plenty of water in the machine when I interupt the cleaning cycle. I always run the hot water in the sink before I start the dishwasher so the first water into the dishwasher is as hot as possible. Also the sani-rinse light is flashing when the cycle "completes".


Heat that is retained in the dishes is largely responsible for drying\015\012in this dishwasher. Since plastics do not retain heat very well, they\015\012will not dry as well as glasses, ceramics or metal dishes. Rinse aid\015\012must be used so that ... Dishwashers

I have a KUDSO2FRWHO- this was the closest I could find to it. I think we had a power surge at the house- now my Normal button flashes constantly. If I push cancel, then the normal and cancel bottons flash together. I have tried unplugging it and replugging, nothing seems to help- what should I do?


Unfortunately the control board is faulty. you will need to open the top section of the door to gain access to the board. With door open, you will see 6 screws that need to be removed to pull top section away, There you will see the board. Take th ... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1370 seconds