Having problems with your Dishwashers ?

I have DW60BI dishwasher that has stopped working. Doesnt pump water, only makes the noise that indicates it has finished.

\015 It was at first doing the cycle until 10 mins in and then started making the binging noise,(which normally indicates the wash has finished) but now just sounds like the machine is starting up but thats it. !!! Has it died or could it be fixed? \012\012Any advice welcome.\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have DW60BI dishwasher that has stopped working. Doesnt pump water, only makes the noise that indicates it has finished.


... Dishwashers

When starting wash cycle the dishwasher cda cw447 doesnt appear to be getting enough water in and is making a droning / whirring / electrical ? noise. pipes all connected ok inc aquastop water supply unit, no kinks etc. machine 3 1/2 yrs old, just started making this noise. appears to complete rapid cycle but still making unusual sound. water drains away fine from this cycle, dont believe pipes / hoses are blocked.


Try removing the inlet pipe, and refitting, might fix it, else likely that the \015\012Inlet water soleniod failing/failed or tiny mesh filter (it does come out for cleaning) behind the inlet hose clogged. Temporaily bypass the aquastop water s ... Dishwashers

Made funny noise; stopped to investigate; then wouldn't restart; followed directions below from FixYa and restarted. It finished the cycle, apparently correctly, except it left a little water in the tub. Also, continued to make a lot of noise--a loud motor hum/buzz or similar. Did not make this noise during dry cycle. Dishwasher is Kenmore Model 665; stock number 16839. Can you give continued diagnostic instructions? Appears there is a cracked washer under the lower wand assembly; th


The solution was nearly correct. The person who answered only forgot to mention that water level and pressure switch must be tested. This can cause drain pump working longer than necessary and humming, and machine underfilling, which can cause noise ... Dishwashers

If i switch on my dishwasher, all lights flash on and off red,and it's makes the beeping noise when it does when the wash is finished... no water is coming in either... please help... it does nothing and you cannot press any of the buttons to use a cycle. it is making a humming noise. i have checked the filter in the bottom of it, and have switched it off at the wall and back on again. cheers,


Un plug it remove bottom drawer. look in back left corner of cabnet on bottom, is it wet dry it out and try again ... Fisher and Paykel Dishwashers

Maytag diswasher MDB6600AWW Sprayer arms don't spin. Dishwasher makes all the right noises, except for spraying. Water fills properly and heats up. Water drains properly. Found paper on the back of access panel. Ran Manual Function and Field Service tests, no problems indicated. Disassembled all the pieces inside the bottom of the dishwasher. No obviously damaged parts. Shaft for motor turns freely. It seems like the parts that attach from the impeller to the motor shaft don't


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

I have a SMEG slimline dishwasher (about 5 years old). When I try to run a cycle, it makes all the right noises, except the sprinkler/jets dont come on and no water comes out of them. I can hear the water being pulled into the system but it doesnt kick in to actually start a wash cycle. Any ideas?


Hiyahave you checked that the jets aren't blocked if they are not blocked i wud 100% says its the water pump that isnt workingRik ... Dishwashers

Hello Dishwasher Whirlpool DWF A00 - the light is flashing indicating a fault. The interior appears to be too hot and the machine was making a noise similar to an element in a kettle with insuffient water. (Although there was WAS water in for the wash) Thanks for any help!


There is a recall for such a problem you need to call whirlpool. ... Whirlpool GU2400XTP Built-in Dishwasher

Hi, I have a ge dishwasher, model number VSD2304J00WW and it does not run properly. When I turn it on, it will hum and then start to make a clicking noise. Then there will be a bad smell, and a little smoke. Also the water does not drain. I've had water in the bottom of it for a few weeks now. The cycle never finishes either.


... GE Dishwashers

Hello i have a slimline beko de2431fw dishwasher and it will not fill up with water. None of the settings seem to alter the noise it makes which indicates there is power going to it. Any help please! I have had a dishwasher repair person look at it and i thought it was fixed but its not. He charged me £50 for nothing.


... Dishwashers

MY ADL 348 dishwasher seems to start briefly, a small bit of water comes in and then its make a washing noise, and then stops and bleeps a few times. When I press the on button it does the same over again. Iam waiting on IGNIS to come out since NOv2010. We have checked the filter where water goes out and doesnt seem to be clogged


\012Hi,\012The dishwasher is not filling with water...Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Trouble ... Whirlpool ADL934 Built-in Dishwasher

Model SHU43C06UC a mouse eats a poliestirene circular piece like a float attached to the right of the bottom plastic base of the dishwasher under a grey plastic lever, now the DW runs but the cycle in the display doesn't make progress and it doesn't make any noise that indicates the water are running, help!, please advice!


Hi there sounds like your dw is in flood protection remove the poliestirene float compleatly and make sure the lever that sits on top of it is in the down position, hope this is of some help.\015\012\015\012pat no for new float is 165301 ... Bosch 24 in. SHU43 Built-in Dishwasher

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers

My Maytag Jetclean Dishwasher Model # MDB4010AWB Serial # 16163916uk is stoping midcycle, it doesnt make any noise or anything just stops. Water left sitting in bottom and have to open door then close to start again , stops again after a few minutes


Possibly a bad door switch losing contact, only after opening nad closing is it making contact again. part number for door swtiches and holder 99002254 retails for a about $25 ... Maytag Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

Cda cw 494 - dishwasher makes beeping noises and stops halfway through cycle . will restart if turned off but will not complete . doesnt seem to be filling properly .now and then does complete cycle and works fine .cheked water supply - ok.


Greetings,\015\012 usually, open and close door..then start counting the flashes. these will give you your fault code. The code then tells us where to go from there. off hand, i would say you have a heater problem.. Either, the water is not ... Whirlpool Dishwashers

My dishwasher is making a noise and will not drain. when I looked underneath, the thing that connects to the hoses was what was making the noise. It looks like some sort of motor and has copper coils in it. the water from the dishwasher flows to it and I guess it pushs the water on threw.


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Frigidaire 24 in. FDB1250REC Stainless Steel Built-in Dishwasher

I have a portable Sears dishwasher model # 66517769k600. It makes grinding noises when empying out the water, then stops. Sounds like maybe something is jaming the inpeller blades on the pump that removes the water as Water is left in dishwasher. It will restart in about 15 mins , run for 15 to 20 sec and stop again with same noises. What needs to be done to fix this issue? Approximate cost of part? Thanks in Advance, Chris


Hello &\015\012Welcome to FixYa\015\012\015\012It's a simple\015\012fix as the ... Dishwashers

Dishwasher makes grinding noise during wash cycle (after pre-wash). noise persists for 15-20 minutes. It seems as though the inlet valve doesn't open during this phase of the cycle. adding water to the dishwasher manually eliminates the noise and water circulates through the wash arms. I'm trying to determine if this is a controller issue or a valve/pump issue.


Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\01 ... KitchenAid Dishwashers

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

Bosch SHV46C Bosch dishwasher (SHV46C13UC) doesn't "start". When I start the cycle, it makes a noise but doesn't fill with water. The drain pump is working because I poured water into the basin and watched it disappear. The noise that it's making is a constant low-toned rumble/hum. I sometimes would hear this noise at the end of a cycle when things were working fine.


Replace the fill valve that sound is it trying to open ... Bosch 24 in. SHV46C13UC Free-Standing Dishwasher

Motor makes noise shortly after starting, makes normal sound level during main body of wash, then makes noise again during what I'm guessing is the rinse cycle. Not sure if it is a pump or motor problem. Slight electrical smell noticed after finishing the ''cancel/drain''. Water does not seem to be sprayed around washer during normal cycle, even though water has been in the washer.


Make sure the sprayer arm is turning freely, check for something stuck in the base of the sprayer arm (food or utinsel) preventing it from turning. ... Dishwashers

I have a Maytag MDB7100AWW dishwasher that makes a lot of noise from the motor at the end of the drain cycle. When there is water in the dishwasher it doesn't make any noise and washes well. This url (http://www.applianceaid.com/maytag-dish-noise.html) describes my problem exactly but I can't remove this part. I have unscrewed the 3 screws keeping it in place but it seems to be still attached to the motor. How can I remove it?


... Maytag MDB7100AWB Dishwasher

I am a licensed plumber who installed a frigidaire fdb1o5rem1 dishwasher for a customer about 2 years ago. It has water to the solenoid valve and the screen is clean. I can see water coming in to the unit on left side through the port hole on the inside of the unit. Dishes do not get clean and it doesnt act like water is being distrubuted inside the dishwasher. Soap never gets washed away from door. Dishwasher makes funny sound in mid cycle like the pump is not running in wash cycle. Discharge p


I can see from what you have described (by the way it is a very clear and precise description which is very helpful), there is a problem in the water circulation system. These dishwashers use an alternating water flow method to split the water circul ... Frigidaire Dishwashers

Maytag HDB8600AWW Dishwasher had been making noise (thought might be water valve, like previous DW), eventually stopped draining water, water now in bottom, I've let sit for couple weeks, looked inside, water was gone, I tried running again, it filled with water, but heard humming control panel noises for first time, then shuts itself off. Also, my handle needs replaced. Please let me know as soon as possible. Thanks in advance. David Weaver


Hi David\015\012\015\012The hum and all the noise that you have mentioned in your post states that the issue is with the pump and motor assembly. Please check the drain hose and try to clean the drain pump filter for any clogs, obstructions. Af ... Dishwashers

My siemens dishwasher has the water tap indicator light on when washing starts. i have cleaned the water filter and the spray arm but the light doesnt go off and the washing doesnt take place. Instead i can just see water coming into the drain in intervals. what do i do?


... Siemens Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2557 seconds