Having problems with your Dishwashers ?

Maytag dishwasher DWU9200 starts with high squeal


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Maytag dishwasher DWU9200 starts with high squeal


... Dishwashers

Squealing sound when the dishwasher is into mid cycle it starts to get a high pitch squeal? What could be the matter .... Its not 2 years old yet??


We have had the same problem and upon removing the main circulation pump, I found that the housing had come apart and had to order a new pump and install it. But the problem did stop there. The pump that discharges the dirty water has two stainless s ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

The rubber gasket is starting to disintegrate on my 95 Maytag Dishwasher Model DWU9200. Is is a problem to replace?


... Dishwashers

My Maytag dishwasher has a high pitched squealing noise upon startup. Any solutions?


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Maytag MDBTT79AWW dishwasher fills and nothing else. Once filled you hear a click, followed by a humming sound for 3-5 seconds, then silence. This will happen two or three more times, and then unit will shut off. Motor doesn't start. Repairman says he thinks control board is bad, but he sounds like he is guessing. I performed a field service test , which indicated a fault in the high current motor circuit. Unit is seven years old. Don't know whether to attempt repair, or replace.


That sounds like the motor trying to start but being jammed it is shutting off via an internal breaker. Check for something in the bootom of dishwasher that might have gotten down there that could do this. You might have to take the sprayer off and s ... Dishwashers

My Maytag steam dishwasher # MDBH980AWS won't do anything when I hit the start/cancel button. Nothing happens no lights go on. When I his the cycle select button only a few of the lights go on - steam clean, High Temp wash & Sanitize. The heated dry button, or the Heavy, Normal, Light cycle buttons won't light up. How do I get it started?


My Maytag dishwasher # MDBH950AWW wont turn on no light but it has power in the outlet no power to the control board ... Maytag 24 in. MDBH950AW Built-in Dishwasher

Maytag w10199645 high pitch squealing just after starting


... Dishwashers

Maytag dishwasher has power but won't start


... Dishwashers

Have the same problem as other with the maytag quiet series 300 model MDBS561AWB dishwasher. Two of the buttons on the front light up, but dishwasher will not start. Don't know if CBoard or the buttons or the ribbon cable is the problem. Took the door apart and couldn't find any condensation....Looks like maytag has done it again......could use some help with the cost of replacing all those parts. Will help me decide if better to buy new dishwasher.....preferrably not a maytag or whirlpool, or a


... Dishwashers

I have a maytag dishwasher model MDB7749AWB1 that suddenly won't start; i push the cycle that i want and push start and the light comes on like its going to start but then in about one second it starts blinking and the dishwasher never starts.


... Maytag Dishwashers

Maytage Mdb7609aww2 dishwasher wont start when start button is pushed


... Dishwashers

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea


2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

Maytag dishwasher MDB8951BWB not drying dishes throughly. Have had several Maytag authorized technicians looking at the dishwasher and saying it is operating normal. That because of the mandated energy saving requirements newer dishwashers do not dry dishes like the old ones. In addition, our older set of stainless steel silverware rusted out, my wife bought a brand new fairly expensive set and the new ones are starting to rust. After going through a wash cycle there is a foul smell similar


... Dishwashers

Describe your MDB6709AW Builtin Dishwasher Problem Maytag MDB6709AWW Most lights are on some will Problem with the Maytag MDB6709AW Builtin Dishwasher Maytag MDB6709AWW Most lights are on some will not reset... Wash cycle starts in "DRY" ... all the "DELAY" lights are on. washer appears to run through the cycles properly


... Maytag MDB6709AW Builtin Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

I have a Jenn Air high end dishwasher. It is very ambiguous on what model, type or serial number is but the number next to ''type:'' is 776-0 and there is a an E39927. jov1270awy and a 49022. None of he numbers or references have any description that indicates their purpose. Symptom: We can not get the dishwasher to start up. The buttons for choosing what type of wash will light up but when the power button is pressed it does not light up and the dishwasher will not start. Needless to say the ki


... Jackson Dishwashers

We have a 2003 KitchenAid KUDI01IL Dishwasher that will not start . We had problems with the top rack dishes getting clean and we replaced the chopper. The dishwasher worked fine for one cycle, but now will not start. The buttons have lights except for the high temp scrub light. The dishwasher will drain when cancel is hit but that is it.


... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

My Maytag NDB9601 will not start any cycle. You can select the cycle and the display will show the time, but the start and delay buttons, located on the front, not the top with the cycle buttons, will not activate. This leads to the dishwasher not working at all. It worked in the morning, but not in the evening. Dishwasher is 1 year old.


Sounds like a possible door switch problem. \015\012\015\012If you take that area of the door apart, check the ribbon cable for keypad. You can clean the connector with a pencil eraser. ... Dishwashers

Maytag dishwasher will not start - Maytag 24 in. MDB8751AWS Stainless Steel Built-in Dishwasher


... Maytag 24 in. MDB8751AWS Stainless Steel Built-in Dishwasher

Maytag dishwasher MDBH969AWS3 won't start - Maytag Dishwashers


... Maytag Dishwashers

Maytag dishwasher model number mdbh 969as flashes cycle started yet no water going into the dishwasher to start cycle


... Dishwashers

Maytag MDB7100AWB Dishwasher won't start. - Maytag MDB7100AWB Dishwasher


... Maytag MDB7100AWB Dishwasher

Start button flashes 2hr, but will not start the dishwasher, when touched. Also, lights on top of the door are not always functioning. I phoned Maytag and customer service had me turn off the circuit breaker for 5 minutes. This did not change the dishwasher. I think that the door latch is not snapping into position, when I open the door.


... Maytag 24 in. MDB7601A Free-Standing Dishwasher

We have a Maytag MDBH950AWS Dishwasher that won't start. When you press the start button the cycle light, washing light , heated dry, sanitize and extra rinse lights all come on the dishwasher fills with water and after a couple of minutes it shuts off. Any ideas what is wrong? Thanks


I have Miele incognito that when I shut the door it does not turn on? Not sure why it stopped working all the sudden ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Maytag MDBtt60awb will not start. Power definitely at dishwasher as panel lights are on, however "start" button does nothing. Dishwasher is less than 2 years old. The panel buttons eventually turn off. I've cycled the power to the unit with no response. The door is definitely latched. Unit ran fine a few days ago.


Most likely you have a bad motor when replacing the motor ihave found it is cheaper to get the pump with the motor attached where as they charge you more money for just the motor or the pump seprately try allbrands appliance parts they seem to be che ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2051 seconds