Having problems with your Dishwashers ?

My candy cdi1012/b has stopped using the salt,the reservoir is always full


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My candy cdi1012/b has stopped using the salt,the reservoir is always full


... Dishwashers

Hi our Touchdry model dishwasher isn't disolving the soap powder, we use the recommended brand Finish, worked fine up to a couple of weeks ago, now there's still a large lump left in the dispenser every morning - I always use the econo cycle, and the machine is always full up with dishes. Used a Finish cleaner yesterday but still no improvement. What's happening?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... Westinghouse Dishwashers

Continuous rinsing My son used a large quantity of washing up liquid instead of dishwasher powder and now the machine will not stop rinsing and is still full of bubbles. What can I use to nutrelise the soap and stop the rinsing?


Put 2 tablespoons of oil into the water at the bottom of the dishwasher it will help break up the suds. Sprinkle as well ordinary table salt liberally across the suds to disperse them. Try to drain the unit as much as possible, soaking up any residua ... Hotpoint 23 in. BF41 Built-in Dishwasher

Calypso washer display "FD" perhaps meand full drain and can't reset and just stop. I run washer with back cover out to see that while water doesn't fill up the drum but normally agitates and just fill up the water reservoir to full and don't drain out to sewer and washer just stops with the message "FD"


Peace broohilda,ngafm At your service!With an error code the only way to find and to repair this is,First unplug the washer and wait a few minutes then restart it like rebooting your computer when its acting strange! ... Dishwashers

I have a dewalt dp3100 pressure washer, i was using it for about an hour then it ran out of gas. After adding some gas it refuse to stop, it start for a few seconds then it would stop. its full of oil (but the oil is a little dirty) and the gas is half full. what could be the problem?


... Dewalt DPD3100 Gas Pressure Washer

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

Just got a used F&P Smart Drive 5.5 MW059. First few times I used it wouldn't always start on certain settings but once it did start it ran through just fine. On the fourth use, it was very difficult to get it to start and it just stopped after it filled up. Pausing and restarting, shutting of machine and retrying did not help. Was able to advance to rinse mode and got machine to drain water; however, instead of going into spin mode it just attempted to drain continously. I let it do its th


Did not realise this is a washing machine and not a dishwasher.\015\012\015\012Looks like some consultant has already been dealing with you on this problem.\015\012\015\012Hard to say if it is a simple as an inlet solenoid val ... Dishwashers

Smeg dwd 64 sse. everytime I put it on a full cycle it starts at the 2nd light and just remains on that programme and sometimes does not even stop I have to stop it manually. do you think its the pcb that has gone and is it worth replacing on a 6-7yr old dishwasher?? always been good up till now


... Smeg 24 in. DWF614SS Stainless Steel Free-standing Dishwasher

When the dishwasher not in use, it filled the water up by itself. And after it was full, the water leaked out to the floor. Even after I turned off power, it cannot stop. I have to shut the valve under the sink to stop it. What is wrong? It is only three years old. Hou


Hi,\012If you have a problem with your washeror dishwasher continuing to fillwith water after the valve has closed, then you this tip will help youunderstand why that is happening.Here is a tip that will help you... ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

My sound conditioned Whirlpool dishwasher is real old. It fills up completely with water. It looks like it will overflow, so I stop it. I thought it always started washing from the start. Do they always fill completely up with water, then start washing. I never noticed. I am afraid the water will overflow. Can it? Last time I ran this, it had a real loud motor. I used to hear the motor running from the start, but now I don't, just water filling up to what looks like overflow if I let it. I baile


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

I Have 3 problems with my dishwasher, my dishes are always coming out with food and grit. I've tried numerous soaps and powders, the motor makes a very loud loud every time it's used. and the latch works but I can opent the door mid cycle it doesn't stop water sprays everywhere


Regarding the problem about dishes coming with food and grit - it is possible the wash water is getting contaminated with stuff that should normally be sucked out by the drain pump up in the dishwasher. This is linked to the accumulator and chopper p ... Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

Our top rack is not getting cleaned at all-- although the rinser seems to spin freely when pushed, and fits correctly into the hole back. We were using powder detergent, and a little residue was always left in the compartment. So we tried liquid detergent, to see if it would help, and now it seems like almost none of the detergent is dissolving out, at all. The compartment's full and a goopy mess after each cycle. So now the bottom rack isn't very clean, either! Please advise. Thanks!


Welcome to FixYa,Based on your description... I`d suspect a plugged or really dirty wash pump. It could ultimately be a worn out wash impeller/chopper assembly, but I'd certainly try my suggestions before considering that. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Hi, When I turn on my dishwasher, it fills as normal with water but is not pumping into the upper spray arm. the spray arms are not clogged, I have checked them. Anyway, I always rinse the dishes under the tap before placing them in the dishwasher. I have to switch the machine on/off several times then the pump starts at full force.Occasionally it goes through a complete cycle without havig to switch on/off. It's a Siemens Lady model, E-NR SN53300GB/08, FD 7201 058479. The dishwasher is used


... Dishwashers

I have a candy trio 501 dishwasher with intergrated oven. When I put a cycle on it starts its first rinse then after 5/10 mins stops and beeps constantly. It's still full of water too. When I put it on rinse cycle it compleates the cycle so inlet and drainage should be ok. Ive removed drain pipe and made sure its not kinked and also clear. I've removed and drained the compartments that had water in and also blew down the pips to see if clear all ok. I've checked the heater element with meter and


... Dishwashers

Why is the maytag reservoir always full - Dishwashers


Most likely the drain hose or sump area / pump are plugged. See if you can locate the hose and use a wet vac to see if you can draw the water through it. If that does not work you can back flush it with a garden hose. ... Dishwashers

Thick film left on alot but not all dishes. Especially dark colors. All of my black utencils are now filmy gray and won't wash off with hand wash/scrubbing. Rinse aid is full, tried using less powder. Getting worse with each wash. Also, had always taken 4 hours to run cycle which I thought was a bit long.


The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the ... Bosch 24 in. SHU53 Built-in Dishwasher

Does not wash dishes clean like it used to. I can't see any wear or rust or anything wrong. Before this fall, it has always done a good job. We are only here 7 months - winter season - so it's only had about half the work of a full timer.


I had a similar problem with my dishwasher. It has a built-in food chopper and after a couple of years use the screen plugged up. This had the effect of cutting down the water flow to the pump and therefore the washing jets were much less effective. ... Maytag Dishwashers

We have a Bosch SHU3307UC dishwasher. Two friends swear by theirs, saying they put everything in dirty and the load always comes out clean. That does not at all work for us. My wife has to just about wash every item before putting it in, and even then most loads are not fully clean. It runs full cycle. We use good detergent. The filter basket is cleaned out. But still...dirty dishes. Help!


Put dirty stuff in will eventually keep a tech like me very busy. We love to come and charge you alot for cleaning your dishwasher.\015\012Remember the Maytag commercials where they put a cake in it ... Bosch 23 in. SHU3307UC Built-in Dishwasher

Dishwasher flood I have a whirlpool "Queit Partner I" type dishwasher. When I used it for the first time it flooded my kitchen floor. I had to stop in the middle of everything. What do I do from here. Not sure if I put in the correct detergent or if I put too much in. Never had one of these things before. I was always the dishwasher...help...I can be reached at [email protected] Thanks for your help.


... Dishwashers

Frigidaire dishwasher 15 months old. just started not washing dishes very well. set it for high temp wash. put plenty of fresh dishwashing liquid in. the unit goes thru a full cycle. you open the door and dishes are still dirty. there is always lots of dishwash liquid in the door. some of it runs down the inside of the door of the unit. just does not use all of it so dishes dont get cleaned. what could it be?


First I would check to see if it is getting enough water. There is a screen in the water inlet valve that tends to pick up debris. Follow the links Di ... Frigidaire Dishwashers

I have a bosch smu 2000 series dishwasher. it has always worked well with no problems but then all of a sudden a week or so ago, the water stopped coming into the dishwasher to wash the dishes. the faucet and all other water areas continue to work w/o problems (i.e. bathroom, shower etc). in attempting to use the dishwasher, the entire cycle seems to be working, i initially hear what sounds like an initial water discharge when the cycle first starts and during the entire cycle it sounds like it


... Bosch Dishwashers

Hi, My dishwasher keeps stopping mid cycle and the door pops open. The soapy water is always gathered in the bottom and there's no way for me to get rid of the water, unless i restart the full cycle. The dishes are all getting stained with white marks, even though the salt and rinse aid is filled. Please help!


Sounds like the latch is worn out you mabe able to get a new one at appliancezone.com.... also check the drain for debris ... Baumatic 23 in. BDW9 Built-in Dishwasher

DD603 stops at 60min on Full cycle water all over floor and beeping


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

The dishwasher cycle starts and gets 20-30 minutes in and then stops giving me the - - - like the door was opened, but it was not. If I use extra heated wash, the cycle stops at 63 minutes left. If I use the regular wash cycle, it stops at 43 minutes left. I have to click the resume button to get the dishwasher to complete the wash cycle. This has been happening evey time I use the dishwasher the last 2 weeks. It is Whirlpool dishwasher model GU2700XTSS! and is only 3.5 years old.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I suspect based on your description...\015\012\015\012"stops giving me the - - - like the door was opened, but it was not, I have to click the res ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1172 seconds