Having problems with your Dishwashers ?

Kenmore Ultra Wash 665.1327 - Start light keeps blinking and beeping

\015 The start light keeps blinking and beeping at me when I try to run any of the cycles and will not start. I have tried pulling the racks out and rearranging the dishes and glass, I have pulled the filter out and cleaned it, and I have made sure the door closes and latches properly. I haven't tried unplugging it yet. We have had this dishwasher for about two years now.\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kenmore Ultra Wash 665.1327 - Start light keeps blinking and beeping


... Dishwashers

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I suspect for either of these units that the timer control boards are bad. ... Dishwashers

My Kenmore ULTRA WASH dishwasher model #1603* does not respond to any command. When I select a desired washing I only get a blinking light on my selection and nothing else. If I select ''Cancel/Drain'' it blinks as well. I receive no response at all if I select ''Start/Resume''. To stop the blinking I must turn off the circuit breaker. When I restore the power, the control board is not lit, however, selecting any of the wash cycles and the blinking starts once again. The manual refers to a blink


Replace timer/program module\015\012Vitally ... Kenmore Dishwashers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


... Dishwashers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I just read this for the same problem: push sanitize, then heat and dry, sanitize, heat and dry, sanitize, heat and dry, cancel, then open and close the door. It worked. The dishwasher is running correctly even as I type this.  ... Kenmore 24 in. 17262 Built-in Dishwasher

On my Kenmore Ultra Wash Dishwasher model 665 the Normal Wash light is blinking even though the previous cycle finished successfully. Also I can't start the dishwasher -- it doesn't respond to any of the buttons. I have powered it off and on and the Normal Wash light comes back on within 5 seconds of restoring power.


Http://appliancejunk.com/forums/index.php?topic=2933.0\015\012\015\012\015\012\015\012Hi. please find above your service and repair manual, bel ... Dishwashers

My Kenmore Ultra Wash 665.1602 665.1702. 665.1603. 665.1703 starts and stops. The Normal Wash light blinks continuously. What can I do to fix the dishwasher so it starts and goes through an entire cycle?


... Kenmore 24 in. 16039 Built-in Dishwasher

Kenmore ultra wash quiet guard dishwasher, the pots and pans and the normal wash button are blinking. The start and cancel and smart wash out tons have a faint light glowing. Thoughts? I tried the sequence of pressing heated dry, normal wash, heated dry, normal wash and that did nothing. I've flipped the breaker too. I was in process of taking it apart to clean filter, thinking that would help, but lost my manual and now I can't get that off to flea either:(. Sig


... Kenmore 24 in. 15689 Built-in Dishwasher

Kenmore ultra wash 665 dishwaser wont start. blinking light


... Kenmore Dishwashers

Kenmore dishwasher model 15692 start light keeps blinking and wont start cycle


... Kenmore Dishwashers

My kenmore elite ultrawash dishwasher, model # 665.16289402, will not start. The green clean light keeps blinking and when you go to push start after selecting which wash program it does nothing.


Youll need to enter a diagnistic mode, press in this order, hi-temp(sani-rinse)----heated dry--hitemp---heated dry... all lights should light, close door and let cycle for about a min, htne press the cancelbutton, you should be good to go, the but ... Kenmore 24 in. 15689 Built-in Dishwasher

I have a kenmore 665 17053400 elite dishwasher that the green clean light keeps blinking and nothing will work on it now. How can I clear the green light and start a wash cycle?


... Kenmore Dishwashers

I have a kenmore dishwasher model 665, an the quick wash light keeps blinking. and the appliance will not work. i have tried pushing the cancel botton , the start botton. all it does is the quck botton stills blink, and no responces. can you tell me what is wrong. thank you E. P.


Check your manual for the error message. May be certain additives are empty. In some machines salt, rinser etc ... Dishwashers

I have a Kenmore Ultra Wash 15632/34/37/39. The Pots & Pans button is blinking constantly and I cannot Start the dishwasher. I tried pushing Hi-Temp, then Air Dry, then again. The sequence didn't work for me. If I press the sequence, then the Pots & Pans light blinks along with the Quick Rinse and Cancel buttons. Which combination do I use to get the dishwasher working again, please? Thank you.


Try to Press and hold AIR DRY for 4 seconds, to reset the dishwasher ... Kenmore 24 in. 15689 Built-in Dishwasher

I have a Kenmore Ultra Wash Quiet Guard 3, the green clean light keeps blinking and it won't wash.


... Kenmore 24 in. 15932 Built-in Dishwasher

I pressed the POWER button to turn on the dishwasher. I pressed the SELECT button, hit HEATED DRY button and the LIGHT WASH buttons. I then hit the START/PAUSE button to start the cycle. All lights came on as normal & I heard the machine trying to **** up water like it normally does. Within 5 minutes or so, the machine started to BEEP & BEEP every minute. When I came to the check why the beeping noise was on, I saw that all the WASH PROGRAM lights were all blinking. I hit the START/PAUSE


... Haier ESD210 / ESD211 Built-in Dishwasher

Pots/pan light blinks alternately with the normal wash button. Sometimes the cycle will start and then the lights come on. Once they start blinking, the cycle stops and I can't get it to start again. Unplugging it for a few days has worked a few times. But it just keeps getting more frequent. If it does start up, it heats fine and washes perfectly.


... Whirlpool DU1055XTSQ Built-in Dishwasher

My Kenmore Dishwasher 665.16359301 quit working. I flipped off the breaker then back on again. The cancel light comes on and it sounds like its going to drain but theres no water in it. After about 20 seconds it stops and the normal wash cycle light starts blinking. Thats it. I did the reset procedure and it started to work then went back to the normal wash light blinking.


... Kenmore Dishwashers

I have a Kenmore Quiet Guard Ultra Wash and the lights on control panel are blinking green. It's the Smart Wash, Normal Wash and Light Wash lights that are blinking green. Dishwasher won't sta


... Dishwashers

Clean light keeps blinking and I can't start a new cycle


That is a comon problem with that model. It is not sensing a temperature change in the water. Push i believe it is heated dry and sani rinse going back and fourth between the two to clear the code and see if you can get it to complete a c ... Kenmore 24 in. 15932 Built-in Dishwasher

Kenmore Ultra Wash, Smart Wash light blinking red.


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

My kenmore elite ultra wash dishwasher flashing start button 1 hr light on. And control lock flashes but does not run just beeps


... Kenmore 24 in. 16059 Built-in Dishwasher

I have a kenmore ultra wash model # 66515777990 the lock on light is blinking and will not stop. This is keeping the washer from working what can i do to reset this?


... Kenmore 1348 Builtin Dishwasher

My kenmore ultra wash model 665.1777 no heat dry light is blinking and wouldn't start what do i have to do?


... Kenmore 24 in. 15932 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1786 seconds