Having problems with your Dishwashers ?

My dishwasher turns on but wont start. I turn it on press start and it double "ping" noise but there is no Error No.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher turns on but wont start. I turn it on press start and it double "ping" noise but there is no Error No.


... Dishwashers

I have a DWI 612C Smeg dishwasher I have an error code of the 2 right hand LED's flashing Have tried to reset the programmer (turn off, on then press program 4 times in 2 secs, wait 15 secs and turn off) This enables me to select a programme, but when the programme starts, after five mins it beeps and carries on making the draining pump noise and the programme never starts When I turn it off and back on I get the far 2 red lights flashing again Have looked for signs of blockages and can


... Smeg 24 in. DWI612 Built-in Dishwasher

Model#lds5811bb--started making noise coming from the water inlet area(bottom left). 3/4's of the way through the cycle, noise became louder and then an error code "le" came on. We tried turning breaker off, then we tried in the rinse only cycle, but 5 minutes into it the "le" code error came on again. I'm fairly handy, so I'm not sure what part I can replace to maybe solve the problem. I can't afford to spend a couple of hundred dollars for a repair man to fix it. I'll appreciate any suggestion


The LE code is a locked motor code. Something may have gotten into the pump impeller. I would take the screens and filters off and clean the and check the pump for something stuck in it. It could also be the motor going bad but I would check the obvi ... LG Dishwashers

I purchased a second hand Electrolux Dishlex DX403 with a kitchen. The dishwasher turns on when I turn the powerpoint on and makes a noise as if it is about to start. I attempt to press the buttons to set a mode and start it and it wont work, the buttons dont do anything. How can I fix this?


... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

Hi, my beko DE 2542 FS dishwasher wont start a wash cycle when i turn it on it makes a noise briefly, then nothing. iv taken the hose off and the water drains out so its not blocked. any ideas??


... Dishwashers

Hi :) Hope you can help. I have a double drawer fisher & paykel dishwasher. In the middle of the night a couple of weeks ago it started up making very loud whirring noises. We could not turn the power off, my flatmate who is an electrician had to remove the fuse to get it to turn off. We have never had problems with it previously. Is this common? Pls help. Thank you. Donna.


Sound slike it has detected a waterleak, this particular machine has a sensor o nthe bottom of caibnet , that when water is detected, it automatically powers up and turns on the pumps , it will stay on unitl the water dries up and/or you shut off the ... Dishwashers

Our dishwasher beeps twice when the start button is pressed but then doesn't do anything and there is no other noise from anywhere (eg, motor/pump). There are no error codes displayed and the display appears normal (ie lights up and shows time for program completion etc). When the problem first occurred the machine was full of dirty water. We have turned the dishwasher off and on at the wall, checked/cleaned all filters, drained the dirty water and still nothing happens (it doesn't even fill


... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

My lg dishwasher LD-14AW2 is not starting. It turns on and displays the time but when I click on anything it double bings and nothing happens. I have cleaned out the filters and my husband has removed the drain hose from the s band and it was all clean. the display looks normal...no error code. Do you have any idea what the problem could be?


Tunr power off 20 min then back on see if this helps ... Dishwashers

Bosch SMS4012 - E-NRSmS4012AU/11 FD7309041276not sure of its age but this dishwasher wont commence its cycle when I turn the left dial (but If I hold the handle latch up, it starts) there is no error code facility on this unit. Would it be worthwhile getting a technician to fix it or should i just buy a new one !! Thank you - Rena.


... Bosch Dishwashers

Fisher Paykel Double Drawer DD601v2. Half way thru a cycle the alarm went on both drawers even though the top one was not inuse or switched on. The error on both drawers is F1. If we push the power button on both after a few seconds they both start up making a whirring noise and both drawers flashing. We have to unplug the machine to stop the irritation. What is wrong and how can we mere mortals fix it ?


Hi,The F1 error means that the sensor that is located in the pan at the bottom of the machine has sensed water.It does not want either machine to run with a leak so it will shut down the operation of both drawers. ... Fisher and Paykel Dishwashers

I have a Delonghi dishwasher, it's a stand alone, like a washing machine. The water inlet is connected to the hot water tap, normally used for a washing machine. When we first started using the dishwasher, we kept getting the E4 error message, we reduced the water inlet pressure by turning down the tap, that worked for a while. Just a while ago, we started getting the E4 error message again, not sure we can turn down the tap any further without cutting the water off completely. Do you have a


The E4 error message could be because the water pressure is too low rather than too high. Can you let me know the exact model number of your dishwasher and I should be able to tell you more.\015\012\015\012Regards,\015\012BElectric ... Dishwashers

My Delonghi Dishwasher keeps turning off. The dishwasher is turned on at the power point. The water is turned on. Okay When I press the POWER botton on the front it wont stay on. I have to keep my finger on the POWER button and then press the START button for washer to work. If I do this it will then pump out any water in the bottom and start to work. ***BUT when you take your finger of the POWER button the washer just turns off and stops working. Do you have any idea what could be the problem p


Yes, the power button is faulty. by pressing the power button forcefully, you are in effect allowing the contacts to close. Replace it. ... Dishwashers

Loud noise The dishwasher was in the middle of the wash cycle when it started making a loud noise. I turned it off and then restarted it. It began washing fine but in a few minutes it made the noise again. Now it won't do anything. I can't get the water to drain out. It won't even start.


Very loud squeaking sound, at the start of each cycle. ... Kenmore 16639 Built-in Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

IDL700 wont start Kept getting error message to say there was a blockage. Checked all the pipes and pump, all fine. Now the blockage lights are out, but the machine wont start at all, just beeps when I press the start button, then nothing


Sorry to read about your problem, I hope this helps you out.the blockage, maybe inside the pump of the unit, or at the check valve.I suggest you contact a service company..I tried to help you. Please help me and Ra ... Indesit 24 in. IDL700 Built-In Dishwasher

ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


... Asko D3122XLSS Stainless Steel Dishwasher

Bosch Shu43C02UC dishwasher fills with water but the washing won't start. As the filling nears complete, a double clicking noise occurs to start the washing motor but nothing happens. The time continues to countdown but the machine is silent. When I open and close the door, the click click noise is heard but the machine is silent. I can cancel the cycle and drain the water but none of the washing or rinse cycles will activate but the timer works. The soap door even opens if the timer is left to


Have you checked the inlet water temperature is at the correct level for the dishwasher.\015\012\015\012Please provide the full model no. of your dishwasher -- Shu43C02UC /??\015\012\015\012I think the problem is linked to th ... Bosch 24 in. SHU43 Built-in Dishwasher

Hi there I have a LD-1204 Dishwasher and most of the time it works fine but every now and then it wont turn on or it will turn on but when I got to press start to start a wash it doesnt do anything. Can you help me please


... LG Dishwashers

Hi . I have a Zanussi DE6965 which has started displaying the error message AL6 every now and then. When it stops and shows this the water has not pumped out. If you turn it off, leave for half an hour or so and turn back on it sometimes works fine to the end. Sometimes it stops again. Eventually after several stop starts it works through. Any advice what could be causing this? Thanks.


... Zanussi 24 in. DE6965 Built-in Dishwasher

Telmann dishwasher We have just moved into a new house with a Telmann TEL12DWMS dishwasher. The dishwasher will light up but wont start. Power and Rinse cycle lights light up but when you turn the dial it wont start. Any suggestions? Thank you


... Dishwashers

Heller HDW12 at first it wouldnt do a complete cycle, now it wont do any cycle. I can turn it on, it has power it just wont wash, it makes a noise but its not washing. The tap is turned on. Could you please help me as I live in Kalgoorlie and it takes weeks to get a plumber, and he's not cheap...probably cost me my first born!!!! regards B Hughes


... Dishwashers

Hi. Our DS603I dishwasher starts on the Rinse cycle on its own - it beeps, red light flashing and no water entering the tub. It does this even if it is open. Similarly, when we try to turn it on to do a normal or heavy cycle, it starts (making quiet a loud noise) and then goes to the Rinse cycle, beeping, red light flashing, no water going into the tub. The pump wheel is turning. We can't find any blockages in the tubes. We have power-cycled it many times. Please help!


Dishwasher Repair Guide: How To Fix a Dishwasher - ACME HOW TO.com\015\012\015\012\015\012\015\012 ... Fisher DS603W / DS603B / DS603I Dishwasher

We have a Maytag built-in dishwasher Quiet Series model MDB8551AWB. When we press the Start, the lights light up, but after a few minutes all lights turn off. We've unplugged and plugged it back in. I've tried to repeat the 'start up' multiple times and sometimes it sounds like the motor is going to begin but then it pauses and stops. All lights turn off. No odd noises or grinds.


... Maytag MDB8851AWS 24 in. Built-in Dishwasher

Hi there, Just moved in to a new place and loaded up this dishwasher. First set it to "normal wash", dry "off", "start". Made noises but after a couple of minutes I heard no water and think I smelled the beginning of something overheating. Think I checked to see if the water was turned on under the sink (turned all the way to the right?). Still nothing but noise. What do you think? Lorraine


Lorraine.. It sounds like the water valve under the washer is stuck or maybe partially shorted. It is a solenoid coil activated shut off valve. The coil may be overheating, and valve not opening.. so motor is running dry. \012If you want to ta ... GE Nautilus 24" Built-in Dishwasher

My dishwasher, a Whirlpool ADP 931, has stopped working. Possibly because the door was opened during operation, right after it was started. There is some kind of error condition indicated through a blinking Start light, but I don't know how to analyze this. This is a quite simple model with very few buttons to press. When I turn the program knob right to start it, the only thing that happens is that the green Start lights begins to blink continuously. There is also another green light


Hello & Welcome to FixYaThis light is reset by pressing two buttons in sequence 3-4 times, to reset your dishwasher press these buttons in sequence:High tem ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1485 seconds