Having problems with your Dishwashers ?

Miele dishwasher - remove upper tray

\015 The upper basket has sand in its tracks so I need advice on removing the basket so they can be cleaned.\015\012Thanks\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Miele dishwasher - remove upper tray


... Dishwashers

Miele dishwasher remove upper basket


... Miele Dishwashers

My Kenmore Elite model # 630.16302402 dishwasher isn't getting the dishes clean. A lot of food is still on the dishes after cleaning, especially inside the glasses. There is a white film on glasses and the inside of the appliance. I also just noticed that the upper arm isn't turning. There is about 1/2 cup of water standing in the drain area (not visible until removing the filter tray at the bottom of the appliance). Is this normal? The obvious problem is the upper arm but it seems like the rin


Hello, \015\012 \015\012 ... Dishwashers

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

Upper spray arm is not turning and I don't think water is coming out. Dishes on top are not coming clean. Dishes on bottom are clean (as clean as they get with this dishwasher). How do I remove upper spray arm. Also I'm not sure how to remove lower dish rack to access upper spray arm. Any help appreicated. Kitchenaid model KUDP01FLSS5 Chris


Hi Chris,It sounds to me like a restriction in the pump. I put together some information here on cleaning it out. If you try these please give me some feedback as to if they help or not.Thanks! ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Miele dishwasher G2870 scm. There is an F14 fault. I have cleaned the arms removed the waste basket from the bottom of the dishwasher and removed the two parts one with the large metal ball to expose the plastic wheel clog. There does not appear to be a blockage. I also removed the top arm and cleaned that out. I don't know what other inlets to check as the guide does not tell me exactly what an F14 fault is but explains F11,12,13. Can you help?


F14 on your model of dishwasher is indicating a blockage, poor water\015\012pressure or could be a fault with the pump pressure level switch or\015\012circulation pump.Filter and non return valve is cleaned of any blockages and if the fau ... Dishwashers

Hello there, I have a Bosch Logixx dishwasher which I purchased just over 2 years ago. My upper dishwasher tray is not fitting properly into the hose pipe holes on the inside of the back wall of the dishwasher. It has a movable plastic mechanism sort of fitting which is dropping off everytime I open the tray to keep the utensils and unable to close it fully until I re-adjust the plastic to fit into the holes proeperly and then it works. I am not sure how to fix the problem, do I need an En


Hello Deepak,\015\012\015\012You can definitely fix this yourself, but I'm not entirely sure from your description which part is "dropping off". It may be a simple fix where something needs to be clipped back into place or you may need to ... Bosch 24 in. SGS69L02 Logixx Built-in Dishwasher

Cannot remove Filter basket from Miele Dishwasher


... Dishwashers

Water inlet I have a miele dishwasher and water keeps collecting in the bottom tray which in turn makes the water inlet light come on and stops the dishwasher from working. i have drained the water out of the bottom tray which makes everything work again but how can i stop this from happening as it seems to happen on a weekly basis. thanks


It sounds like there is either a kink in your drain hose or your garbage disposal is blocked up where the dishwasher drain is connected ... Dishwashers

Hi I've inherited a Zanussi DA6142 Dishwasher from a recent house move. It was treated quite poorly by students who I suspect ran it without the filters in place. I've used a dishwasher cleaner and was able to pull out the lower spray arm and rinse out all the crud that was blocking it (small stones, food, plastic, pieces of glass, paper, etc) but I cannot for the life of me work out how to get the upper spray arm out. The PDF manual I've downloaded for this model says DO NOT remove upper spra


... Zanussi Dishwashers

Indesit D61 dishwasher... Upper spray arm catches/sticks on back of machine. Can I only use upper tray on lower setting hence unable to wash dinner plates in bottom tray due to height restriction.


... Indesit 24 in. D61 Free-standing Dishwasher

The dishes in my dishwasher are not getting clean, particularly on the upper rack. It seems to be because the upper water arms are not spinning during the wash cycle. The bottom spin arm is working fine. I have cleaned out both upper arms as best as I could without removing them (above and attached below to the upper rack), as it does not appear that these arms are easily detachable. I am thinking maybe water is not making it up the line to the upper arms? I also have a lot of dirt in the b


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... GE Dishwashers

Jdb2100aws dishwasher - door handle fasteners loose, handle ready to drop off. This is a dissambly question: The middle section of the door has an upper one-third (which contains the input switch strip) and a lower two-thirds; the upper section must be removed to tighten the door handle fasteners. After wiring is disconnected (yes, power is OFF), the upper section appears to be held to the shell by some kind of barbed fastened from the inside, run through a tab on the door shell and into a fema


After removing the stainless cover l tried to disassemble the door further but found it difficult, there is a hard thick plastic cover, i took my dremel and cut a small hole large enough for a wrench to fit and tighten the thin nut on the handle, lin ... Jenn-Air 24 in. JDB2100AWS Built-in Dishwasher

I have a KUDS03CTWHO KitchenAid dishwasher. It started not cleaning the upper tray well a few weeks ago and now the lower one is not getting cleaned very well either. I have disassembled and cleaned the 3rd level , upper and lower spray/wash arm assemblies as well as the feed tube assemble. These were not blocked or glogged. There appears to be less spray coming out of the upper and 3rd level spray arms they before but as I said there is no blockage. I also cleaned the bottom filter. There has b


\015\012Hi\015\012\015\012The issue seems to be with the float switch\015\012assembly that is bad and should be replaced. Please check this ... KitchenAid Dishwashers

Hi: I have reviewed the forums and tried to fix this issue. Have a Miele G2120 dishwasher that at the end of the cycle - the three (rinsing, drying and end) orange lights begin blinking in harmony. I have removed the triple filter, and two plastic parts to the impeller and made sure all was free of obstruction. I then pulled it out removed the drain hose from in-sinkerator; removed the water line and checked for obstruction. When it gets into this condition - the majority of water drain


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Miele Inspira Series Dishwasher w/ 6 Programs and 5 Temperatures - G2120 / G2120BL - Blac 24 in. Built-in Dishwasher

Need miele dishwasher upper spray arm for g868 dishwasher. plastic circle broke


... Miele 24 in. G865 Built-in Dishwasher

How do you remove the upper dishwasher rack? It's


The upper rack is held by four side brackets. They are not removable unless you pull the dishwasher out from under the cabinet. Not very homeowner friendly. ... KitchenAid KUDM01TJBS Dishwasher

How is element removed from Miele Dishwasher


Procedure to change :)\015\012\015\012\015\012http://www.acmehowto.com/howto/appliance/dishwasher/repair/heatin ... Dishwashers

Dishwasher: upper tray rolls out everytime the door opens


Put 2 small pieces of cardboard under the front legs until you get it where it wont roll out anymore. i had the came problem with my kenmore and it took care of it ... Viking DFUD142 Built-in Dishwasher

How is element removed from Miele Dishwasher


Procedure to remove element :)\015\012\015\012\015\012\015\012http://www.acmehowto.com/howto/appliance/dis ... Miele G892SC SS Dishwasher

Dishlex global 300 dishwasher upper arm removal


... Dishwashers

Remove / clean upper spray arm on Maytag dishwasher


... Maytag MDB7100AWB Dishwasher

I have a whirlpool GU2700XTSQ1 dishwasher. I have the typical top rack not cleaning problem. I have removed the rear washer tube that leads to the top sprayer, no clogs. Upper arm is clear, lower arm is clear. I also removed the lower cover, checked the chopper screen and inlet, no clogs. There is a screen inside that I cannot get to. It appears to have some sort of paper or cloth sticking through the screen with a 50% block. Perhaps a sticker or label from a dish. I see this screen when looking


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

Sometimes the dishwasher drains, sometimes it doesn't; I emptied the dishwasher, removed the bottom tray and baskets; ran a cycle - it drained so, I presumed it was now operating as it should - it wasn't - the tub was full of water so, I ran a rinse (5 minutes) cycle - it drained next time I ran a cycle - it didn't drain


Hi,Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - Water will not drain out ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1938 seconds