Having problems with your Dishwashers ?

Miele g595 Everytime I place the tablet to wash it is not disolving at all. Water not being dispensed?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Miele g595 Everytime I place the tablet to wash it is not disolving at all. Water not being dispensed?


... Dishwashers

Hi I have a westinghouse 904. It stopped working. I found that it wasn't heating the water. The elemet looked fine so we replaced the thermostat The one that has the safety switch and now it goes to wash then it works for 5 seconds then stops. I have tried to use all settings including eco but stops at the same place everytime. It then flashes on normal.


Elements often have no visible sign when they go bad ....they need to be checked with an ohm meter ....check and replace if circuit is open ... Westinghouse 24 in. MDP531 RF Free-standing Dishwasher

Hi, Just moved into a place with a DU4500B Magic Chef. After a cycle there is still a clump of wet soap in the main wash cup dispenser and the dishes aren't clean. Yesterday I tried putting the soap in the pre wash and and main wash dispensers but leaving the main wash soap dispenser OPEN rather than clicking it shut, and there was still left over soap in the dispenser and granulated soap residue on the dishes and they weren't clean. Many thanks for your help.


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Magic Chef 24 in. DU4500 Built-in Dishwasher

Kenmore dishwasher My Kenmore dishwasher model 630.16302401 is not successfully completing wash cycle. When I hit "normal" and turn it on, water enters the d/w, and the sprayers (both top and bottom), spray water. Approx. 10 mins. later, the water is drained. At that point, it appears that water never again enters the d/w to complete the wash cycle. In fact, the soap in the dispenser does get released, and the door opens. However, the soap will just run down the inside of the door and pool on th


... Maytag Dishwashers

My Kitchenaid ModelKUDI01TJBL0 only leaks at initial start up. Just after the water fills, the first few seconds of the wash cycle. It pours out the front door for a couple seconds than no more for the rest of the wash. It is level, no cracked arms, or loose pumps.Splash guard is in place. The float seems to be working, not too much water in the bottom. I am stumped. Although I do feel that it has something to do with the level of the water being too high, when the arm starts turning, it makes a


Is the unit level or leaning back if leaning back it is morelikey filling too much if level make sure the float moves up/down easy if not clean ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My siemens dishwasher has the water tap indicator light on when washing starts. i have cleaned the water filter and the spray arm but the light doesnt go off and the washing doesnt take place. Instead i can just see water coming into the drain in intervals. what do i do?


... Siemens Dishwashers

Bosch Integra SHU 9955US/12 - when we start wash cycle, the detergent dispenses and the tub fills with water, but the wash cycle never starts (never spins spray bars). Seems like timer is counting down, though, but doesn't start "washing". After waiting awhile, we are able to use the "Cancel/Drain" mode to drain the water. The drain filter in the bottom of the tub is clean.


Sounds like your motor is burned out. The drain motor and wash motor are seperate on your machine. You can check for power going to the motor, but to do this you might have to pull the dishwasher out. While the cycle is running check for 120 VAC g ... Bosch SHU9955UC Built-in Dishwasher

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Dishwasher malfunction MOST OF THE TIME it shuts itself down before fully filling with water - SOMETIMES it doesn't shut down until the minute the wash pump starts - SOMETIMES it washes for 10 or 20 minutes before shutting down - SOMETIMES it will even run a whole cycle, BUT it doesn't open the soap dispenser door - tried doing a diagnostic run but after it turned on all the lights on the panel it started to fill with water and shut itself down......... HELP


Follow this steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

After running a cycle, there is some water in the tub and the soap dispenser is open but the soap has only run down the inside of the door. It does not sound like there is a vigorous spray during the wash cycle. Opening the door during the wash cycle reveals only a little water reaching the upper arm.


May have a stripped wash impeller. I would tear into the pump and look for any kind of obstruction but if its clean probably the motor assembly needs replacing. ... Frigidaire Dishwashers

Hotpoint FWD70 - dispenser flap not opening. My Hotpoint FWD70P detergent dispenser flap does not open during the wash cycle and the wash tablet does not disolve.


This has hapened to me twice. I am no expert so treat the following with caution. This is what has worked for me.\015\012\015\0121/ I sugest you check the dispenser solenoid - it should be about 1.65K. If it is open circuit buy a new disp ... Hotpoint Dishwashers

I have just bought a cid60b10 dishwasher and it won't work! I completed the first wash putting water in the salt dispenser as instructed and when it had finished the wash there was still water in the bottom of the washer. Now when I turn the machine on all the buttons light up and then go off and I cannot select a function. Does anyone know how I can fix it without having to send for a technician?


... Dishwashers

Westinghouse 904 water starts overflowing after prewash and at wash it does not stop the water i had to turn tap off. Also it does not open detergent dispenser when Wash led is lit, it was working fine yesterday outside but since i moved it under the bench its gone nuts!


Hi there,\012Well first of all you can check the float switch, A float for use in a dishwasher to control an externally mounted overflow switch in response to a potential overflow condition existing within the dishwasher tub. The float is ... Westinghouse 24 in. MDB421 RF Built-in Dishwasher

I have a new Whirlpool dishwasher. It has been working fine until a couple of weeks ago when all of a sudden I've been having a problem with the soap dish not opening and dispensing the packet of detergent. What should I do to solve this problem? I have run the cycle through three times and it still won't disolve the packet. The dispenser opens, but the packet is only partially disolved, leaving the dishes not washed. eileen mueller, glendora, ca


I suggest using detergent and jet dry....w/p doesnt sugg packets due to this issue ... Dishwashers

Tricity Bendix DH090 water valve closes too early. Insufficient water causes program to stop before first heating cycle. If I switch off, open the machine & pour an extra pint of water in, shut the door & switch on again the wash takes place and completes perfectly to specification. OK so the problem seems to be that level detector No 1 switches off the water inlet valve early and level detector No 2 (apparently) halts the cycle since it detects insufficient water in the machine. I cannot see t


... Tricity Bendix 18 in. DH090 Free-standing Dishwasher

Turns on, the entire cycle runs, but no water pumps through the sprayer. There is water present on the bottom....and I can here the water pumping in at the beginning of the cyle....but the dishes are not being 'washed' by the sprayers. I have disassembled and cleaned the entire inside and sprayers to no avail. Im thinking its a pump/motor issue but Im not sure because the sprayers spin, the heat comes on, the detergent dispenses....but no water is being sprayed. Thanks.


Yes i agree, your pump is not working as it should. J.\015\012\015\012That said if this machine is over 3 years old, replace it. The new ones are so much quieter, better, and cheaper to operate. J. ... Maytag MDBH955AWS Stainless Steel 24 in. Built-in Dishwasher

I have a Miele G868 dishwasher. It is 15 yrs old. 8 months ago the soap dispenser wouldn't close, so I got another dispenser from Miele and replaced it myself. Everything worked fine until 3 months later, when the soap dispenser did not open. After 3 restarts, it began to function as it should. Now 5 months later, the soap dispenser is not opening at all. Here are my observations: 1. Economy wash cycle should run 35 minutes but only runs 13 now. 2. Water in machine is not hot, even though I run


... Miele Dishwashers

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.


Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

I have a problem with my Asko D3350 Dishwasher, can you help? On startup the diswasher does its normal cycle and pumps excess water out and then fills the dishwasher with water to the correct level of water, after this the machine has no dishwashing action at all for the duration of the program setting. The dishwaher then pumps all excess water out and switches off as normal but no washing action has taken place, there are no error codes during the entire operation. Is there any way to rese


Hi Tony,\015\012\015\012I have the same machine (D3350) and almost the same problem.\015\012\015\012Mine starts each cycle fine - pumps out - fills - rinses - pumps out tht first load and then does not fill again. If I manuall ... Asko Dishwashers

I accidentally placed Jet-Dry...DISHWASHER CLEANER...in my brand new Whirlpool dispenser. I took off the cap and ran two cycles of water through the dishwasher. The dispenser is 3/4 full of the CLEANER fluid. How do I extract the fluid from the dispenser....:-O


Let me understand you correctly. Jet dry in your soap dispenser or soap in your rinse solution dispenser. The only dispenser that holds solution is your Jet dry drying solution. But if you put soap in the drying dispenser then the only way to extr ... Whirlpool Dishwashers

The water level in my Whirlpool Gold dishwasher does not seem to be high enough to clean the dishes. Also, the detergent dispenser opens but the detergent does not wash out of it. How do I increase the water level? Also, could it be something else besides the water level?


Screw fell into wash moduel. how do i remove the lower arm ect. Thank's ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Indesit idl 535, washing on usual cycle but not heating and dishes not being cleand properly? Disolves tablet and goes through full wash cycle as usual but doesnt wash dishes properly and the dryer isn't working as it normally is hot when you open the door, but it is just cold. water draining as normal too.


Your problem is very clear, you need to replace the wash tank heating element. ... Indesit 24 in. IDL500 Built-In Dishwasher

Dishwasher Our dishwasher is not washing the dishes. The water go in and it goes through the complete cycle and dumps the powder in but the water never gets above the dishes or even to the soap holder. The powder is a dry pile below the dispenser. It seems that the spray arm doesn't extend or spray water over the dishes.


I have a kenmore dishwasher (about 10 year old) it won't turn on. It just buzzed when set to wash. What can I do? ... Dishwashers

Main wash detergent dispenser appears clogged, detergent and water remain in dispenser after cycle is complete.


Could be a dispenser problem, not just cloggingCould be wrong type of detergent ... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

I HAVE A BUILTIN KITCHENAID SUERA DISHWASHER WHICH IS ABOUT 14 YEARS OLD IT SEEMS TO WORK PRETTY WELL. BUT THE SOAP DISPNSER DORRS TICK CLOSED SO THE DISHWASHER FINISHED AND THE DOORS REMAND CLOSE SO THE ONLY WASHING IS DONE WITH WATER AND NO SOAP. THE SOAR DOOR HAS TWO SLIDING DOOR THAT ARE ARC SHAPPED AND SEEME TO BE CONECTED WITH BUTTONS ATH THE CENTER. THE SOAP DISPENSER ID AHITE INJECTION MOLDED PLASTIC ANDY IDEA I CAN TRY TO GET THEM TO OPEN DURING WASHING CYCLE THANKS **** VON ROTH


Water does not come into the washer ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1667 seconds