Having problems with your Dishwashers ?

Ge potscrubber 1420 dishwasher

\015 How to fix \015\012waterfrom wash cycle does not discharge and fills up sump\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

I have a Bosch SHU43C05UC diswasher. Last night, I put it on before going to bed as usual. I was awakened a couple of hours later to a loud grinding sound (like a pump being run dry), and found the noise coming from the dishwasher. The display read "0" time remaining, so I opened the door and the dishes seemed clean, so I left it shut off. Tonight I have been trying to troubleshoot the problem. The dishwasher will turn on, but it will not seem to fill with water. I have verified that the


Ok well before you can do anything you must obtain a service manual, link below.\015\012\015\012http://allrepairmanuals.com/bosch ... Dishwashers

I have a Neff s4457n0gb/32 dishwasher that will not complete the cycle as it finishes on 0:01 minutes remaining on rinse and not moving to drying. I have to press the reset to clear the display to 0:00. If you've any idea how I can correct this problem that would be most helpful.


... Neff 24 in. S4457 Built-in Dishwasher

At 2 minutes left in the wash cycle, the quick rinse light starts blinking and the timer goes to 0. My dishwasher is a Whirlpool Quiet Partner IV gu1500xtkbo dishwasher. I'm assuming the blinking light is an error code. What does it mean?


... Whirlpool Dishwashers

This dishwasher caught fire it got to hot and burnt the plactie around the bottom by the element. This modle has been recalled what can I do? GSD2620J01SS AG736720B not sure if the 0 are zero's or the number 0


... GE Tritonr XL GSD6260JCC Dishwasher

My 6-year-old dishwasher is not getting my dishes clean. glassware feels gritty; flatware looks dirty. I've tried cleaning the interior, and running a potscrubber cycle with the dishwasher empty except for a coffee mug filled with vinegar. What is wrong, and can I fix it? Model number is KUDP01FLBL2.


... KitchenAid Dishwashers

Bosch SHU43 My Bosch SHU43C dishwasher stopped washing, turns out the impella came free from the motor, I repairded impella and put it back together and now the dishwasher washes great however now it is stuck in a wash rinse drain cycle. Display counts down but the unit never stops running when it reaches 0. Also, the water level is higher than normal and I there is a kind of thumping sound repeatedly every 15 seconds " use to make that sound only once at the start of a cycle before the impella


Sounds like the control module is out -- cost about $100 (I am on my third). I got a "lifetime" warranty when buying my second one. If you are handy, you can replace it yourself. You can call Bosch to confirm this (I did). It mounts inside the door. ... Bosch 24 in. SHU53 Built-in Dishwasher

I have a knmore elite dishwasher about 8 yearsold.Past two weeks the cycle starts at 0 but never advances past 46 min. the dishwasher does not seem extremely hot like usually. what can i do


Probably a bad element ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a GE potscrubber portable dishwasher and when i connect the hose to the facet and plug in to the outlet and turn the dial to start the dishwasher up all i hear is a low humming sound. I tried truning the knob around a few times and still the same low himming sound.


I have this same problem with the same dishwasher. Did you ever find what was wrong with it? ... GE Dishwashers

I have the GE 206c1513p001 Potscrubber and recently found a black seal or rubber band in the dishwasher. Since then, it has been making a continuous clicking noise when it is run and does not clean the dishes thoroughly. I am trying to find a manual or something that may tell me where this seal belongs so that I can fix this issue. The bottom of the dishwasher is also not draining completely. Please help! Thanks!


I have the exact same problem!!! Found 2 loose rubber bands, the bottom doesn't drain completely, and the dishes are left either dirty with a white film on them. Please help! ... GE Dishwashers

My GE Potscrubber 2230 is not heating the water in the dishwasher. The water at the sink is hot but when I ope the dishwasher, the water is closed. Sooo, it's not cleaning the dishes. Is there something I can do or do I need to call a repair man?


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not W ... Dishwashers

Our LG 6810 dishwasher has stopped cleaning. After the cycle the dishes are wet and covered in greasy clumps. We ran the test cycle and got the following: 3H/U3 11 22 33 44 55 66 04-2 32 33 0 (inlet valve) 35 36 37 38 23 (Thermistor) 3A 3A (beeped twice and showed 3A) 3A (beeped twice and showed 3A) Any advice you could give me would be appreciated. I have the service manual but have never done any type of dishwasher repair. I'd like to not have to replace this dis


1.) Take racks out of unit.2.) put both of the spray arms in the 12 o'clock position3.) Run the washer,once the washer has started wash cycle,open the door and ensure the spray arms have moved off of the 12 o'clock position. Write down re ... LG LDF6810 Built-in Dishwasher

C3 error on a 2230 ge potscrubber dishwasher. Reset it, turned it back on, then get C4 error. Continue to get errors and dishwasher won't drain


... Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

My dishwasher makes a banging noise whenever the water supply shuts off & it drains. It has been doing this for a long time. I finally bought a hammer arrester & soldered it on the line after the tee for tap & dishwasher & it sits about 1 foot up.this did not solve the problem. It still bangs loudly & I'm worried about damaging my pipes since they are old copper pipes. can you give me some advise it is a ge Potscrubber mod. #SSD539PS1181 Dave


... Dishwashers

How long should a normal wash cycle take for a kitchenaid dishwasher type 577 0


... KitchenAid Dishwashers

Need installation guide/manual for GE Potscrubber 700 dishwasher


... GE Dishwashers

Zanussi dishwasher when cycle finished displays .60 instead of 0?


... Dishwashers

Our dishwasher is a GE Potscrubber 2230. The


... GE Dishwashers

GE Potscrubber 1230. My dishwasher makes noise


... GE GLD4600NCS Built-in Dishwasher

My old GE potscrubber 700 dishwasher stopped working


Moter has probably locked up TAKE FRONT LOWER PANEL OFF AND YOU CAN ROTATE ROTOR/ if itis not free and rotates easly then the motor has failed / mm ... Dishwashers

I have a GE Potscrubber dishwasher that only hums, won't run


I have a portable that had the same problem. I called a repairman and he turned a fan blade on the motor. Mine is located on the right side about 12" in. It gets hung up when it is run often enough. If your problem is the same is mine all you have to ... GE 24 in. GSD2000Z Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1146 seconds