Having problems with your Dishwashers ?

I have here a carrier autoscaph 21 (using Isa 3161) . On the back reads 2427 water resistant 100m/330ft stainless steel 11734PL. I would love to hear an honest opinion . Is it a good or bad one? please advise


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have here a carrier autoscaph 21 (using Isa 3161) . On the back reads 2427 water resistant 100m/330ft stainless steel 11734PL. I would love to hear an honest opinion . Is it a good or bad one? please advise


... Dishwashers

Would the stainless steel make the inside of the dishwasher smell awful when half full of dirty dishes after only 2 days? I noticed under the screen on bottom of tub that not all the water completely drains. Would this be the cause of the bad smell?


Stainless steel will not smell or rust that why its used,the cause of the smell is twofold 1 dirty dishes should not be left unwashed in the machine to long a bectearia starts to grow within a couple of hours and starts the smell process,2the filter ... Bosch 24 in. SHU43 Built-in Dishwasher

Electronic control pad is pushed for quick wash and the LED display would show 52 minutes. Now when it pushed the display shows 17 minutes and performs all the functions that would occur at the end of a normal cycle. Can set for the longer wash cycle 94 minutes and performs all functions start to finish. Think the control board is bad any advise.


... Maytag 24 in. DWU9902 Built-in Dishwasher

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers

I have a Frigidaire FDBB2040FC3 Stainless Steel Dishwasher. A few days ago it would not finish a cycle. It would run for a while and then the high temp and air dry lights would blink. Today it won't start at all. Is there a reset button? I took of the kick panel and all the wires appear to be attached.


Http://frigidaireservicetips.com/pdfs/467_10.pdf\015\012\015\012\015\012\015\012\015\012 ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Often had to press 'Start' up to 5 times to get it going. All lights light up but then go out. Occasionally the pump would run for a minute or so then whole shooting match would close down. Recently we were lucky and it filled with water but sadly disappointed when it closed down again. 8 people in the house so had to do the dishes in the sink (again!!). Plenty of helpers and a glass or two of wine so things weren't that bad. Not good for Dishlex though especially when others say theirs are


Problem not solved yet.\015\012Cleaned the filters well, hoses clear and water delivery happens.\015\012Both pumps work happily so are not seized/locked up or have anything jambed in them (pulled them both out and checked for foreign obje ... Dishwashers

My dishlex dishwasher is a model 560 silent range with eco save and has a printed circuit type switch arrangement it has man code of b8833ww or 88833ww the problem is that the pause start button activates but dose not latch in I suspect that the problem is with a latching relay behind the switch panel as i have had the front off and cleaned the contcts with contact cleaner! all of the buttons work including pause ! any advise would help as would a wiring diagram and or a operation or wor


Latching relay or door lock assembly need for you to check on that model number 560 silent range wont come out on dishlex's site should be a dx followed by some numbers try also to shut off the main power for 7 minutes to the unit to reset the contro ... Dishwashers

We have an AM-14 dishwasher. It now will not work on auto. It would sometimes and then not and now only on manual. We have had a couple people in to look at it. One says the main board was bad, so it was replaced and the problem continues. The board that was removed was put into another washer and it worked ok. We were told then that that a wire from the motor was wrong and thats when we called in another person. That person said the board was bad and they couldn't work on it. We are in Lancaste


... Hobart AM14-253 Free-standing Dishwasher

My dishlex dishwasher is a model 560 silent range with eco save and has a printed circuit type switch arrangement it has man code of b8833ww or 88833ww the problem is that the pause start button activates but dose not latch in I suspect that the problem is with a latching relay behind the switch panel as i have had the front off and cleaned the contcts with contact cleaner! all of the buttons work including pause ! any advise would help as would a wiring diagram and or a operation or workshop ma


Hi.The switch on this machine's control module is electronic. I do not think you will find a relay. In normal conditions the button is not supposed to stay latched If the button is defective you may get the same problem when ... Dishwashers

I have an older Bosch dishwasher #SHU3326 and haven't been able to find stainless steel front that I know would fit. The unit now had an almond color and I've considered spray painting with the "stainless steel" look. Any ideas.......


... Bosch SHU9922UC Built-in Dishwasher

E3 Error Hi My dishwasher is showing error E3, which the user manual states "The appliance is not able to pump out the water.", however, other E3 error states a heating issue. The dishwasher does in fact heat the water but generates the E3 error after 10 minutes or so, then pumps out the water from the dishwasher. I'm a little confused as to what the issue is here and what part I would need to rectify the problem. Any advise you could give would be greatly appreciated. Kind regards


The E3 error is a result of water temperature not getting to a nominal value within a particular time. This could be caused by several factors like heater faulty, wash pump not working well, wash arms not circulating water as required. Need model nu ... Smeg Dishwashers

Good day - we are experiencing a problem with our AEG that it does not drain all the water when the cycle is finished. The filter is clean and there does not seem to be any blockages yet it still does not drain. Would be grateful if you would please advise.


... AEG 24 in. Favorit 40310 Free-standing Dishwasher

Hi silverdragon, re the dishlex 302 not heating or drying Have replaced heating element but unfortunately still cold. If the control panel has not shorted which it hadn't before, do you have any suggestions. My hubby would rather wait before buying a new dishwasher, but I don't want to throw good money after bad. Is there anyone you can suggest who would be able to check out the circuit board to see if i have missed anything.


Hi\015\012\015\012Check the two thermostats located at the inside bottom front\015\012panel of the dishwasher, if any one of them goes bad it won't heat. Hope this\015\012helps...please post back for further assistance.\015\012\015\ ... Dishwashers

Hi there, we have had our Bosch Loggixx Auto Option dishwasher for about 5 years now and we seem to have had endless issues with it. However, it now seems to have an error with the timer, which on any wash it seems to get to about 6 minutes and then jumps to 32 minutes and the contents are not being cleaned. Any advise that you would be able to provide would be greatly appreciated. Many thanks


There is way's to fix this problem, first check the amps that is going to the dishwasher, and them repplace the timer.\015\012\015\012can be a electrical problem that is keeps damaging the dishwasher. ... Bosch Dishwashers

Our Bosch SL15J1B had started to make a lot of noise like a load screech and loud banging, then we put it on a wash and it stopped after a few minutes with water in the bottom that would not drain and the detergant undissolved. I would be grateful of your advise.


... Dishwashers

Will not pump out all the water, I hear it click, but I don't hear the 'whirr' just a 'hmmmm'. is there a solenoid gone bad, or the pump motor?


Pumpkin seeds blocked the drain line, so $180 to the lucky plumber as he drove off in his Mercedes back to the country club! ... GE 24 in. GLD6300L Built-in Dishwasher

The inside of stainless steel dishwasher door is badly streaked


... Bosch Dishwashers

Wont dry Hello, I have the Asko D3112 dishwasher. It washes great, but does not dry completely. After a wash everything is still drenched as if i splashed in a bucked full of water. I know it drains properly (i hear it draining down the sink), and it attempts to dry (hot air). I also am using the rinse aid as specified in the manual. Any tips would help. thank you Andrew


Make sure you select a high temp wash and the heated dry as well Also, dont put too many plastic items in there at once, they dont dry very well in anything. Check the amount of soap you are using, it shouldent be more than 2 tablespoons (way less th ... Asko 24 in. D3112 Free-Standing Dishwasher

Low flow Please advise how to disassemble Delta shower head A112.18.1 I have the handle portion apart but can't find the key to removing the head portion. Your help would be appreciated. Gene


... Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

Email address HI there, thanks for replying. My email address is [email protected] and if you can find the manual it would be much appreciated. I think we figured out where the rinse aid pipe goes to, that and the other one seem to go straight into the detergent bottles and they have a weight on he end to help **** out the detergent/rinse aid. I look forward to hearing from you soon


Service Manual emailed ... Electrolux WT30H240DU Dishwasher

Hobart LX30 Thank you for your help earlier. I figured out a way to get the machine running on 220. Now my problem is finding the intake for the sanitizer and detergent. I have looked all over the machine and I cant find tubes anywhere. The guy I bought it off of tells me that when the water temp is over 170 you don't need any cleaning products. I just want a second opinion. I feel that our glassware is not as clean as we would like. Any thoughts?


I'm not sure I'm comfortable with the direction your seller is leading you. I assume this machine is installed in some type of place where you are serving food to the public. If this is the case, then the local health inspector will expect to see a w ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Sink What is the best way to get rust stains off of a stainless steel sink? Any product or in-home solutions would be helpful.


"Wink" is and excellent product and can be found at many stores. You can use it for toilets, clothes and many other items as well. ... Dishwashers

Have a siemens lady dishwasher and dishes are coming ut salty as I donot have manual I maybe am doing something wrong i would love some help


Hi,\015\012\015\012Please see the detailed video link bellow to understand the standard operating procedure and where are you going wrong.\015\012\015\012 ... Dishwashers

Put through entire cycle, standing water and dishes still wet, only 1 yr and 3 months old!WHY!!!!!!!!! It also has a musky or bad smell like food in the trash sometimes smells. 500 series 6 cycle stainless steel inside, black 24" in wall. Water is about an inch deep. Have tried it on pots and pans cycle, regular and auto, and have on sani-dry and have spot stuff in it. HELP!!!!!!!!!!


Take the drain hose into a bucket and see if it pumps out.\015\012if it does check for blockages where the hose goes to.\015\012\015\012most likely is a blocked pump, the pump is assesable from in side the sump, you may have to get ... Bosch Evolution 500 SHE45M06UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0862 seconds