Having problems with your Dishwashers ?

Kitchenaide model kudc10fxss3 heat dry won't shut off and actually melted plates. had to shut off the breaker and stop using. the unit is only 15 months old


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kitchenaide model kudc10fxss3 heat dry won't shut off and actually melted plates. had to shut off the breaker and stop using. the unit is only 15 months old


... Dishwashers

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Electrolux ESL63010 integrated dishwasher 10 months old- works for a few seconds, then stops and beeps continously. & the End indicator light flashes once. I turn it off, cancel programme, set it again, shut the door -it starts and goes on to complete the programme and washes the dishes perfectly. It has been doing this 'performance' for a week now -every time I use it- can you shed any light please


... Electrolux Dishwashers

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer

My dishwasher won't turn on and makes a high-pichted ringing noise. The problem began when our power went out during a storm. The circuit breaker works as the disposal is connected to the same breaker and still works. The nosie stops when I trip the breaker. The unit is almost 6 years old and is a Profile.


... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

GE GSD2230 JUST RECENTLY I'VE BEEN HAVING TROUBLE GETTING IT TO START. I HAVE TO KEEP PLAYING WITH THE DIAL. IT'LL HUM BUT WON'T PULL ANY WATER. AFTER PLAYING WITH IT A WHILE IT'LL COME ON AND OPERATER CORRECTLY. I'VE NOTICED THAT WHEN IT STOPS, IT'S NOT STOPPING IN THE SPOT THAT IT USE TO. MY UNIT IS CLOSE TO FIVE YRS OLD.


... GE 24 in. GSD2230Z Built-in Dishwasher

Built in model MDB5601AWB- about 3 years old. The touch panel stopped working..no lights would come on when touched. Tried it a couple of days later. Lights came on..finished a cycle. after satying in the wash mode for a few hours. Then lights started flashing on and off. At that point I shut it off at fuse box since I couldn't get lights to stop blinking and haven't trusted to use since


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. From what you have described it seems to be the ... Maytag Dishwashers

Dishwasher is 16 months old. Recently, it won't get tea stains from spoons or cups and there is a white film on plastics. I have run unit once with vinegar. I tried using less detergent and no change (Cascade Complete). (Neighbors using same detergnet on different machine with no problems so it's not the water.) I always select High water temp and air dry on normanl wash. My hunch is that the motor is going bad and therefore it is not pushing the water with enough force.


Hello, there are a few thinks to check on the dishwasher. Circulation, drainage - no backflow back into tub, and water temp. If all three are good, then you have hard water. \015\0121. circulation - These MDB models are very good with water circul ... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

My Asko D3232 will not turn on. No power light will work and I've checked breaker and outlet for power (which are okay). Any ideas. Unit is 3 years and 2 months old. Is there any reset switch on the unit?


... Asko 24 in. D3250 Built-in Dishwasher

Frigidaire dishwasher 15 months old. just started not washing dishes very well. set it for high temp wash. put plenty of fresh dishwashing liquid in. the unit goes thru a full cycle. you open the door and dishes are still dirty. there is always lots of dishwash liquid in the door. some of it runs down the inside of the door of the unit. just does not use all of it so dishes dont get cleaned. what could it be?


First I would check to see if it is getting enough water. There is a screen in the water inlet valve that tends to pick up debris. Follow the links Di ... Frigidaire Dishwashers

My fisher paykel dishwasher DS6031 started beeping and would not stop(not during use). I turned off the power for 20 seconds. The beeping stopped but the unit appears dead. The only manual recommendation is to replace controller. The dishwasher is approx 7 years old. Any ideas on part #, price, is it worth fixing?


... Fisher Dishwashers

When the dishwasher not in use, it filled the water up by itself. And after it was full, the water leaked out to the floor. Even after I turned off power, it cannot stop. I have to shut the valve under the sink to stop it. What is wrong? It is only three years old. Hou


Hi,\012If you have a problem with your washeror dishwasher continuing to fillwith water after the valve has closed, then you this tip will help youunderstand why that is happening.Here is a tip that will help you... ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Is there a reset button on dishwasher model S62NXPLP7653? It filled with water, then shut off and won't restart. If there is no reset button, what other thing should I try. The unit is fairly new, maybe 6 to 8 months old.


... Whirlpool Dishwashers

No power to unit breaker did not trip has electric used last night 2 years old


Check the terminal box at the bottom of the toeplate.could be a burnt wire. ... Dishwashers

I have a Bosch SMU2046Uc/14 about 15 years old. Sometimes it works, sometimes not, for the last couple of months. Now it has stopped working completely as if no power. Checked the breaker. Another problem - one of our kids just today jammed the door lock on it and we cannot get the door to latch at all. Can you help with any one of these problems? How do you fix or reset the door latch??? What else can we check to troubleshoot the dishwasher? Thanks!


... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Maytag MDB6600AWW Unit is approx 3 years old it was finishing a load and stopped part way through sticking on heated dry. I don't know if it was there in the cycle or if the diagnostics on the board sent the message there. The light now will not shut off or move from the heated dry. I have disconnected 120 volts, removed the panel to check wiring, removed board and reassembled nothing resets the heated dry light and nothing works. I have gone through manual function test, sales floor demo test,


Have you tried pushing heated wash, heated dry, heated wash then heated dry? Sometimes this will reset it. ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Maytag 6 yr old Dishwasher - Model LR111721 Standing water in bottom of unit. Front panel lights do not come on. Checked circuit breaker in basement & it is getting power. Last time we used it it seemed to make a bit more noise than ususal.


... Maytag Dishwashers

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

Kenmore Dishwasher Model 665.11643300 Cycle will not run. Normal Wash light blinking Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was some sort of sequence Note* last cycle ran was rinse cycle many months ago - house has been vacant and dishwasher has not been in use.


I will look a bit further in detail about your dishwasher problem. I am assuming you have checked the inlet water tap to the dishwasher is turned on. ... Dishwashers

Dishwasher is reading "overfilling", but no water is in unit. Door can open, noise of motor or pump continues and will not shut off even with the Power switch. Only way to stop noise is to turn off the circuit breaker at the electrical panel. What does this sound like to you?


HI- The flood switch has been tripped. It is located under the unit and is not really accessible except by a Tech. The most likely cause it poor draining; if there is a little water left over from each part of the cycle then eventually the water ... Asko 24 in. D3530FI Built-in Dishwasher

Soap cup This unit is 30 months old. It does not dissolve the soap tablets and when you open the door after cycle is complete there is condensation on the door. We always use the Smart setting.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Kenmore 24 in. 16269 Built-in Dishwasher

My Karcher pulses when on standby,stops when i use the trigger,but it also seems to have lost pressure.Is less than 6 months old but have lost receipt!


Is there a leak from the bottom ?\015\012\015\012If so Problem, the leak is from the seam of the Manifold housing. There is a small crack in the seam. A design weakness.. A New Manifold Complete Replacement approx. $61.03.\015\012\015\01 ... Karcher K 5.85 M Electric Pressure Washer

F&P DD603i Greetings! My mother-in-law went to use her 18-month old Fisher&Paykel DD603 bottom drawer today (Thanksgiving) but it started beeping and showed an error with the motor. From the messages here, it looks like you may have a service manual for this unit? If you do, would you be kind enough to forward it to me also? My mom-in-law would greatly appreciate it, and I could probably get an extra slice of pumpkin pie!! Thanks, Craig [email protected]


Service manuals can be found at http://www.fisherpaykelparts.net ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Danby ddw497w will only be about 5 min into cycle when digital code E2 appears it then starts beeping 2 min after this it just stops the unit is only one day old it ran once yesterday fine now i get this code no matter what cycle it is on I bought mine new off the internet and it's been running great for about 2 months. Now I can't get it to drain and E2 shows, I can't get my money back because I've had it more than 30 days, if the solution is a pump, I'm tossing it and getting a good one from


E2 is a hose issue. There is either a kink in the hose, the hose is too high to drain or the pump is faulty.1-800-26 DANBY ... Danby DDW497W 22 in. Countertop Dishwasher

My asko dishwasher ran great until recently. after finishing a load, the pump just continues to run (even when all water has been pumped from the unit and it's running dry) and the display isn't flashing anything (not codes, etc). Worried about destroying the pump, I shut off the washer at the breaker, and it's been a few months since we've had a dishwasher. Every once in a while I'll turn the power on and it just continues doing the same thing - it's stuck in this position/state, so I have to s


The IC that controls the pump seems to have gone kaput. Change the IC. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0934 seconds