Having problems with your Dishwashers ?

Wiring connections. Trying to hook up an old FSP 361316 washer motor to use to power a fan. Can you tell me how to hook it for the slow speed and fast speed? It has a white, orange, and blue wire.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Wiring connections. Trying to hook up an old FSP 361316 washer motor to use to power a fan. Can you tell me how to hook it for the slow speed and fast speed? It has a white, orange, and blue wire.


... Dishwashers

My wiring is Blue, Green, Yellow, Orange, Brown, White, Black and purple how do i hook that up to a Honwywell RTH7600D


... Dishwashers

I am installing a dishwasher. When I went to wire I had only two wires a white and blue comming through the house wiring and a white and black from the dishwasher. Does blue go to black. White to white and how do I gound it Thanks George


If you have a volt/ohm meter you can check for Power on the Blue wire. Or you can open the face of your fuse box and look to make sure the Blue wire is connected to the fuse. If it is, just hook up your Black from dishwasher to the blue from house. ... Dishwashers

I'm attempting to reuse a Maytag dishwasher motor for a bench grinder. Since this is a reversible motor, I'm not sure how to connect the wiring to a simple switch so that it works in one direction only. The motor has 4 wires: blue, gray, red, yellow. Not sure which to connect to the hot (black), return (white) and ground (bare) wires from the romex and can't find a wiring diagram online for this dishwasher. Any ideas? Thanks.


... Hobart 29 in. AM15-1 Free-Standing Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

Hooking up the electrical wires for the dishwasher, I have a black,white,copper & two tone green wire. Where does the two tone green wire go to?


... LG LDS4821WW 24 in. Built-in Dishwasher

How do you hook-up the black and white wires?Also, where is the ground wire?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please post back with the\015\012model no# for your Frigidaire Dishwasher so that I can assist you further. ... Frigidaire Dishwashers

High limit light goes on and unit shuts off about 20 seconds into start of cycle. Disconnected both wash and rinse heater elements problem continues Disconnected white wire at high limit thermostat problem continues disconect white with blue tracer problem continues whacked thermostat with pliers no luck whacked rinse heater thermo with plers no luck relay for rinse heater clacks and unit shuts down


Well, while I must admit that "Percussive" maintenance, sometimes works, as you have discovered there is more to servicing than, just "Giving it a good whack" lol.\015\012\015\012The problems with these units, is usually to do with the Thermost ... Jackson 25 in. TempStar HH Free-standing Dishwasher

Trying to wire the pump motor. Blue, red, black, white and green. Green is grounded to the frame, but I don't know what the other wires do. Please help.


Hello,\015\012The black and white wires supply power to the motor so that it rotates clockwise when the machine is in it's wash cycle. The blue and red wires are opposite to the black and white. This makes the motor spin counter clockwise. The ... Moyer Diebel 24 in. 301HT-40 Built-in Dishwasher

How can i tell which wire connects to the white and which connects to the black wire if there not color coordinated?


Looking at outlet and if the round ground hole is on the bottom, the white wire comes from the left side and the black, the right. Reverse if ground hole is on top. ... Estate TUD8700SQ 24 in. Built-in Dishwasher

Hi i have a gerni compact pressure washer and need to know how to wire it up. The motor(240 Volts) has red, blue ,white and black wires. There is also a starting capacitor. Thanks


... Pressure Washers

Dishwasher i have a ge dishwasher i purchased two years ago. i have misplaced my owners manual. i can only tell you it is a ge quietpower 3. i don't even know the model since i've misplaced my owners manual. it started with the timer for speed cycle set itself between 50 and 60 minutes, and i knew that wasn't right. and then yesterday it did not drain all the water out. i know there is no food particles in it because i clean them before i put them in the washer and the drain line it is hooked up


Hi lilwing,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: you have a ge dishwasher you purchased two years ago. you have misplaced your owners manual. you can only tell you it is a ge quietpow ... GE 24 in. Profile PDW7800 Built-in Dishwasher

It doesn't work at all no lights anywhere. I ordered and replaced new switches, and replaced the control board. The circuit breaker is on, and if I put one of the little meters that just tells if you have either 120 or 220 volts accross the two white wired connections on the board, 110 lights up. The float seeks to move freely.


If you have no lights at all and you have power to the circuit double check that the circuit board is connected properly first since you replaced that. On some models there is a safety circuit installed that disconnects power in the event it detects ... Kenmore 24 in. 15932 Built-in Dishwasher

Smeg dishwasher the same problem interference suppression filter part number F3CF70002L is gone. Where can i get one in uk? Can it be another problem with this dishwasher if this part is broken. Can i run without it. If yes how to conect wires 4 colors brown and blue in the lead and red and white in the dishwasher?


... Dishwashers

I'm replacing the terminal assembly block on a Bosch smu4052 uc. A short caused too much damage to the white and ground wires to tell which is which. Where can I find a schematic?


I took a calculated chance based on careful observation of the charred remains and got it right. It was only a $5 part. ... Bosch Dishwashers

Is the black wire negitive and white wire postive


Hi,\015\012The Black wire is the Hot or positive wire and the White wire is the nuetral or negative wire.\015\012The green wire gets hooked to the frame or any metal part of the dishwasher...usually there is a green screw inside the littl ... Bosch SHU9925UC Built-in Dishwasher

I am installing a Kenmore dishwasher model 13743. I have direct wired the washer?s terminal box wires to the wall power via a BX wire and the washer doesn?t respond. None of the panel buttons are active. With a multimeter, I find that there is voltage on the wall wires and on the dishwasher end of the BX cable wires that hard wired to the wall current. Even though, when I connect the dishwasher?s terminal box wires to the BX wires as directed in the Installation Instructions (white to white,


Next step to check the door switch...the door must close and the switches on the door must close to send power to the control...let me know ... Dishwashers

I wired a ge dishwasher ..white to white and black to black. the ground..green wire a screwd to the dishwasher.. turn it on and everything worked ok til the pump came on and the the black to black connection overheadt and starte a fire.... what did i do wrong...note my house wire has only white and black...thanks


Well, hard to say at this point. Your wiring sounds correct, but there may be some other stuff going on which you may have not anticipated. First off, what size breker is attached to the wires you connected to the machine. Most household machine requ ... Dishwashers

HI. Trying to install a LDF6920ST Dishwasher. Question about the wiring. The wires coming out of the machine are Black, Green with a yellowish stripe and White (the white one has a label attached to it with a "N" on it). The plug wires are 3 side-by-side. They are gray, green and gray. Which wires do I connect with which wires?.


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

2 wires from the plug wire to the on/off switch have come off. there are 4 connectors on the switch no1 has come off no2 has a black wire on no3 has come off no4 has a blue wire still on .so do i put the blue or the brown wire on no1 connector


... Karcher Pressure Washers

KitchenAid dishwasher Hi I have kitchen aid kds 20 dishwasher around 25 years old it has a broken motor and I was trying to put a new motor in it,the old motor has 3 wires white,black and ground but no extra startrelay. the new motor (partno: 4171686 from whirlpool) has 4 wires white,black , yellow and ground , also in package was startrelay but no wiring info for this motor. I Need wiring info if someone can help. Regards. Bjorgvinj


... KitchenAid Dishwashers

My LG Dishwasher LDF7932ST has White, Black and Green wires coming out of the unit, no problem there, however the ALL Grey Cord that was in a separate bag does not help me identify which wire is white and which wire is the black, I can only see that the green wire is in the middle of the three attached to the grey cord as I can just see a little bit of green, how am I suppose to know which ones are the other two? I tried pullilng back the grey rubberized cord to see if it was show me ... but no


Hi,\015\012\015\012There is a simple way to tell is to look at the plug end of the cord...\015\012The blades on the plug will be two different sizes...\015\012The blade that is the larger of the two will be the white wire... ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Hi i have a dishwasher to wire in could you tell me if it is wired strate into the mains or does it have to flexy wire and plug on instead as thare is no cable on the back to tell me wich one


Best to wire into a plug so machine can be disconnected if repair is needed etc ... Dishwashers

I'm installing an electrolux dishwasher, the first thing I'm going to do is the electric wire. I know I have to attach the black white and green (ground wire).I've done this before with my Maytag and it was a breeze. When I open the elec. box on the electrolux dishwasher the black white and green wires go into the box from the Dishwasher and then THROUGH THE BOX AND THEN BACK INTO THE DISHWASHER>>>>>THERE IS NO END........... In the Maytag I just opened the box on the dishwasher and the ends of


There should be a complete wire connection already there ready to be plugged in. If not, typically at the back of the unit there should be a black plastic box that when opened will indicate 3 terminals. live - neutral - and earth. Looks to m ... Electrolux Dishwashers

Need to know how replace a 3 prong plug on my dishwasher model # fdb1050rem0 frigidaire dishwasher the wires on dishwasher are white,black,red wires on 3 prong are green an 2 white wires


On libnk below tells you how to change the plug. Step 8\015\012\015\012http://manuals.frigidaire.com/prodinfo_pdf/Kinston/15442730 ... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0712 seconds