Having problems with your Dishwashers ?

Teka tdw 45.3 fi electronic - Dishwashers


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Teka tdw 45.3 fi electronic - Dishwashers


... Dishwashers

Hi, Our Teka TDW 59.2 FI Dishwasher engine not starting.Where do I get an engine in Dublin area? Otherwise it is buy a new dishwasher as per local handyman. Any ideas?


... Dishwashers

TEKA Dishwasher TDW 59.2 FI Error lights Light 1 = off Light 2 = on Light 3 = off Light 4 = on Light 5 = flashing


... Dishwashers

Teka Dishwasher DW6 59 FI Electronic. Stuck on rinse and will not operate on any programme


Hi\015\012Because the timer controls many operations, a faulty timer can cause many problems. The timer is a complex component, so you shouldn't attempt a do-it-yourself repair. Test the timer with a VOM set to the RX1 scale. To gain acce ... Dishwashers

Teka dishwasher beeps continuously


... Dishwashers

Kenmore 665.1646 dishwasher. A nearby lighting strike killed some electronic devices in our house. We have electricty to our dishwasher but the console will not light at all. The fuse, latch switch and overfill switch all check out good. We replaced the electronic control, 8539379, and still have no lights. What else could it be?


Hi.If you have tested fuse, overfill, latch, and you have a new electronic control, then it is necessarily a wiring problem. However, since wiring problem causing this after lighting is quite uncommon, I suggest double checking all the re ... Dishwashers

Looks like program in electronic dishwasher has locked into a cycle. the machine will not drain even after resetting it. Also it will not restart any program or cycle after resetting and recycling power. The machine is a classic electronic bosch dishwasher It has worked perfectly for three months


Im a old bosch tech . the problem is the module or the drain pump is stuck. if this helps please give me a 4 thumbs up post thanks. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Hi I have a LG LD-2052 dishwasher. It gives me an E 0 error - the water does not pump out when I open the machine after a few minutes when started to wash and message of E 0 appears? Have cleaned an


... LG Dishwashers

Whirlpool dishwasher This dishwasher quit in the middle of a wash cycle,we had to empty it and wash by hand. I thought that maybe the breaker to the dishwasher popped but when checked it had not .I then noticed that there are no lights on the electronic key board .Even when not in use there should be one red LED that is lit. It almost seems as if there is no power to the dishwasher. Is there some type of backup safety switch or breaker on the dishwasher itself that I could reset?


Fuse on control board. ... Dishwashers

My dishwasher if a Fridgedare Gallery dishwasher appros 6 yrs old with an electronic front...just ran the dishwasher..everything fine and now all the lights are flashing and i can't reset and the dishwasher won't turn on. Can u help


Hello. I would turn the dishwasher off at your electrical panel and leave it off for five minutes. THen turn the power back on and it may reset everything\015\012\015\012lem me know as I have additioinal ideas if this doesnt work ... Dishwashers

Hi there I purchased a Simpson Riviera 966 Dishwasher about 10 years ago and was very happy with it. All of a sudden water was flooding the kitchen from somewhere under the dishwasher, and not having the money to repair it at the time, it has just been sitting, and possibly the seals may need replacing. All electronic funtions seem OK on it however. Would it be possible to give me a quote on repairing the dishwasher - I HATE washing up !!!! My name is Hartley Cowderoy, and I Live at 65 Rosemount


... Dishwashers

I have a Frigidaire 1500 series with fully electronic control dishwasher. When I try to start it all the lights come on the display but not water enters the dishwasher. I have tried various settings including delay start but still the same outcome. The over-fill protector in the bottom of the dishwasher moves freely. What else should I try?


... Frigidaire Dishwashers

LG Dishwasher My LG Dishwasher Model: LD 14AW2 Electronic stand alone keeps on coming up with an error E1? I am not sure what it is because we have no instruction manual. The dishwasher is about 2 1/2 years old. I am doing a standard (Normal) wash. It starts to put the water in side then comes up with the error.


I have same dishwasher first check the water is cumming in if not remove the left side cover.1) the bottom tray is full of water you have a leak . replace the leaking part . 2) you will see a foam float toward the back of ma ... Dishwashers

Problem for Kenmore 24 in. 15992 Built-in Dishwasher Previously answered by Ginko but have not had any responses since June 18 and problem not solved. No water flow into dishwasher. Actual model is Kenmore Elite undercounter dishwasher 665.15982990. Float is not stuck. Worked fine for 10 years until mid May. Display shows cycle is on and counting, for all the different cycles. No valve or motor sound when starting cycles, only a single electronic click. When cycle is canceled, motor does s


Hi.Sorry about your old query.If there is no power on black wire and no filling, then check and eventually replace the thermal fuse. The thermal fuse is attached to control board. If it is faulty it will read continuity, norma ... Kenmore 24 in. 15992 Built-in Dishwasher

I have a bd 1681 60cm electronic dishwasher, set dishwasher to rapid setting, dishwasher starts water and then drains again code e1 will then come onto display. could you source problem please


... Baumatic Dishwashers

Teka DW7 59 F1 dishwasher bottom spinner arm not spinning have replaced arm but made no difference top arm /top section of dishwasher working fine


... Dishwashers

Teka DW7 59 F1 dishwasher bottom spinner arm not spinning have replaced arm but made no difference top arm /top section of dishwasher working fine


... Dishwashers

Kenmore portable dishwasher 665.1784 faulty Electronic Control


Hi do you get any fault codes? ... Kenmore Dishwashers

We have an LG dishwasher LD14AT1 P/No 3850ED3005R. It kept signalling an error to do with a leak- all hoses etc were checked, one relaced but no fault was found, so we had a repair man come out and he repalced the electronic board at a cost of $200.00. The error still kept signalling (by the dinging sound). It was then discovered that the appliance had rusted and there was in fact a leak in the base of the machine, not a fault in the electronics. The machine has just remained idle since. I belie


I agree that it should not leak like it is dowing. Is it really rusted/corroded? Or is there a whole?The tech should have seen the leak with ease. Replacing the PCB was uncalled for.Regarding the leak, I would gather the pr ... LG Dishwashers

Installation upon installing 24"stainless electronic dishwasher, I don't see how & or any top tabs to attach to under counter top for stadiltion. most diswashers have tabs for wood screws to attach the top of dishwasher to. please advise. theres just thick plastic w/ grooves in it..


Some people put timber off cuts on the top panel to stop the dishwasher tilting forward ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

How to reset a dishwasher teka lp700 - Dishwashers


I have a problem with teka lp 700, dial gets stuck and water starts to spill out, also the motor after awhile ceases up. ... Dishwashers

Electronic controls the dishwasher will not turn on. press and hold the heated dry button for 5 seconds and the machine came back to normal. now even that is not getting the machine back to normal. the normal button and start buttons flash but machine does not function. i have the front electronic panel off and do have a volt meter to test if you could run me thru the proper procedures.


First thing to check is the door latch switches, and hte strike plate(metal tab protruding from the top of tub assy in which the door closes into, if bent up to high the door will not be recognizedas being closed. you can use a small screw driver nad ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Our GE Profile Dishwasher is not working since today afternoon. The electronics seem to be working fine but the water supply does not start on pressing the start button. The dishwasher seems to go on with its cleaning cycle without water. We don't know how to fix this or to even check any plumbing/water supply problems. Please help.


OK First try this below....\015\012\015\012Ok so your dishwasher won't do anything... it justs sits there and "Hums" you can't make it respond to any controls, and the ONLY way to Stop it. is to unplug the unit, replugging back in it simply "Hu ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

My 2008 frigidaire 24" dishwasher model #FDB1050REC is not washing during the cycle. I have run the test cycle and the tub is filling up and draining but no washing is taking place during the wash cycle. The dishwasher has an electronic control board and therfore no mechanical timer. I put test leads to check for voltage on the power leads to the main washing pump, which I have already replaced with a new one, and I'm only registering a low voltage of around 10 or 11 VAC. With the cycle off I'm


If you have replace the motor and this did not fix your problem then yes replace the control board ... Dishwashers

My GE dishwasher will not turn on. The electronic touchpad will not do anything...I can't change the wash cycles or reset anything. Is there a reset button for the touchpad? Or do I need a new dishwasher?


... GE Tritonr XL GSD6260JCC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1968 seconds