Having problems with your Dishwashers ?

DWA147X On installation shows an ER 01, saying that the anti-flooding system (where present) has been tripped. How do I fix it?


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DWA147X On installation shows an ER 01, saying that the anti-flooding system (where present) has been tripped. How do I fix it?


... Dishwashers

My dishwasher a favorit 65070 is showing an error code of i30. This shows the anti flood system has triggered. How do I fix this please!


... AEG Dishwashers

Showing E1 anti flooding system has been tripped. How do you correct this.


... Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher

WE HAVE A SMEG DISHWASHER AND IT KEEPS COMING UP ERROR 1 MESSAGE ANTI FLOODING SYSTEM HAS BEEN TRIPPED HOW DO WE FIX


There is a water leak in your dishwasher. Need to find the source of the leak. Usually a cracked hose or water leak through door gasket.You can check this by turning off the water supply and mains power. Take dishwasher out from under bench i ... Smeg Dishwashers

Bosch SHX45P05UC: i see from other forums this model often overflows within a year of being installed. Customers must make modifications to the drain system to accommodate the company's failed design. Is there a fix for an overflowing bosch dishwasher in the filter system, to eliminate the larger particles of food from lodging in the machine's drain/pump system?


... Bosch SHX45P05UC Dishwasher

Flood switch This DW is a Kitchen Aid version of a Fisher & Paykel. Both drawer rinse lights stay on, the drain pump stays on. Book says the flood switch is activated. Is this somthing that a homeowner can fix or am I required to call for service?


I had the same problem and I fixed mine. It wasn't hard at all. First, make sure power is off either unplug or shut off breaker. Next, open the lower drawer and on the sides toward the bottom you will see a circular recessed pin with a flat slot. Wit ... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

Our two drawer dishwasher model 603dd was working - it showed the "flood button" and then the power cut out and now there is no power to it. Its two years old. Id it worth fixing?? id there anything we can do to fix it or do we need the Fand P repairer out? Thanks


I have a the F&P double drawer d/w. When I use only the top drawer, the bottom one fills with (dirty) water; and when I use only the bottom drawer, dirty water fills in the top drawer. When I use both at same time, there's no problem. Any sugg ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Model 110 - 20722990 sur ck 0966307 type 111 - Suddenly on the spin cycle - it started making a high pitch sound - ( should we stop using it immedicately - or can my wife presently keep using it ) - when you open the top cover - it stops - what I want to know if a handy man can fix it ( thats me ) or should I call a appl. person - and the steps to fix it ( also what is your charge - it says as low as 10.00 ( I hate as low as ? )


Hello. That sound is an indication that the transmission is on it's last legs. This is not a repair that a handy man should attempt. In fact, if this machine is more than three years old I would not recommend a repair. You would be better off to ta ... Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

What do i do when the anti-flooding system has been tripped


Take hose off tap it and put back on ... Smeg Dishwashers

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Drain pump The drain pump is running continuously. The instruction manual says the anti-flood system has been triggered, and I should switch off and contact AEG. Is there anything I can do? I am a qualified engineer. This happened once before and the techbnician apparently solved the problem very quickly (I wasn't at home) and charged quite a lot! Kel [email protected]


Switch off at the mains. Take a side panel off and tip your dishwater over 45degrees towards th open side. Make sure you put towels down to soak up the water that will come out of the base. This will reset the flood detector. Reassemble. Switch ... AEG 24 in. Favorit 40260i Built-in Dishwasher

This is a "ventless" system. Our dishes aren't drying in any cycle. There are two door gaskets on this model, one was installed by me under the countertop. I was sure to make as complete a seal as possible, since I did not see a vent on the door itself. What can I do to fix this problem?


If your dishes are not drying properly, you most likely will have a defective heating element. You can remove the element on a General Electric appliance, (or any other make and model) and replace it, by following these simple steps: 1. Your heating ... Dishwashers

My dish washer has codef2 on it it says flood switch has been activated how do i fix this


1-Unplug power2-Dry out floor first.3-Wait for at least 6 hrs so the sensor has a chance to dry out.4-After that plug in power so you can troubleshoot why there is a leak.5-Most the time the Lid seal went bad after using a whi ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hello i have a dd603 dishwasher the f1fault code shows up which said to be flood switch has been activated how can i fix the problem


First you half to find the leak... This could be from many reasons. here are some common leaks with this unit : Lid seal is very common, motor seal, Drain hose, inlet water valve.\015\012\015\012Then you dry the inside bottom of the mac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Hello there during normal operation, our F&P DW60 started beeping and displaying E6 which the manual says means that the flood switch is activated. How can we fix it? thanks Cath


Hi,Pull the appliance out, tip it back about 45 degrees and see if water runs out of the base.If it does, drain the base (under where the tub) completely and the anti flood should reset.If there is an aqua stop dev ... Fisher Dishwashers

I have a brand new Miele dishwasher which has worked grate since it was installed 2 weeks ago. It keeps shutting itself off & indicates an F13 fault. I looked in the manual, see that water is going in fine & pressure is good. It then says to clean water intake filter. How do I get to that ? I don't have a user maintenance manual. I'm on city water & doubt that the filter is clogged but My wife will kill me if I don't get it fixed today. Can anyone help. Glenn


On my Miele 1220 dishwasher, the inlet filter is inside the inlet hose connector, where it screws onto the water supply. To clean it:\015\012\015\0121. Turn off the stopcock.\015\0122. Unscrew the inlet hose.\015\0123. Remove the black rubber s ... Dishwashers

The normal light on my Whirlpool DU1101XTPQ7 is blinking. Service company installed a new circuit board but this did not solve the problem. Now they are saying it's the control panel (after the third visit to my home to fix this).


A blinking indicator light means the thouch key that geos with that light is stuck. So yes you need a control panel since the touch pad assembly is installed on it at the factory. I would have them put your old control board in with the new touch pad ... Dishwashers

Fisher and Paykel dd605 The flood switch has tripped and is showing "F1 with spanner" on the display turned of for 24 hr still there pumps just running . this problem happened aftr my son put cloths washing powder in it


F1 is a flood code meaning excessive amounts of water have collected on the bottom catch basin. If a flood condition is detected, both draws will activate the drain motors and flash F1. Remove the bottom drawer and dry the catch basin.TUR ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

F1 fault shows flood switch activated, how to fix??


HiThanks for using FixYa. As you know F1 error means that the flood switch has been activated.You’ll need to reset it by powering off the breaker or by unp ... Fisher and Paykel Dishwashers

Anti flood system been activated, how do i fix it ?


... AEG 24 in. Favorit 50740 Free-standing Dishwasher

Acquastop failure. Code E1 The anti flooding sytem has been activated. The system is tripped in case of water leaks..


... Smeg Dishwashers

I have the "rinse" error code on my kitchenaid double drawer dishwasher kudd01dppa1. I've turned off the power, then it worked for one load and the code reappeared on both drawers again. What should be a next step? it says in the manual that the "rinse" error code means that something happened to the flood switch...? Can this be fixed without calling out the kitchenaid technicians? thanks


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

I have an zanussi LS6 and in the display it on and off shows the A1 and B2 and spills water. The problem though is not what normally comes with A1 and B2. Somehow the water gets to electrical parts and all power is out in the café. Several experts that has been to see the machine clame it has something to do with the electrical system - that measueres when there is enough water. They say it has something to do with machine having the salt container and they have all given up repairing it. I boug


... Zanussi 24 in. LS6E Free-standing Dishwasher

"F1" Flashing on Control Panel on my Fisher Paykel Dish drawer DS603. User manual says Flood switch has been activated and to call Authorized Service. Can I fix it instead myself? If so, how?


Thanks - your expert pointed me in the right direction. Never found a leak, but I dried up the water in the tray, which may have been from condensation, and dishwasher seems to work fine now. ... Fisher and Paykel Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0974 seconds