Having problems with your Dishwashers ?

Kitchen aid KUDP021R does not drain

\015 Door counterbalance broke allowing the door to drop violently, since then the timer stops working at heated dry and also does not drain all of the water out of the machine. Could a wire have come off or did the brain not like the dropping of the door?\015

Answers :

Test this steps and fix it. God bless you
1. Air gap / Drain hoses
\012\011\011\011\011\011\011If there is an air gap (located in the sink, near the faucet), \012check to see if it is clogged. Unscrew the top cap and see if there is \012anything blocking inside. Note: If there is no air gap installed, the \012dishwasher might not drain properly.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\011If the drain hose is clogged, the dishwasher would not drain. If \012there is an air gap installed, it is very common that a hose going from \012the air gap into the garbage disposer is clogged. Remove and clean the \012hose. Make sure to reattach the hose before starting the dishwasher.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\011Note: If you recently had a garbage disposer installed, it is common to overlook removing the drain plug.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0112. Broken belt
\012\011\011\011\011\011\011Some dishwasher models use a belt to drive the pump. Replace the belt if found broken.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\011Note: Sometimes the belt would just come off the pump. Even though\012 it might not be broken, it is recommended that you replace the belt, \012because it is probably too stretched out.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0113. Pump
\012\011\011\011\011\011\011Some models have two impellers inside the pump - one, wash \012impeller, takes care of the wash cycles, the other, drain impeller, \012drains the water out. If the drain impeller is broken (broken blades, \012shaft), the dishwasher would not drain. Replace any broken pump \012components.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0114. Drain solenoid
\012\011\011\011\011\011\011Some models (for example most GE dishwashers) use a drain solenoid\012 to drain water out. Sometimes the solenoid gets stuck, preventing the \012water from draining out. Try to free up the solenoid. If unsuccessful, \012you might have to replace the pump assembly.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0115. Motor
\012\011\011\011\011\011\011If the motor is stuck, it is sometimes possible to free it up by manually spinning the motor.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\011Replace the motor if defective.
\012\011\011\011\011\011\011
\012\011\011\011\011\011\0116. Timer
\012\011\011\011\011\011\011Replace if defective (note: uncommon problem).\012\011\011\011\011\011
Read more: http://www.appliancepartspros.com/repair-help/dishwasher-repair-help.html#3#ixzz2aaqbXzEw\012
http://www.appliancepartspros.com
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Kitchen aid KUDP021R does not drain


Test this steps and fix it. God bless you1. Air gap / Drain hoses\012\011\011\011\011\011\011If there is an air gap (located in the sink, near the faucet), \012check to see if it is clogged. Unscrew the top cap and see if there is \012 ... Dishwashers

I have a Kitchen Aid KUDS03CTSS3 dishwasher. Dirty water is staying at the bottom and nothing comes out the drain hose during the entire cycle. The drain hose is looped above the kitchen P-trap, although for a time it wasn't. I use a wet vac to get the water out but there is still water below the fine filter. I thought if I could get the fine filter off, I could clean out the bottom as I think that it's full of crud down there that may be blocking things. I can't figure out how to get the l


Hi,Thanks for the follow up. I am glad it worked out for you. If I can Help in the future let me know. http://www.fixya.com/support/c64627-kitchen_aid ... KitchenAid 24 in. KUDP02FR Built-in Dishwasher

I have a Kitchen aid dishwasher model#KUDP02CRBL2 and I replaced the drain pump and all it does now is drain very slowly i haveblown air through the drain line and removed all debri that was blocking the drain line cant figue out why it drains slow


... KitchenAid Dishwashers

Kitchen Aid Dishwasher KUDR24SEBLO does not drain 100%. I have removed the drain hose and chcked the sink P-Trap, [it drains thru the garbage disposer]. Unit is 10 years old, otherwise works fine. I am having difficulty removing the impeller and items above the pump to see if it is clogged. Do you think I have a partially clogged pump or a timer issue that prevents the pump from completely emptying the bottom of the dishwasher? We have run the dishwasher 20-30 times since observing the problem.


Hi there,\012Please check out the following -Pump - Your dishwasher pump ejects the water. The pump is usually mounted directly to the motor, then attached to the bottom of the dishwasher. You can reach the pu ... KitchenAid Dishwashers

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

Kitchen aid dishwasher not draining....help


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Water will not drain out ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

Kitchen Aid dishwasher doesn't wash dishs, water doesn't seem to spray onto dishs, rest of cycle seems to work fine ( heat & Drain )


... KitchenAid Dishwashers

Not draining I ran the dishwasher and it doesn't drain all the way. We cleaned all the lines on the dishwasher and even to the garbage disposal. What else can it be. It's a kitchen aid.


WATER OUTLET SOLENOID IS BAD OR TIMER ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Hum in Kitchen Aid Dishwasher Model 8531529. Stated last night. No hum when filling or draining - only during the wash cycle. Can still hear the water spinning inside during the wash cycle, but hum is loud. The water does fill & drain completely/correctly. Any ideas? Might this be an easy fix? or a likely repair man call? Thanks!!


Hi\015\012\015\012The hum sound that you hear is from the motor that is not\015\012working or is about to go out, the motor should be replaced. Hope this\015\012helps...please post back for further assistance.\015\012\015\012Dani ... KitchenAid Dishwashers

Not cleaning properly, and Water will not drain out. However when we pull the house out the water does drain. Assuming pump? KUDV24SE Kitchen Aid Built In


During normal operation the outlet hose should be higher than the outlet nozzle, if the water drains when youremove the hose it means that the pump is not working, open the bottom of the machine and remove the inlet side pump hose and check for any o ... KitchenAid 34 in. KUDV24SE Built-in Dishwasher

Our kitchen aid dishwasher mod KUDE03FT is not draining. We have checked to breaker box and no breaker is tripped but it is as if the front panel is dead even the drain button will not respond


... KitchenAid Dishwashers

I just installed my kitchen aid dishwasher model kudco03fvss and it won't drain. There is standing water in the bottom of the dishwasher. It is a brand new appliance. There is no water going through the drain hose that I can tell. Is the pump faulty?


Hi, my name is Audrey. I am a KitchenAid employee and thought the following link might help address the draining issue you're having with your dishwasher:\015\012 \015\012 ... KitchenAid KUDC03FVSS 23 in Builtin Dishwasher

I have a Kitchen Aid dishwasher. IC Series. Model # KUDN230YWH. The dishwaser fills and runs but it does not cycle past that. It will run until we shut it off. I can hold the button in and it will click and to get it to the drain cycle and it will drain but it will not do it on its own. It just fills and runs. Thats it. Thanks


Hi\015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing that should be checked is the Timer and then the\015\012heating element. Timers don't often ... KitchenAid 24 in. KUDP02SRSS Stainless Steel Built-in Dishwasher

Kitchen Aid Dishwasher Not Draining


There is a knock out plug on the garbage disposal that probably wasn't removed. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I HAVE A KITCHEN AID DISHWASHER model number KUDM25SHBL1. AND IT WONT DRAIN ALL THE WATER OUT AT THE END OF THE CYCLE. WHTA COULD BE THE PROBLEM?


... Dishwashers

Kitchen Aid KUDS02 dishwasher - does not drain


... KitchenAid Dishwashers

Water will not drain from Kitchen Aid Dishwasher


Kitchen Aid makes the worst appliances on the market. Never buy them, they should stick to mixers. My dishwasher doesn't drain, the glass on my convention microwave/oven shattered in the middle of the night, the freezer doesn't freeze. Service calls ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

I have a kitchen aid dishwasher KuDR01TJBLO noisy when draining


See this causes and fix it. God bless you\012 \012 \012 \012 \012 Drain Pump\012 \012 \012 \012 \012 \012 \012 \012 \012 ... KitchenAid Dishwashers

Dishwasher will not drain it is a kitchen aid


Check the pump if there is no noise when its supose to drain then this needs replacing ... Dishwashers

Why wont my kitchen aid model kude70fvss2 drain


... KitchenAid Dishwashers

Kitchen aide won't drain


Look in your air gap first make sure there is no debrie in there this will make you dishwasher drain really slow. ... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

Kitchen aid dishwasher kudk031twho gets water drains but will not clean


... Dishwashers

I have a Kitchen Aid Superba KUDS24SEBS1. The inlet water pressure is good and the dishwasher fills and starts the wash cycle, however, after the initial spray of water, it seems that all of the water drains out and there is nothing left to continue the cycle and wash the dishes. It's like it's not able to fill up enough to wash the dishes.


When "full" of water, the normal height of level is about 1/2 below the heater assy(large blackish grey coil below he spray arm).. if theres enough water in the unit nad its still not "spraying",its quite possible that your filter/chopper assy is cl ... Dishwashers

We have installed a dishwasher (as of yesterday) and everything seems to work but it will not drain. this is a replacement for a kitchen-aid dishwasher that we have had for 17 years. Everything looks the same - it is supposed to pump through the garbage disposal. There is not an air gap but we did not have one with the old washer.


HELLO THERE PLEASE TRY THESE SOLUTIONS I HAVE PROVIDED i KNOW THERE IS NO AIR GAP BUT I HIGHLY RECOMMEND INSTALLING ONE TO HELP WITH THE DRAIN THIS WIL RELIEVE THE AIR THAT THE MACHINE PRODUCES further More \015\012\015\012 \015\012 ... Whirlpool Dishwashers

Kitchen Aid Dishwasher Model # KUDM01TJBTO. The unit will drain with the motor, but it will not start. Some of the panel lights will light but not all. The control panel light can also be activated or unlocked.


... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0934 seconds