Having problems with your Dishwashers ?

Won't wash but comes on.

\015 I push the ''normal wash'' button and then the ''start''button. Normally, it should then start its cycle. But now it just sits there with the ''wash'' light on and does nothing. No water filling or anything. I can do a reset and the drain pump runs and the then it's back to where it was before. I took the main motor off (it was very clean). I then took the drain pump off and checked it (looked very clean). Water is definitely getting up to the water valve. I performed the ''Service Mode'' tests for the main pump and auxillary pump ( they sounded good). I then performed the Detergent cup, water valve and heater tests from the front panel. Each test, made a clicking noise (like a switch was activated) but I never heard the water valve open or the detergent cup cycle. I'm not sure about the heater but at one point, it was warm. So, I'm pretty sure it's OK. I think this is a board issue (just a gut feeling). Thanks for any suggestions.\015

Answers :

If anything else is OK, replace the control panel assembly.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher wont let u select a cycle...all buttons seem locked...ive unplugged it for 5 seconds or so and then plugged it back in and the normal wash button light comes on and the heated dry button light comes on, but it wont start and it doesnt respond when buttons are pushed...please help. thanks


... GE GLD4560NSS Stainless Steel Built-in Dishwasher

Ariston dishwasher i have an ariston built in dishwasher. It wont start washing cycle, and has 2 flashing lights from the left (total 4 lights)...can anyone help. i cant find the model number on the machine. The lights looking like sprinkiling water..i have filled the salt, and rise etc but still it wont come on please help


I have a brand new ariston ll-64 and the wash cycle won't start and two flashing lights ... Ariston Technologies L63 Free-Standing Dishwasher

Dishlex Global 310 model. My dishwasher has water sitting on the bottom of it and it wont drain. I noticed it after I did a cycle of dirty dishes and the 'fast' light was flashing when I went to open it. Which shouldnt have been because it was on a normal wash. The water has been sitting at the bottom for 2 days now and still wont drain! I've taken out all the parts on the bottom which come out and cleaned them. Still no change however.


Just ran another cycle and it was fine ... Dishwashers

The dishes wont come clean on top rack? the bottom rack is clean..we tried cleaning filter and making sure the wash arm wasnt hitting anything..we tried different wash settings..please help Jessie Oakes


Check that the top rotating arm jets are not block. These often get blocked by pieces of food or other solid particles, this is the normal problem. ... Whirlpool DU1055XTS Built-in Dishwasher

W10199645 The lights for type of cycle and drying type come on but the start light wont come on, NO WASH. Checked to be sure there was water pressure, checked the latch switch, both OK Help


... Maytag Dishwasher

My miele wont wash it starts up then stops an wont drain out then the water intake light comes on


Hi If appliance fills then starts to wash then stops and starts. Then most likely cause is debris in circulation motor. This will require appliance and motor to be removed ... Miele 24 in. G643Vi Plus Built-In Dishwasher

I have an LG dishwasher Model LD-O5AW2 Benchtop. IT has been going perfectly until now. I push the button in and then the start button, when the wash cycle has finnished it wont empty until I push the stop button off and then on again. Then it empties and goes to rinse but wont come out of the rinse cycle, just keeps rinsing, until I turn it off and on again.Up until now its been a great little dishwasher. JOAN


... LG Dishwashers

Miele g7859 will rinse and drain on programme but wont run through a wash programme and drain its stops after about 30 secs was working on a wash programme till it went to drain f a fault code would come up tipped machine on its side then it would rinse and drain it would not do that before


... Miele G7859 Thermal Disinfection Dishwasher

I have a 5 year old kenmore 665 15689 dish washer that wont come on at all . No lights no nothing . Before it stopped working the lights on the desplay were not coming on but it seamed to be washing normaly . I checked the breaker and even turned the power off for 5 min.


Theres a fuse in the back of the panel. ... Kenmore 24 in. 15689 Built-in Dishwasher

Dishwasher conrol panel light comes on but it wont go into wash cycle


All dishwashers usually start by draining first, if your machine does not detect that your machine is empty it will not start to wash. There are a few resons why this can happen, could be the pressure switch is stuck. Some machines ie bosch have a fl ... Dishwashers

Beko DSFN1530 wont start, light comes on for wash and thats it


... Beko Dishwashers

Error soak and scour light comes on wont wash


Press and hols start button until it resets then try again. ... Whirlpool 24 in. GU1500XT - Multiple Color Built-in Dishwasher

Indesit dishwasher model dif04 wont wash water comes in and go out


... Amana ADB1400AWB Dishwashers

My dishwasher wont run when i push the start / cancel button the washing light comes on and blinks ,but the dishwasher does not turn on . i put in a new control panel and it still does the same thing.


Check the water level switch/ pressure switch.Control panel may not have full control. There may be yet another board inside! ... Frigidaire Dishwashers

Indesit slimline dishwasher wont rinse and dry. Dishes come out half washed and still wet. Dryer light flashes also


ANAYIN AMINA BACAGIM G?\302\260RS?\302\260N :D anan zaaaaaa liseli <3 inci siker ... Dishwashers

White residue baked on dishes and wont come off even when washed by hand


Unfortunately this could be caused by water that is to soft combined with bad wash liquid. Typically you want to make sure you get the highest possible phosphorous content in wash liquid. This will help with the staining on your dishes. At this po ... Whirlpool 24 in. DU915PWP Built-in Dishwasher

Zanussi dw927 not filling inlet valve changed,supply to machine ok, calls for water solinoid activates for about 30secs shuts off and machine does no more. cleaned out two blue plastic pipes situated under a plastic cover which were both blocked, and put a hose jet wash thru where they were situated to clean housing out, put blue channels back still not filling up and now the inlet solinoid wont switch off when when it should and programme advances heater now comes on with no water in.manually


... Dishwashers

My baumatic bad6005 comes up with error and just beeps alot and wont go, two lights just keep flashing (I think the wash light and rinse light). What should i do???


... Baumatic 24 in. BFD60SS Free-standing Dishwasher

Bosch SHU5318: Water wont start washing


If it hums when you are in the wash phase then something is jamming the wash impeller like broken glass tooth pick found a necklace in one one time i think replacing the control board fixed the other problems on most washers ... Bosch 24 in. SHU53 Built-in Dishwasher

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

My Maytag Dishwasher mdbd880awq wont finish a wash cycle. It will wash and rise then when there is 32 minutes left it wont drain and wont dry the dishes, It just makes a clicking sound. I have to dry the dishes by hand and then use the rise only cycle to get the tub to drain. The drain only doesn't work either


... Dishwashers

Rinse only light is on and all of the wash rinse sanitize clean buttons come on and flash when you try to start it, if you change the setting to normal or heavy duty the wash light comes on then the rinse only light comes on and all above mentioned buttons flash until the tub is drained.


Hi\015\012 \015\012Try and reset the dishwasher by unplugging it for 5-10 minutes. Now check if you are still getting the same error you can try and press the following buttons to reset it-- \015\012Saini Rinse, He ... Dishwashers

Kenmore Elite Stainless Steel 24 inch tall Model 66577963K701. The heating element works for "heated dry" but not for "Hi Temperature" wash. It used to do so and when I opened the door a nice blast of steam would come out. My hot water tank is a great distance from the washer so we usually run the hot water tap in the sink for a bit until hot water comes... but the heating coil no longer kicks in on any of the cycles (Smart Wash / Normal Wash ). The high limit switch works and as I said, th


... Kenmore Dishwashers

Beko washing machine wm5100w my washing machine wont work it wont start and and the ready and wash dots keep flashing and the spin and end one stays on thanks


... Dishwashers

Kenmore 16632 dishwasher wont run but lights say washing


... Kenmore 16632 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1082 seconds