Having problems with your Dishwashers ?

Fisher and Paykel dish draw F2 code. - Dishwashers


Answers :

Buy a Miele they last 20 years or more and don't go brain dead in 4 years like the Fisher and Paykel
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fisher and Paykel dish draw F2 code. - Dishwashers


Buy a Miele they last 20 years or more and don't go brain dead in 4 years like the Fisher and Paykel ... Dishwashers

I have a single draw Fisher and Paykel dishwasher. I stupidly put washing up liquid in the dishwasher which resulted in a F1 problem. Water started leaking under the draw and onto my floor. I turned the dishwasher off at the power point and have cleaned up the leak. Have I damaged my dish washer? How do I fix it?


Ok , F1 means your flood switch has activated, which is underneath the drawer. now they show the F1 fault because of 2 reasons.1st there is still water underneath drawer causing switch to activate. 2nd your activator board which has the flood switch ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

FISHER PAYKEL DISH DRAWER U3 FAULT CODE - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


LP is a setting for Low pressure. To reset your pressure to HP, hold the Programme and Eco touch switches simultaneously for 5 seconds. Once the setup mode is entered a beep is emitted andthe LCD is red with ‘HP’ or 'LP' displayed. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

F2 Code Hey, I have a single drawer built in Fisher & Paykel dish drawer and today I pulled the spray arm, filter and large metal screen out to clean them as we have been starting to get a bit of stuff left behind after washing lately. That was all good After putting it all back in though I went to use the dishwasher and it stopped and came up with an F2 fault, I thought I may not have put the bits back in properly so pulled them out again and noticed that on the rotor that connects the motor to


Fault F2 means the rotor is not rotating. If you say some of the vanes have broken off, they could have been jamming it. This should spin freely with minimal force when installed correctly. If you removed the rotor itself, you do ned to take care whe ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Both dish drawers showing code F1 - Fisher and Paykel DD24DCFX6 Dishwasher


... Fisher and Paykel DD24DCFX6 Dishwasher

What is error code 00 on dish drawer - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel DD603 Error code F2. My top dish draw is showing the error F2 , I have taken out the baskets, spray arm, propellors. The metal shaft is completley frozen, I can't move it at all. I see other posts say to wiggle it to free it but that doesn't work here. Can I get a copy of the service manual too? We are along way from a repair man to come look and I like to try myself before spending more money on it. My e-mail is [email protected] Thanks.


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Anyone have experience with a Fisher Paykel double draw dishwasher (model DD24) getting stuck in wash mode? Once it hits exactly 48 minutes it stays there. Only several hours later it cycles through OR you have to turn it off put it in rinse mode to complete. Already tried all the basics (unplugging, no fault codes, cycled through the diagnostics everything good and working). Did the quick diagnostic cycle of 14 minutes and everything cycled through fine. Next step will be to put the bottom cont


... Fisher and Paykel Dishwashers

Fisher & paykel double dish drawer top draw just beeps...


The controllers get very brittle & can break away from their housing, the reason it's rapidly beaping is because it thinks the door is open. PLEASE TURN IT OFF FIRST AT THE POWER POINT. Take the front draw panel off by pulling the plugs situated ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

E6 code on fisher and paykel dishwasher - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Fisher paykel dish draw


Turn the power off to your dishwasher for about 30 seconds by flipping off the circuit breaker in your home's breaker box. When you turn the breaker back on it will have reset the dishwasher and should begin working just fine. ... Dishwashers

Fisher and paykel diswasher f1 fault code - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


F1 fault code means the flood switch is activated. There is moisture at th e base of your dishwasher.\015\012 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and Paykel Error code Ho - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and paykel e8 fault code - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

Fisher and paykel dish washer keeps running - Fisher and Paykel Dishwashers


It will help to come up with a cause and solution if you can please specify the model number of the dishwasher.\015\012\015\012Also please confirm if you hear the pump motor start during the cycle. How do you stop the dishwasher. Is there wat ... Fisher and Paykel Dishwashers

Code u1 fisher& paykel model 920 - Fisher and Paykel Dishwashers


Hi, this tells you everything you need to know about a \015\012 fisher& paykel model DW820 and DW920 modelsi was also looking for the u1 error, and im sure my problem is being a male i use to much detergent (powder) that creates extra foam ... Fisher and Paykel Dishwashers

Fisher paykel dish drawer f9 - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

Error code. Fisher and Paykel Dishwasher


Well since you asked on the 5th July, and no reply, doesnt look like you may get one. I thought thats what this site was about?? ... Dishwashers

F9 problem code Fisher and Paykel Dishwasher - Soft Touch


That's an electronics failure code. Bad news. http://www.advantagesupplyfl.com/FisherPaykelDishwasherFaultCodes.html ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

F1 code on fisher and paykel dish washer


... Dishwashers

Fisher and Paykel Dishwasher not getting dishes clean


Had the same problem and took out the inards and cleaned them. Also found that a lemon seed was blocking the drain channel - I used a piece of wire to snake it out. Seems like it needs periodic cleaning to keep it cleaning properly. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Top dishwasher codes f 1 & shows picture of wrench bottom unit works fine it is a fisher&paykel


Forums.whirlpool.net.au/archive/584206 give this a go. has a few solutions ... Dishwashers

Fisher Paykel Dishwasher Door Open error code


If it is a dish drawer type there is a clip at the rear of the drawer that holds the drawer closed. you will need to withdraw the drawer partially to look in. with the drawer open the fingers should be facing towards you. If not you will need to reac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Hi, I emailed sometime ago about my fisher @ paykel dishwasher not working. This will be the first time I've used your service and I'm just a little unsure how effective it will be. I guess I'm a just being sceptical but i really want it fixed without paying call out fees and the like. So how much do i have to pay. The top draw will not turn on. At the time the draw was hard to open so i went through the procedure to recalibrate the draw when i was holding down the buttons to get it into self t


Please confirm if you still have a problem with the dishwasher. It is unclear from the thread of your responses as the statements of the other expert will be visible only to the client. \015\012Also please confirm what you mean by "buttons stop ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2133 seconds