Having problems with your Dishwashers ?

Middle arm stopped spinning

\015 I have a GE Triton XL dishwasher that worked fine up until 2 months ago. I have checked the filter and have run cycles with vinegar and bleach. The middle arm has stopped spinning. I am assuming there is some kind of blockage somewhere that is keeping the water pressure from rotating the arm.\015

Answers :

You may be exactly right. I always start with something simple. spin the spray arm to make sure it goes all the way around with out touching anything. next is the hard partyou would have to take the motor apart and any filters you see and clean out all the debris.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Middle arm stopped spinning


You may be exactly right. I always start with something simple. spin the spray arm to make sure it goes all the way around with out touching anything. next is the hard partyou would have to take the motor apart and any filters you see and clean out ... Dishwashers

GE PDW8280 - MIDDLE ARM WILL NOT SPIN - WATER FLOWS AND SPINS FROM TOP AND BOTTOM ARMS - MIDDLE ARM HAS WATER FLOWING BUT WILL NOT SPIN. tOOK APART AND CLEANED - SPINS FREELY BY HAND BUT NOT DURING CYCLE. SUSPECT LOW WATER LEVEL? WATER IS ONLY UP TO BOTTOM OF HEATING ELEMENT


Take the whole middle spray arm assembly off -- spray arm and long tube that it is attached to. I cleaned the inside of the spray arm and found some odd stuff but it still didn't swing after the cleaning. I order all new parts and when I was repl ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

I have an LG ldf7811st dishwasher. My bottom arm spins with water, my middle arm does not spin but does have water coming out, and my top arm doesn't spin or have water. I have just finished taking apart the arms, the supply to the upper arms, the filters and the impeller. I cleaned everything and nothing really seemed clogged. I have tested it since and it still has the same problem. I know that they aren't spinning because i placed them in a certain position before i ran the test run. They


I'm thinking like you're thinking, that it's something affecting the water pressure, but you've done everything in the upper section, so the problem must be from below, unless you have a leak somewhere you haven't noticed and are losing pressure beca ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

GE quietpower 3 middle spray arm not spinning


... Dishwashers

I have a triton xl model @ gsd6200g00bb serial #va790400b. The dishes on the top rack are not getting clean. I have removed the top, and middle, and bottom arms cleaned calcium out of them. Removed the screen below the lower arm cleaned. The top and middle arms are still not spinning during wash cycles. Where do I go next?


Apart from the spray arms themselves there could be other reasons why the water is not getting up to the middle and top arms.\015\012\015\012The distribution circuit from the wash pump that feeds the arms could be blocked or the wash pump ... Dishwashers

I have a maytag MDB600AWW dishwasher. the top spray arm doesn't turn. it wouldn't even turn if i removed the to middle trays. I took the accumulator out and cleaned it. the fine mesh filters were clogged. unfortunately, birthday candles found their way into the machine sometime back. i cleared as much as i could. when i put it back together, the top arm would spin only when i had the 2 middle arms disconnected. It seemed there was an increase in pressure. i ran a diagnostics test and there were


First check to see if the washarm itself is clogged, if so clean it out.\015\012\015\012If the arm has a bearing it may be shot.\015\012\015\012You may have a clogged manifold on the output side of the pump. I sometimes run a ... Dishwashers

GE triton dishwasher middle spin arm not spinning


I had the same problem and found two things which were causing it-The O-ring was missing off of the tube connection on the back of the dryer that inserts into the sprayer tube. I found a size 11 O-Ring at Home Depot and it worked-The open ... GE Tritonr XL GSD6260JCC Dishwasher

Motor hummed loudly and lower spray arm didn't spin. Replaced motor which stopped humming and gave a lot more pressure but lower spray arm still won't spin. any thoughts?


Check for clogged vents. Try checking by hand for freeness .Hope no vessel is obstructing it's movement. ... Dishwashers

I have an asko D3450 dishwasher. Washer makes buzzing/humming noise at start of cycle and then randomly through cycle. I checked the sump and pump appears to be clean and impeller spins freely. The cycle seems to work ok. Water is pumping out ok. If you open the door to stop the cycle, the buzzing will continue for a few minutes then stop. If the cycle is restart, the buzzing starts again. The vibrations seem to originate from under the lower spin arm.


If the sound is a bussing - it is the capacitor mounted to the pump. It is failing.Shown here (big white cylinder on right of pic).. ... Asko 24 in. D3450 Dishwasher

Dishwasher stopped cleaning but appears to run through cycles. Possibly water starved. The bottom "sprayer has some water coming through the holes but is not spinning, (although spins freely by hand). The top and middle "sprayers" definately aren't functioning. Stopped working suddenly, (not a gradual change).


HI. I agree with your assessment. There may be some sort of blockage within the hose assembly. I recommend to inspect all hoses that correspond to the actual recirculation pump. Check the drain hoses as well. ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

Middle arm of dishwasher not spinning


I'm the one that reported the same problem in November as "Guest". I fixed mine finally. I removed the middle arm again and noticed that the holes that spray a jet ot water causing the arm to turn aren't the ones on top. On the bottom of the arm t ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Two problems: the water pressure in the arms is low. If you pop the door, arms are not spinning as it should. Each time you start and stop, the arms move a tiny bit. Have cleaned the filters and the spray arms completely. Also, detergent door no longer pops open.


Hello, Welcome to fixya.\015\012 \015\012I just came ... Bosch SHU3306UC Built-in Dishwasher

GE PWD7980 dishwasher middle spray arm not spinning when in wash or rinse cycle.


... GE Dishwashers

Noticed dishes on top shelf not entirely clean. Ran machine empty and opened many times during wash. Noticed that Lower Spray Arm works as expected, but Middle Spray Arm turns only 1/8 or less, then Lower Arm spins again. Schematic with Use and Care manual just says pump motor switches from one to the other in certain cycles, but I don't see this happening. Looked for obstructions to water flow and pressure seems normal. Is control for this function part of the pump, or in the control panel?


Something could be in that checkball, see page 5 ... Frigidaire 24 in. GLDB653A Built-in Dishwasher

Middle spray arm of GE Triton XL Dishwasher is not spinning


... GE Tritonr XL GSD6260JCC Dishwasher

Middle spray arm does not spin Frigidaire dishwasher


... Frigidaire Dishwashers

Brand new ge GDF540HSD0SS dishwasher just installed this week has a middle arm that is not spinning. This is the one that is attached to the bottom of the top rack, and sprays water up. Water is coming out fine but no spinning. As a result, the inside of dishes on top rack are not getting clean.


... GE Dishwashers

Middle wash arm not rotating on a GDL5800L00. Water comes out of holes but does not turn. Arm spins free


Check the spin spindle at the pivoying point. Clean it. The spinning takes place through the water pressure only. or contact service center to get a new part. ... Dishwashers

I have a Bosch dishwasher and the upper arm that spins and dispenses water has come off. There is a bracket on the back wall with 2 protruding pieces and an open whole in the middle which seems like the water comes out of it. There are 2 metal "clips" on the side of this braket which seems like the plate part of the spining arm should be able to attach to it.. I cannot figure out how..Any helo would be apprecated..


On Bosh dishwasher you just slide the upper arm vertically until it snaps in place. The arm attachment will snap automatically into the clips, onto upper dishrack, unless the upper arm is damaged ... Dishwashers

Hi experts! The middle wash arm in the dishwasher (underneath the top tray) does not seem to be spinning resulting in dirty glassware etc. I have checked the arm for debris which is clear and clean. The only thing I can think off is there is not enough pressure being pushed through the pipe from the back of the machine. Unfortunately I do not know where to go from here? Please help! Thanks Paul


Hello,Welcome to FixYa,Based on your description... I`d suspect a plugged or really dirty wash pump. It could ultimately be a worn out wash ... Dishwashers

I have a maytag MDB2200AWE DISHWASHER I THINK ITS A 1999 THE BOTTOM ARM DOES NOT SPIN FREELY IT GOES FOR ABOUT 1/2 A REVOLUTION THEN STOPS, WHEN I MOVE IT BY HAND IT MOVES FREELY FOR ABOUT HALF A TURN THEN GETS HARD TO MOVE, HOW DO I FIX THIS ,AND HOW DO I GET THE ARM OFF TO SEE IF ANYTHING IS JAMMING IT UP


... Maytag Dishwashers

I have a Whirlpool Gold Quiet Partner III that is 8 years old and recently stopped cleaning top rack dishes. I remember finding a mylar like piece in the bottom of the tub and threw it away thinking it came off of something we washed (I know, bad thinking.) The mylar piece measured roughly 3-4inx2in and was folded in half. Anyways....the upper arm does not spin and the detergent doesnt get fully dispensed so dishes dont get fully cleaned. I am guessing not enough water pressure to upper arm. Wou


I'm having a similar issue. Are you sure the arm isn't moving at all?\015\012\015\012Generally what I'm finding is either you have a clog or the pump motor is bad.\015\012Hear is the service manual.\015\012 ... Dishwashers

GE GLD5800L Middle Spray Arm is Not Spinning


The middle arm may be missing an O-ring at the back of the dishwasher. ... GE GLD5800L Dishwasher

I need to take apart the inside of my whirlpool dishwasher and can't get the mesh filter part under the spinning arms off it has a plastic part with a metal screw in the middle.


... Dishwashers

Frigidaire fdbb944cs0 Funnel and Middle Spray Arm not spinning


... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0842 seconds