Having problems with your Pressure Washers ?

Karcher G 3050 OH pressure washer with honda engine: The pull cord is locked so I can't start the machine. Help!


Answers :

The model G3050 OH use gas or mix?
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Just bought a jet usa 7.0HP 3950 PSI pressure washer, put it together and put oil in it and i cant pull the pull start cord out at all?


... Pressure Washers

I have Honda pressure washer.Inorder to start the pressure washer you have to pull the cord. THe cord is stuck and I am not able to pull the cord. Why it and what should I do to start the washer.


... Honda 2500 PSI Gas Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Karcher G 3050 OH pressure washer with honda engine: The pull cord is locked so I can't start the machine. Help!


The model G3050 OH use gas or mix? ... Pressure Washers

Very Hard to Pull Cord to start engine on Northstar Pressure Washer. When I remove spark-plug it is very easy to pull cord. With plug reinserted it is extremely difficult to pull cord to start engine.


On the Honda motors very hard pull starting with no start ck for broken rocker on exhaust or intake, I've already repaired two with this problem...... ... Northstar Pressure Washer 3000 PSI

Just bought a john deere 3300 power washer. It started with no problem. shut it off to answer the phone. When I went to start it the pull cord wouln't pull tryed everything but still the pull cord was in a locked position. Don't know what to do hoping you have an answer for me


First turn off the water to the machine. pull the trigger to release any trapped pressure in the high pressure hose, then try to start the machine. if it starts then turn on the water to the machine.it may be that the engine is tryi ... Pressure Washers

Pull start locked up on briggs and stratton pressure washer


... Pressure Washers

My pull cord to my pressure washer is hard to pull and it's not starting. Why? This all started after I tried to start it without the water on while attempting to start.


Take out the spark plug and trying pulling it , if its still tight then you may have seized your pump ) , put a rag over te spark plug hole as there may be fuel/oil mix in the cylinder , check the oil in the engine , check the oil in the pump ( look ... Pressure Washers

Cannot pull start pressure washer. Cord will not


Cord will not extend past 3 inches; just shut down after last use after 30 seconds. ... Pressure Washers

Karcher 2400 pressure washer with honda engine. my problem is that i've installed a new rebuild kit in the pressure pump assembly, and now, when i reinstall the assembly back on the engine, i cant even pull start the engine over. its too tight! when i loosen back on the pump assembly, i'm able to pull the engine over. what have i installed wrong from the rebuild kit??


The pump is correctly oiled and lined up on the camshaft, correct? ... Karcher 2500 PSI Pressure Washer

I cant pull the cord in my pressure washer it feels like it stuck thiere is no pressure in it it wont pull


Take the sparkplug out and see if you can pull the cord then. If fuel comes out of the sparkplug hole the carburetor is leaking gasoline in to the engine filling up the cylinder causing the lockup. The carb has to be rebuilt. Another problem mice lik ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

I cant start my power washer. the pull start is locked and wont release to start engine.


When the pull start gets locked, you have to release water pressure from the wand. I had the same problem last year. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

When i pull to start my pressure washer the cord pulls back an nearly ripps my arm off why?


... Pressure Washers

Husky 2600 pressure washer--pull cord locks up


... Honda Pressure Washers

Craftsman Pressure Washer 2.7 GPM 3000 PSI. Stopped working, found no oil, added oil now washer will not start, can't even pull the cord. Help


... Pressure Washers

I have a Husky 2600 PSI pressure washer. Started up and used for about 20 minutes - turned off to take around back and now the pull cord is tight and has a clicking sound when trying to pull. Has oil and fresh gas. Suggestions?


... Karcher Pressure Washers

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

Start problems The 1st time I tried to start my Honda 2400 pressure washer the pull cord came all the way out with no resistance and it wouldn't recoil. I took it to a repair shop and they said atyhe engine was shot due to a broken piston. How could this have happened and is a new engine the only fix?


... Honda Pressure Washers

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

Honda engine turns 3/4 then locks up under pressure? Cant pull start. Tried without pull rope, and same thing? Is this a valve stuck? How much for repair?


... Honda Pressure Washer PSI 3000

Honda gcv160 pressure washer won't turn over. pull cord just starts to move then STOPS hard.


... Honda Pressure Washer PSI 3000

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

Can'r pull the cord on my pressure washer. it seems to be ceased.


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1150 seconds