Having problems with your Pressure Washers ?

Fluid in reservoir not coming through when jet washing

\015 When jet washing with my Mac Allister 360PWA the fluid in the reservoir is not coming through. I have mislaid the instruction book.\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fluid in reservoir not coming through when jet washing


... Pressure Washers

The dishes come out dirtier after they're "washed"! The soap leaves a filmy residue and I have to re-wash all the dishes. I've tried liquid Cascade, the Finish tablets, and putting Jet Dry rinse aid in the allotted spot. Help!


Take out the botton dish rack and check the drain. Most likely there is a screen that is supposed to catch big debris and keep it from entering the drain. It's probably got a lot of gunck in it. Take the screen out and clean it and check under the sc ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Dishwashers My dishes come out of the dishwasher, which what feels like crumbs on them. Inside of glasses are that way also. I have to re-wash by hand after soaking in hot water to remove this. We use the Jet Dry and Ultra Jet Dry always, and usually use liquid cascade. Is there something wrong somewhere.


What you are likely seeing is the solids from household soap products. Household soap has too many "fillers", and doesn't dissolve fast enough for a 4 minute cycle. \015\012\015\012If you look into the bottom of your wash tank, I expect y ... Hobart AM14-253 Free-standing Dishwasher

I have a Karcher 110 pressure washer and when switched on to jet wash the water is coming out of the handle and just trickling out of the jet nozzle please can you help. Thankyou Brian Hills


Which part of the handle is water leaking from? It could be that the hose connection into the gun is not fitted properly. Otherwise it could be that you just need to replace the handle. ... Pressure Washers

I just installed a new Whirlpool dishwasher (model DU1301XTV) and have run three loads. Each time, the glasses, silverware, and plastic, come out with white, chalky residue. There are also water spots. I have tried it with both Cascade detergent, and with a Quantum Finish tablet. I have also filled the reservoir with Jet Dry. Do I have a defective dishwasher? Do I have a clogged line?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the water\015\012temperature by using a thermometer inside the dishwasher to measure ... Dishwashers

MAYTAG JET CLEAN DISHWASHER MODEL # MDB7100AWB, WILL NOT RUN THROUGH CLEANING CYCLES, TRICKLES WATER UP FRONT DRAINS VERY BRIEFLY, REPEATS THIS FOR A PERIOD NEVER KICKS INTO THE WASH CYCLE, THEN COMES UP BLINKING CLEAN/FINISHED?


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not toopen. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Maytag MDB7100AWB Dishwasher

When my Kenmore 665 dishwasher is done with the cycle, the glasses on the outer areas of the top rack have stuff stuck to them. Almost like the jet spray is clogged and spraying the garbage. My "repairman" has taken apart and cleaned everything he could. The problem was solved for a few washes, but then the particles continued to come back. Any suggestion>


... Kenmore 15129 Built-in Dishwasher

Zanussi dw927 not filling inlet valve changed,supply to machine ok, calls for water solinoid activates for about 30secs shuts off and machine does no more. cleaned out two blue plastic pipes situated under a plastic cover which were both blocked, and put a hose jet wash thru where they were situated to clean housing out, put blue channels back still not filling up and now the inlet solinoid wont switch off when when it should and programme advances heater now comes on with no water in.manually


... Dishwashers

Kenmore ultra wash quiet guard standard. Very little pressure coming out of the jets. Doesn't clean the dishes.


Sounds like hard water is the problem and may have clogged the jets. clean it out really well and get the dishwasher filtration system from www.dishwasherfilter.com. that ... Dishwashers

I have a lDL40S dishwasher. but when i put it on no water is coming from the jet wash and a green button keep flashing, all though it sounds like it working


... Indesit Dishwashers

I have model 1597, kenmore ultra wash dishwasher. I used turbo jet dry in it and now the glasses are not coming clean on the top shelf


... Kenmore Dishwashers

Maytag Quiet Series 100 fills up but washing cycle doesn't start. It drains the water and all but no water comes out from the jets. I can hear the electric motor trying to start, but it automatically shuts on its own.


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

I have white crusties with black spots in all along the seal on inside of door, and along filter on top left side of door (inside). and also i use jet dry and my glasses and dishes are coming out cloudy looking. also i have to fill the rinse agent every wash instead of monthly. Is there any special cleaning that needs to be done to this?


Problem is your water. that is from the calcium in the water. go to www.dishwasherfilter.com and get the filter system . it will make your dishes sparkle and help clean out ... Whirlpool GU2400XTP Built-in Dishwasher

I have a Bosch dishwasher model SHE4AP02UC/06, serial number FD901102579 that has been used twice since installation. When I select the Regular Wash cycle, the Regular Wash LED and the Active LED come on. The machine washes the dishes and then when it stops making noise. At that point the Active LED goes off and the Clean LED comes on with the Regular Wash LED. These LED's do not go off. There is no signal saying that the dishwasher is finished. Is this the way it is supposed to be operating or


Ya id say until u open the door after it has washed ... Bosch Dishwashers

Rinse only light is on and all of the wash rinse sanitize clean buttons come on and flash when you try to start it, if you change the setting to normal or heavy duty the wash light comes on then the rinse only light comes on and all above mentioned buttons flash until the tub is drained.


Hi\015\012 \015\012Try and reset the dishwasher by unplugging it for 5-10 minutes. Now check if you are still getting the same error you can try and press the following buttons to reset it-- \015\012Saini Rinse, He ... Dishwashers

Kenmore Elite Stainless Steel 24 inch tall Model 66577963K701. The heating element works for "heated dry" but not for "Hi Temperature" wash. It used to do so and when I opened the door a nice blast of steam would come out. My hot water tank is a great distance from the washer so we usually run the hot water tap in the sink for a bit until hot water comes... but the heating coil no longer kicks in on any of the cycles (Smart Wash / Normal Wash ). The high limit switch works and as I said, th


... Kenmore Dishwashers

I have videocon washing washing, the water is not coming out of bath, it will come too slow


... LG Washer Wasing Machine Thermistor 6322fr2046c

Machine switched on to wash cycle.pre wash comes on but no water comes out


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Water not coming into unit at beginning of wash cycle


Hi,\015\012Here is a tip that I wrote about that problem...\015\012\015\012http://www.fixya.com/support/r4021363-dishwasher_ ... Bosch 24 in. SHU43 Built-in Dishwasher

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers

Hi my nearly 9yr old neff S5555 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Thanks Su


... Dishwashers

The touchpad buttons no longer work to select a wash cycle. When I push "Start" the light above "Smart Wash" comes on and the dishwasher operates normally, but I cannot select any other cycles and the light only comes on after pressing "Start", not before. Also, the Options buttons seem to work normally but the delay button doesn't scroll through 2-4-6, it only toggles the light on and off above "4". The item is 15 months old. Thank you.


... Kenmore 13743 Staimless Steel Built-in Dishwasher

Control Panel is stuck in Pots and Pans. Sometimes I have to hit the start button several times for it to work. When it does start washing the lights that come on are non sensical to the cycle. The drying light comes on immediately but I know it is washing.


It would be helpful to have the make and the full model number of the dishwasher.\015\012\015\012Looks like a problem with the keypad. Moisture etc. Might be as simple as opening up and running a hair dryer or could invovle a replacement. ... Dishwashers

The spray arm, above the top rack, keeps unscrewing during the wash cycle. Just the arm comes off leaving a round plastic part attached to the top. This can be unscrewed and inside is a white 'washer'. The arm can be clipped back but comes off again in the next wash. The plastic 'washer' has to be turned over to allow re-attachment. Is a washer missing from inside?


Could the arm be mounted upside down and rotating the wrong way? Just an idea... Some of these can fit either way and the retainer will fit either side of the arm. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Cranky dishwasher I have to admit my wife's solution is the only one that works. Our ten-year-old Superba built-in usually starts a normal cycle part-way through, at the wash part, without filling or opening the dispenser door. Therefore the dishes come out with the soil now baked on. Closing the door, selecting normal and start results in a pump-out sound, or at least just the pump running to wash the dishes. The dishwasher ignores any cancel button push,and the light does not come on over t


You want to make sure that the dishwasher is level and secure first of all. Then I would look into the door latch assy. Sounds to me that you are not making all the latch switches when closing normally. When you are slamming it, you are making the s ... KitchenAid KUDS24SE Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1145 seconds