Having problems with your Pressure Washers ?

Craftsman 70 hp Gas Pressure Washer 580752600 dies

\015 Normal 0 MicrosoftInternetExplorer4 \015\012 /* Style Definitions */ table.MsoNormalTable\011{mso-style-name:''Table Normal'';\011mso-tstyle-rowband-size:0;\011mso-tstyle-colband-size:0;\011mso-style-noshow:yes;\011mso-style-parent:'''';\011mso-padding-alt:0in 5.4pt 0in 5.4pt;\011mso-para-margin:0in;\011mso-para-margin-bottom:.0001pt;\011mso-pagination:widow-orphan;\011font-size:10.0pt;\011font-family:''Times New Roman'';}Hi All,I start my Craftsman 70 hp Gas Pressure Washer 580752600 after hooking up thewater supply and spray nozzle and immediately after squeezing the trigger theengine shuts down. What causes that to happen?Best Regards,Charlie\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Craftsman 70 hp Gas Pressure Washer 580752600 dies


... Pressure Washers

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

My pressure washer starts, runs for 3 minutes or so, then dies, won't start for about 10 minutes. Then starts again, dies, starts, dies... Bad gas?


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

My pressure washer starts runs for 3 minutes or so then dies won't start for about 10 minutes. Then starts again dies starts dies... Bad gas?


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Craftsman pressure washer


... Pressure Washers

Northstar pressure washer starts and then dies when I give it gas


You may have a restricted carburetor?? ... Northstar Pressure Washers

Oil to gas mixture for a craftsman 3.75 hp pressure washer


There is universal 2 cycle oil available (pro-mix at Lowe's for example) that is good for all ratios from 16:1 to 50:1. With this oil you add the same amount of oil to the gas independent of ratio required. One gas can, no ratio worries. Hop ... Briggs & Stratton Pressure Washers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Hello, I have a couple year old brigs and strattion upright pressure washer. It has always ran great untill recently. It will run for a acouple minutes before dying, like it is starving for fuel. i give it a couple of minutes, it starts right back up and again dies after a couple minutes of use... I have takin the float bowl and float off and cleand the gas tank and fuel line. everything seems to be in order. Do you have any ideas what it could be? I have not tuched the top side of the carb sinc


Check the oil level in the engine itself. Verify that your oil reservoir is full, then try again.You may also want to refer to the owners manual for other trouble shooting tips. Click this link to go to your manual.http://www. ... Briggs & Stratton Gas Pressure Washer 20244

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Craftsman pressure washer 580752251 kicks, but won't start


... Pressure Washers

How to replace pull cord on a craftsman gas pressure washer


... Craftsman 2700 Max Psi Pressure Washer 23 Max Gpm

Have a honda 5.0 hp engine on a pressure washer model belive is a de 1504 not sure of make, starts if you use starting fluid but then dies, getting gas to the bowl at botttom of carb but not to carburator


Hi there mburns44 i believe your problem is either that either the Air/Fuel mixture is too rich and causing it to flood or you have clogged jets. carburators are tricky and often times need to be cleaned or adjusted by a professional. I hope that thi ... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Craftsman gas powered pressure washer kills motor when you release wand trigger.


The unloader/bypass valve is jamming or defective. When you are not pressing the button the water is directed through the unloader valve/check valve to recirculate.It is common for them to corrode or for the spring to break.If it has an adjustment sc ... Pressure Washers

Husky Model HU80833 Pressure Washer. Just took it out of the box, starts right up runs about 1-2 minutes washing then dies. I checked the oil, and made sure it has fresh gas. Help


Send it back under warranty ... Pressure Washers

Hello, I have a Craftsman Clean N Carry® 2150 psi Gas Pressure Washer w/4.0 hp Briggs and Stratton Engine. My problem is that I can't get any water to come out of the nozzel. What can I check to fix the problem? Also, where can I get a book to look at for parts and problems?


... Pressure Washers

I have a craftsman pressure washer. it sat for a year but it did start and it ran fine. then my sister borrowed it and it started but while it was running she tipped it to move it to another location and it just stopped. i've checked all fluid levels, gas, etc. and are ok . i can't start it. is there a safety breaker/fuse that automatically shuts it down and has to be reset?


... Karcher 2500 PSI Pressure Washer

WHAT WILL HAPPEN TO A CRAFTSMAN GAS POWERED 2500 PSI PRESSURE WASHER IF SOMEONE RUNS DIESEL THROUGH IT AS A DETERGENT OR DE-GREASER? WILL THIS RUIN THE SEALS IN THE PUMP? OR CAN THIS PROBLEM BE REVERSED WITH A FULL TAKE APART AND CLEAN UP OF ALL PARTS?


If you want to run a very small amount through the engine to help clean carbon deposits I would say that was fine as long as you only used 1-2 ounces to the gallon. But if you want to run diesel through the pump itself I would not recommend this. ... Pressure Washers

Gas is leaking into the oil tank on a craftsman pressure washer. it will do this while it is running or sitting in storeage. it has a briggs and stratton intek engine.


... Karcher 2500 PSI Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

My gas powered pressure washer starts up then dies right back out..is there something I need to do after starting it


... Briggs & Stratton Gas Pressure Washer 20244

I am looking for a service manual for a gas powered craftsman pressure washer 2000 psi 3.75 hp. Cant seem to hook it up correctly


If you have the product model number (located on the tag on the unit) you can follow the attached link and enter in your pressure washer model and then look to the right side of the page and click on the "manual" button to get a copy of the manual yo ... Briggs & Stratton Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0945 seconds