Having problems with your Pressure Washers ?

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Answers :

Look for plugged filter anywhere in fuel line.
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Look for plugged filter anywhere in fuel line. ... Pressure Washers

8 hp honda on cement mixer starts on first pull but shuts down as if it is running out of gas. I put fresh gas in it and cleaned the filter and bowl of the carb.


If it has a fuel filter. check that. change the spark plugs. ... Honda Pressure Washers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

I purchased my KARCHER G2500VH last summer. I used it one time for about an hour. I tried to start it today, seems like its not getting gas. I checked the gasline to make sure gas was flowing. I removed the sparkplug, poured a little gas into the engine through the plug hole. Replaced the plug, pulled the rope and it started for about two seconds. I also poured fresh gas in tank. Cannot get to start.


Have tried to start our BlackMax 2700psi pressure washer, it is not getting gas to the carburetor, what to do? ... Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have an Asko D3230 which has activated what is probably the overfilling protection and the pump continues to run. The overfill activated because we had to pull out the machine to get to something and when putting back in there was a kink in the hose. Then we ran a cycle and the water wouldn't drain out. There is now no kink and we have removed all the water we can find. It is now completely empty but the pump continues to run even when the dishwasher is switched off, e.g. the off switch an


... Dishwashers

I have a Honda 5.5 hp pressure washer and it wont keep running I bought it off craigs list they said the last time it ran was almost a year ago I took off the carb and sprayed carb cleaner threwout but didn make a difference I cant seem to see any jets juist the float needle and that was clean if I pour gas in the carb it will run for a for about 5 seconds and but wont stay even if I choike it. does anyone have a answer


Try soaking the carb for 15 minutes in gasoline. If you have a plugged port just sparying may not be enough to clean it ... Honda 2500 PSI Gas Pressure Washer

I cannot pull the rope on my gas pressure washer locked up, do all the hoses have to be hooked up and water running for the rope to pull


The engine might have failed unbolt the pump and see if its the pump that locked up or the engine ... Briggs & Stratton Gas Pressure Washer 20244

Carburator is gummed up I can remove the carburator but after that im lost I removed the screw from the bottom of the cup drained the old gas shot some carb cleaner in there opened the gas line put the screw back in numerous times wont start regapped the spark plug and cleaned it won't start only has been used about five hours my buddy didn,t run the old gas out of it two years ago before winter it's a type 5 manual choke/fixed throttle


... Karcher 2500 PSI Pressure Washer

I have an excell xr2600 pressure washer and i cant get it to stay running. I put a little gas in the air filter box and it runs for a second. Can you help me out please


... Honda Pressure Washers

MSV3024 pressure washer backfired after 2 hours of continuous use, then died. i was able to restart it but pulling the trigger kills the engine. i was able to pull the trigger rapidly and keep it running but holding the trigger down killed it again. now it won't restart. can it overheat? it has a full tank of gas.


... Simpson Pressure Washers

Pressure washer will not stay running. Have put in new fuel, new plug, new oil. Will not start until I spray some ether in carb, then it will start and run for about 3 seconds, then stall. will not restart without another shot of ether. What should I try next? thanks


... Briggs & Stratton Gas Pressure Washer 20244

My Bosh Model# SHE4AM02UC/01 Is not cycling. Started with the soap dispenser not opening, progressed to the drain pump not staying on. When you turn it on, the pump runs for 2 seconds. water solenoid opens for another two seconds, and then the "clean" light comes on. If I go to quick wash, or to pot scrubber it might do a regular cycle. I did pull the pump to remove a piece of glass before this all started, but can't imagine that would be the cause.


... Bosch SHE4AM02UC 24 in. Built-in Dishwasher

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Engine will not turn-over. It is a Honda 11 HP, OHV on a Karcher Pressure Washer. It was running fine for about 45 minutes. All of a sudden it stopped. When I tried to start it again, the engine is bound up so that the pull rope will not pull out at all. It has plenty of gas. The crank case is full of oil, not over full.


Pull the spart plug out and see if you can pull it. Sometimes the carb will flood the engine to a point that they get hydrolic lock.If it does free up then I suggest cleaning the carburator before trying to start it again.If it does not free up the y ... Karcher 2500 PSI Pressure Washer

Motor has been sitting for a while changed out old gas put new in drained carb bowl put new spark plug wont stay running


Here is the long answer with everything we learned while using a power washer twice a week for years::It sounds like could be one of the problems listed below or a combination of those things.1) The exhaust is partially blocked. Che ... Pressure Washers

This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!


It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

I have a GE monogram zbd5900 that continues to drain, won't shut off. The drain pump just runs. None of the lights on the control panel will come on, tried pressing and holding buttons to clear, nothing. Turned off and on circuit breaker (even left it off overnight) and did not change. Drain is not blocked, pulled the unit out and put water in the bottom and it pumped the water out just fine. any thoughts?


See if you can access the tech sheet, should be on the right side of the underside of the unit after you remove the toe panel, or perhaps in the console. Almost sounds like a stuck key pad but the tech sheet might shed more information on this malf ... Dishwashers

It wont start...i have only used it once in 1.5yrs...just put in new oil and gas...I give it a pull but does not ignite.


... Karcher 2500 PSI Pressure Washer

I have a Ryobi power washer, model #RY30080. I ran it for a long time yesterday, running it out of fuel. This morning, after refilling the gas, I am unable to start it. The starter rope is very difficult to pull, like it is binding. I followed the correct starting procedure. Can you help me?


It is more likely the pump seized up... or you are experiencing combustion lock.\015\012Remove the sparkplug(s) and pull the cable a few times.\015\012If the motor turns normally - clean the plug or replace it.\015\012If the motor s ... Pressure Washers

Engine wont stay running unless i put my hand over carb then it stay runnin cleaned carb gas is flowing fine engine is on a morta mixer


Hi and welcome to FixYa. I am Kelly. \015\012When you said you cleaned the carb did your remove the float bowl? Here is what you need to do: \015\012\015\0121. Fuel selector off\015\0122. Remove float bowl mounting s ... Honda 8 HP Engine

Pressure washer has been sitting up for about 2 years.. worked perfectly before I parked it.. lol.. But, I put a new spark plug on, cleaned the filter, sprayed carb cleaner in it drained the gas tank and added new gas.. But it still does the same thing.. It starts in the choke position, runs awhile, and then shuts off. While its running, I tried to put the switch in the run position and it kills. Just wanted to see what an expert would say about the matter before I Brake it down. thanks


... Briggs and Stratton 020275 Elite Series 3400 PSI Portable Gas Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1481 seconds