Having problems with your Pressure Washers ?

Motor was running low on oil. Added oil and now it runs but has a poping noise when running.


Answers :

Make sure you did not overfill the oil.
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Motor was running low on oil. Added oil and now it runs but has a poping noise when running.


Make sure you did not overfill the oil. ... Pressure Washers

I have the John Deer 3800 psi from lowes. The machine is in great running order it just seems to be losing psi as I use it. Also checking the oil in the Honda 13hp motor and in the pump. Do you take the dipstick out and then insert it Not screw it back in to check the oil? The motor has 2 places for oil 1 on each side?


Thread the dip stip back in to get a true reading of the oil level. Either oil filler may be used to top off the crank case. There is only one crank case - the oil on one side is the same oil seen in the other filler. ... Briggs & Stratton Pressure Washers

What oil does my troybuilt pressure wash use, its 4.5 hp unleaded gas 4500 psi? it just stalled while i was using it looked like oil was low, i have no manual and there was no info on unit so i added 10w-30 regular motor oil now engine wont start?


There is no way that a 4.5 hp engine can create 4500 psi. If you are putting the oil into the engine it would just take a 10w30 motor oil, if you are putting oil into the pump I would have to know what pump kind of pump you have, if the name isn't on ... Briggs & Stratton Pressure Washers

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

Motor runs constantly with low pressure.


What you described I would think that it a switch problem, I would go to Karcher.com and order an original part for this and start over with the electrical portion and then go from there. ... Karcher K2.26 Electric Power Washer

Motor noise it fills with water, then the motor seems to make a noise instead of work. dishes are still dirty if we let it run.


It could be something caught in motor empeller IE. a bit of glass, or motor could be faulty ... Admiral 24 in. DDB1501AWW Free-Standing Dishwasher

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

My KitchenAid Kudd230bwho started rattling today. We have not had any problem up until now. I took the cover off the front and the noise is consistent with the motor. When the motor runs the noise can be heard. I checked the drain inside visually and did not see any cause or obstruction. What do I do next? Any suggestions?


... KitchenAid Dishwashers

Motor will start on choke setting and then it immediately dies when moving the choke lever to the run position. Cleaned carb, new plug new air cleaner and checked all linkages. the motor has new oil and runs rough on choke like it should. any help


You say you cleaned the carb. If you did that by spraying cleaner in through the choke, that's good, but it doesn't get to the root of the problem. The problem is getting the gas into the carb. Try this. drain the gas. Put a small amount of c ... Honda Pressure Washers

I have GE GSD2300r00bb, it was working just fine the other day no unusual noise, today we tried to run it, just a little bit into the cycle, i heard a strange stalling noise that sound like the motor is stuck or something, i put a camera(in a ziplock bag) in the dishwasher to see if the blade is spinning, no spin, the water did squirt for about 1 sec then stop but still leaking out somewater. Is it the motor or the water pump. I just got this dishwasher about 1.5 yrs. Is this something i can fix


... GE GSD2300RBB Builtin Dishwasher

The dishwasher is making a horrible noise. Could it be the motor? Tried running both drawers and same noise each time. About how much would it cost to replace motors? Would I be better off getting a new dishwasher?


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

The same problem as everyone else with the motor continuous running, but it keeps happening about every 5 months. Know I have done the normal procedure it is making a fairly loud noise while running.


... Asko 24 in. D3112 Free-Standing Dishwasher

Have a PD2800 that has started to leak oil. lowered the oil level slightly but it started to again leak oil after just a minute or two of running from a cold start. Oil seems to be coming either from around the oil drain plug or from underneath the motor mounting plate. any ideas? Richard


Hi,There is a nice Troubleshoot article :-http://www.the-power-washer-advisor.com/pressure-washer-pump-repair.htmlHope i helped you.Thanks for using "Fixya". ... Dewalt Pressure Washers

KUDK01ILBS5), SN: FR2702809. Have used this machine 6 years and just recently experienced noise that I eventually traced down to a bad recirculation pump bearing that failed due to a small leak in the shaft seal. Installed a new pump on Friday, 4/21/10 and that particular noise is now quieted. While the bearing noise was gone, there remains a pumped water noise that is quieted by manually adding about 1/2 gallon of water within the machine. So I now believe the water level is low, possib


The water level in the machine should be slightly under the heat element. The float you refer to is only for overfill and should not be activated if the machine is filling properly (the water level should be lower than the float switch activation poi ... Dishwashers

Loud whinning noise when motor is running


Standby for a while i'll sent you how ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Won't start After two months of no use my dishwasher won't work. I can hear motor running but no water. We tried cleaning by filling with water (priming motor) but nothing happens. Now the dishwasher if full with water, motor makes noise but nothing is happening. Help!!


It sounds like you have a food blockage or some blockage between where the water fills up and where it goes into the pump you need to take out the water wand (the rotating thing with water coming out) only the bottom one. You need to unscrew the wate ... Hotpoint 24 in. HDA1000Z Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

I have a Coleman powermate clean machine pressure washer 2500 psi 2.36gpm and has a 6x200 honda 6.5 horse motor. I just bought at a garage sale.It started just fine when I got home and in less that 2 minutes quit. It says the engine will stop automatically when low on oil. what kind of oil should I use and for the pump what kind of oil do you use?


... Coleman Pressure Washer PW0881800

Low on oil quit running filled with oil will not start back is


Is it electric start? if so take the battery cables off the battery and hold them together for a few seconds. ... Honda 8 HP Engine

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

Does the honda karcher G7.10 have an oil sensor which can stop engine for running if low oil? thanks


... Karcher 2500 PSI Pressure Washer

I have a northstar model 1577501-A motor runs great pump will not generate pressure and makes a nasty noise. I have removed the pump from the motor it looks just fine how do I get repair advice? maybe the valve body is messed up


... Northstar Pressure Washers

I have a north star 5000 psi and I have low pressure it has what looks like a presure relief on the side bottom and it lets alot of water out when motor is not started and a hole lot when running presure gauge only reads about 600 psi when running Thanks in Advance [email protected]


It is possible that your pressure relief valve is on it's last legs. Call the company at 800-221-0516 and get another one. You may still have warranty protection so ask them about that when u call. J. ... Northstar Pressure Washers

My kitchenaid KUDI01DL dishwasher began making a lot of noise while running, then subsequently decided not to circulate the water around to wash the dishes. It sounds like the motor is running (maybe) but there is no washing action going on. The machine will fill, drain and heat the water but nothing else. Is it likely that the pump/motor assembly has ceased to function properly? thanks...


The problem is very likely in the chopper and/or somewhat possible in the impeller. The chopper is replaceable from the front. Disassemble the pump, the chopper will be on its left side under a cover. That cover is kinda tricky to remove (remove all ... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1207 seconds