Having problems with your Pressure Washers ?

What is the valve clearance on 5 hp engine mod 12H802-2349-B1 I"m installing a new valve seat on the intake the old one just came lose and fell out there is zero on the exhuast side, I'm at 18 thousands right now for intake


Answers :

Hi

valve clearance(cold)
intake 0.005 to 0.007inch
exhaus 0.007 to 0.009inch

bye
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What is the valve clearance on 5 hp engine mod 12H802-2349-B1 I"m installing a new valve seat on the intake the old one just came lose and fell out there is zero on the exhuast side, I'm at 18 thousands right now for intake


Hivalve clearance(cold)intake 0.005 to 0.007inchexhaus 0.007 to 0.009inchbye ... Pressure Washers

My Miele G2430 dishwasher stops right after draining in the first minute or so after starting, and the intake and drain light comes on. The solenoid at the end of the intake hose then clicks and the light begins to flash. I applied suction to the intake hose to determine if the solenoid is working, and the valve does open and close. There has been no error code displayed. I cleaned all of the parts and filters referred to in the owner manual.


For a drainage fault heres what the miele service manual says for your machine\015\012Water present in appliance and is not being drained off. The display shows Drain fault F11. The buzzer is activated for 2 minutes. ... Miele Optima G2430SCi Stainless Steel Built-in Dishwasher

By the time I recieved info, I'd already removed the intake valve, removed some debris from the screen, and was ready to test the movement of the solinoid valve. Right now,I can blow a little air thru either end while applying AC, and it stops tight w/o AC. If this is normal, I'll reasemble the unit. At least I was able to vacuum much insulation that a resident mouse had deposited on the floor years ago.


... Bosch 24 in. SMU70 Built-in Dishwasher

4hp briggs and strat,quattro 1500psi leaks water out of unloader valve,right after turning on garden hose,and shoots out the detergent pick up tube? motor runs like a champ,pump seems to be working just losing the pressure at un/valve???


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Miele G892 SC dishwasher. When I start the cycle, it drains (except for a bit of water left below the triple filter). After that, the intake valve opens and water enters. It then does nothing for a period of time until the "intake/drain" indicator light starts flashing. When I open the unit, I find about 1/2in of water in the tub (above the tripe filter). I have 1. cleaned the intake valve filter (no blockage found) 2. Inspected the drain line at the base of the unit as well as t


The pump is running due to the float switch or the float itself either being stuck open or broken and showing a fault this is why you have water going in to a certain point but not the point required for washing the dishes and then due to the float s ... Miele Dishwashers

Water does not enter through the intake valve. No voltage at intake connector. Bench test OK, valve opens when AC110 connected to terminals.


... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Intake drain The dishwasher is an excellent machine but the intake drain problem is driving us crazy. I have had pumps changed twice and that has not been the problem. I start the dishwash and within a minute the intake drain light comes on right after the first cycle. I need help!!


... Miele 24 in. Touchtronic Platinum Built-in Dishwasher

Model 01902 2350 psi . engine runs fine , sprays out nozzle but lower pressure and water sprays out plastic elbow on relief valve , that is supose to **** in soap if used , cant hold finger over spray from elbow , high pressure , took apart relief valve and plastic valves all orings are ok , brass pump seals look ok , all back together , still blows out elbow . ?? plastic spools were out by somebody else , not sure if they are in right , cant find picture to compare .


It sounds as if the non return valve in the elbow is the wrong way around .The o-ring normally goes in first then the ball then the spring. Try it and good luck. ... Pressure Washers

Hey guys, I am a dishwasher repair guy in barbados, the caribbean. I am having problems with a Hobart LX30H. the relay board is doing half the things right and the othrs not at all. I replaced it with a new one and the same results. At startup, the wash sump heater and wash motor are running, but the fill valve, drain valve and rinse booster are not running. Hence the startup operation is stalled. the funny thing is that the rinse booster and fill valve led's on the relay board light up at


Not sure what sort of problems (fault codes etc) you were having before you chose to go on the path of replacing the relay board.\015\012\015\012It might help to know what fault codes you have been noticing.\015\012\015\012One ... Dishwashers

No water intake, replaced water intake valve yesterday, six washes later no water intake


Ok, Just to make sure that the culprit inst the water valve, once more, simply follow the test procedure below.To access the inlet valve remove the lower panel located beneath the door. The panel is usually held in place with two screws e ... Dishwashers

Miele intake valve


Dishwasher Not Leveled\012 \012 \012 This is a very common reason for a leaking dishwasher especially\012 if this was a new installation. The framing in a dishwasher is made up \012of mostly thin sheet metal, so ... Miele Dishwashers

Why is my OXO food scale not providing the right weight after I zero out the bowl and adding an ingredient in the bowl?


... Oxo Good Grips 11-pound Digital Kitchen Scale with Pull-Out Display

Unit won't pump out, checked the lower impeller and it was very loose, is there a drain valve on this unit? Model 587.14249991 The upper impeller is a fixed unit right to the motor but it appears the lower impeller is a push fit over a rubber sleeve. I only saewa check valve in the drain hose, is there any thing else I should check? hose is clear and the switch for the float is working ok.


At the bottom of the unit where the hose goes is a check valve. check to see if clogged. ... Dishwashers

Water valve what does the water valve do? and where is it located? would it cause water to empty out right away also? it doesn't seem to fill up enough... thanks tanner...


The water valve, or water inlet valve is what lets water in the dishwasher. If it is filling and emptying at the same time, that is a different situation, and is most likely the drain solenoid. Take the bottom panel off the dishwasher and take a pe ... Dishwashers

Kenmore dishwasher 587.15163401 won't fill. I checked the float switch with my multimeter and it's working properly. It's registering zero when I touch the terminals and 1 when I activate the switch. On this particular washer, how do I access the water inlet valve to check it for debris and also to check the solenoids? Also on this particular washer, how do I access the drain valve and solenoid. Can you tell me if this is a single direction motor or reversing motor. As I understand


The problem was the water fill valve. When set to Ohms, the multimeter never would read zero indicating a problem with the water fill valve. I replaced the part and it works now. Be sure to turn your water off under the sink before taking it off t ... Dishwashers

RepGetting error drain intake Have replaced the Drain Intake Valve


You did not post the make and model. ... Dishwashers

ASKO 1595 daer greendude, indeed your troubleshooting was right!!!! i pulled out the dishwasher and the base was full of water. once i got water out, the fault sign went away and it's ready to run its normal cycle. now i need to figure out where the leak comes from: either the fitting or the valve itself. just in case i have to replace the valve: any good source to get it from? i live in california. once again, thank you much!!! i'll keep you posted on the developments


I live in australia our part no is 8052120 ... Asko D1776 Stainless Steel Built-in Dishwasher

My Whirlpool Gold Series 980 dishwater no longer fills up with enough water to drive the washing arms, so the dishes do not come out clean. I cleaned the filter on the water intake valve (which was really clogged) and it still did the same thing. Replaced the inlet valve and still no change. The water does not reach the level of the overfill float switch, so that’s not it. Its been working fine for 4-5 years, what else could it be? Thank you.


I hve provided u with all details .read it carefully .it has all the resolutions for all possibilities ... Whirlpool Dishwashers

The overflow air drain on top of the sink that is connected to two hoses under the sink is leaking. It leaks out the top onto the counter. I took it abart but am afriad I did not put it back together right. There is a rubber ring that I think must be for sealing and I put it directly on the counter and then screwed down the air valve over this and water s coming out of the air flow valve and all over the counter.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

6.5 hp briggs on power washer, the intake valve is opening on the up stroke of the piston and like wise with the exhaust valve opens on the up stroke, engine will not start


... Briggs & Stratton 020272 Elite Series Portable Gas Pressure Washer

Bought suction hose for karcher in order to use water from bucket. Have attached hose but there is no water being sucked from the bucket . One side of hose attached to washer the other dropped in bucket is this right? The end in the bucket has no suction, and a depressable valve that seems to be impeding the water suction. Do I remove this valve ?


... Karcher 26408500 Pressure Washer 25Foot ExtensionReplacement Hose

Bosch shu9915uc dishwasher when turned on sounds like drain pump is running but water will not enter dishwasher. When opened the pump sound stops. I did have a plumber over right before this occurred to replace kitchen sink faucet but he said he did not shut off valve to dishwasher and valve IS open.


Hello, \015\012 \015\012Welcome to FixYa.\015\012 \015\012 ... Bosch SHU9915UC Dishwasher

Leaking intake valve on frigidaire ultraquiet III, model: FDB750RCC1


Hello Dan Wetmore - Do you notice if the dishwasher have deflectors installed in the bottom left and right corners of the tub gasket channel? If so, confirmed that they are properly installed and present. In case that it is not, t ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Replacing intake valve on Miele dishwasher


... Miele Dishwashers

Miele, G892, Intake Valve


... Miele Touchtronic G892 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0356 seconds