Having problems with your Pressure Washers ?

ModleHDS 3.5/30 P Cage - 1.575-551.0

\015 Modle HDS 3.5/30 P Cage - 1.575-551.0 \015\012Q: I have Pressure for a short while then (nothing) I have used the Trobleshooting Chart in my Operators Manual but it has no listing for this Problem.\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

I have an Arthur Martin ASF 2655 and the timer continues to turn from 0 to 1 to 2...... how do i reinitialise it


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

Indesit di620 dishwasher. after normal cycle request (2) on the 1-4 options the bleeping sounds and after 2 minutes both the 2 and 3 lights start to flash together. Any suggestions what the fault is? Thanks


... Dishwashers

Soap problems Not only won't the soap dissolve but there are granules on the inside of my glasses. The dishes are also not getting very clean. I have been using cascade 2 in 1 action packs for a few months now with no problem, they've been great. I ran a wash 2 days ago and when it was done, I opened it up and the dishes were still dirty and the action pack was just sitting there slightly open with detergent sitting on the bottom of the machine. I had done a wash 2 days before with no problem.


Either: 1. not enough water gets into the dishwasher. open the dishwasher 3-4 times during cycle, you should see some (quite some) water at least once, if not - check water valve, water level float and water pressure. 2. the pum ... Kenmore 24 in. 15689 Built-in Dishwasher

OE Error I'm getting an OE error which is a drainage trouble error. I checked the hose and the drain, and everything is clear. My diswhwasher runs 98% of its full cycle and usually with 2 minutes to go I get this error. I have 2 opinins as to why this is happeneing. 1. Maybe the clog is in my trash compactor, however that seems to be working fine and my sink is funning with no slow down. 2. My 2nd theory is I have to reset the progam within the dishwasher. Like how sometimes I


Had the same problem and had the pump replaced ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

3 problems: 1. lower drawer is hard to close; seems to be sticking on something. 2. lower drawer retains water (2 inches) after completing a cycle. 3. F1 fault code on both drawers with alert occurred when washers were not in use. I had to turn off the electric circuit breaker to make it stop.


Ok where to start, first thing the bottom draw is hard to close because they use 2 little motors on either side to pull a lid with a seal on it down on top of each draw when u start it to keep the water in, if its hard to close the motors are damaged ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

My Kenmore elite dishwasher 665.13793K600 has 2 problems: 1. won't drain water 2. won't even start working today Please help!


I have a Kenmore model # 665.13793K600 and it has been having a small puddle of water remaining in the bottom at the end of each cycle. I've taken it apart and cleaned it. I'm thinking I may have the drain hose incorrectly positioned or it could even ... Kenmore 24 in. 15079 Built-in Dishwasher

Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'


... Miele Optima G2470SCSF Dishwasher

My dishwasher runs 2 hours as a complete cycle. I think it is never going to finish but I have not stopped it in mid cycle. Dishes are very clean but they should when it runs this long. I hear it change cycles so I know it is not stuck on 1 cycle. It also makes a lot of noise. 2 hours of noise. HELP!!! How long it it suppose to run?


That means that the machine does not detect that one condition to continue the cycle is met.Sometimes\015\012 when this happen unesperience repairers replace the timer board , an \015\012expensive part that rarely fails. The timer b ... Whirlpool DU1055XTS Built-in Dishwasher

I have a maytag mdb6100 dishwasher with 2 problems. (1) the water does not drain and (2) food is left on the dishes after the wash cycle. I have checked the hose and there are no kinks or clogs.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

Dd601 ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the


I had the problem with the top draw not draining properly and the dishwasher showing the U3 fault code on my DD601 v.1, I did'nt have a copy of the dishwasher manual so it took the following steps, this is best done out side to save on messing your k ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

2 problems 1- dishes coated with white-ish film that won't rinse off, has to be hand washed with soap to remove. 2- heating element isn't heating up at all


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your d ... Asko D1706 Built-in Dishwasher

Hello I am trying to connect my GE GSD680 dishwasher to the drain hose but there seems to be 2 drain outlets. 1 large and 1 small. The small outlet seems to open when I depress the plunger. The larger outlet is capped with a rubber cover. Which one do I use? Thanks!


... GE 24 in. GSD2120C Built-in Dishwasher

Have a NEFF S5453XOGB built in dishwasher - put it on last night and came down this morning and nothing has been cleaned and I have 2 red lines in the time display. HAve tried resetting by holding the 2 buttons down and switching on - it shows the number 23 - as sson as I let go the lights continue to flash and the number 1 appears. I am resetting it correctly?


... Neff 24 in. S5453X1 Built-in Dishwasher

Indesit DI620 1 Switched on and programe 1 set but nothing happens. Water supply OK 2 Have taken the door panel off and there is a black and black/purple thin cable connected to the control panel in the bottom right hand corner with the other hand hanging loose. Don't know where it connects to. Any suggestions please


... Dishwashers

I have a kenmore quite guard 2 and it shuts down completely after about 1 or 2 ( compete power shut down) and then after about 4 to 5 min all the lights on the key pad keeps blinking.


... Kenmore 17342 / 17349 Built-in Dishwasher

DD601ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the s


Check for restriction in sump. ie remove rotor, push pipe cleaner or similar from filter sump into rotor sump ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I lost the manual for my dishwasher. I have two questions: (1) How does Light Wash differ in its cycle from Normal Wash? It seems it should be (but isn't) shorter. (2) When using the Light Wash cycle, should I put soap only in 1 of the cups for dispensing (leaving the pre-wash cup empty)?


\015\012We need the Model Number off the inside of the door to get you the manual please post this first so we can Help you Thanks ... Dishwashers

Kitchen Aid dishwasher Model# KUDP01FLSS. 2 problems #1 Won't run unless you press in on the door and hold it for a few minutes then it runs through cycle normally. Problem #2 It won't drain water out at the end of the cycle when I open the door there is water laying in the bottom of the tub. I have checked the drain hose for clogging and it appears normal. I am able to remove the hose from the disposal and suck the water out of the tub using a shop vac this indicates to me that the drain is ope


... Dishwashers

Hobart LXIC under counter comerical dishwasher. Delime lled keeps comeing on every time power up. Checked sensors on bottom in the water drain area senser on right (there are 2 next to each other on this unit I think other is water temp) the wire had wire burn completely off. I reconnected the wire and started to burn up the wire again. Question: 1) Is this sensor for the Delime sensor? 2) does it sond like the sensor is shorted to you? or sending wrong voltage to sensor? 3) If no


... Hobart 24 in. LXIC-5 Built-in Dishwasher

I have an Amana SofSound 1. When I raised the plastic handle to open the door, I heard a snap, something broke inside and I can't open the machine. 1. how do I open the door? 2. Once open how do I replace the inside broken workings? Thanks in advance.


... Amana Dishwashers

I have a 7 yr old GE Tritron XL dishwasher that I rarely use. Last time I used it was almost 2 months ago. A week ago I noticed a horrible rotting stench coming from the inside. I poured 1 cup of vinegar in the base and let it sit overnight. Next morning I ran the dishwasher with detergent but no dishes. Odor still there. Checked bottom of dishwasher for food - nothing there (I prewash dishes before putting them into dishwasher). Added 2 cups of vinegar, ran dishwasher on hottest setting. Sti


... Tappan MDB531RF Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0591 seconds