Having problems with your Pressure Washers ?

Water pouring out of the pump on my kew powerwash

\015 Water pouring out of the pump on my kew power washer 1502v its the large industrial type model i removed the face plate on the pump and found the 3 seals had worn badly and therfore water was being forced passed and out of the pump hence no pressre were can i get these seals\015

Answers :

Hi, You can get this seal set for a 1502v from nilfisk alto or any alto dealer.
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water pouring out of the pump on my kew powerwash


Hi, You can get this seal set for a 1502v from nilfisk alto or any alto dealer. ... Pressure Washers

Bosch SHX46A (6 years old) Selected regular cycle, pressed On and closed door. Cycle did not start normally. Pump runs, but no water is coming into the DW. I confirmed the water supply line is turned on. I opened door, turned off On/Off switch, then poured water into drain. Then turned On/Off switch on. DW began pumping water OUT of the DW. Also, it doesn't matter if the door is open or closed - if you turn the DW on, the pump will run. I suspect a problem with the electrical controls, or perha


From your description, I doubt that the problem is door latch is the cause.\015\012\015\012The first thing that a modern dishwasher does before it begins to fill with water is run the drain pump.  It appears that this DW is not progressing ... Bosch Integra® 500 SHX46A0 Dishwasher

Full model number is SGS45E08GB/56 Will pump out water if you pour it in manually. Takes in water - sometimes. Main pump runs but no water flowing out of arms. Float switch is not operated and is not defective (tested off the machine). Intake solenoid valve seems to work properly (tested off the machine). Pump continues to run even if door is opened.


... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

The machine is not taking on water but the water supply is live. The machine is pumping out water if I pour water in but does not seem to stop pumping


Check the filter at the m/c end, where the nlet water enters. Clean it. It will be a small piece. Watch and remove. ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Zanussi zdt6053 will not fill with water, on any programme, it appears to try to start and makes a moise as if pumping, but there is not water to drain, and pump appears to operate if water is poured into the machine


Check float valve. It is probably stuck. This tells yuor machine to pump the water out and keeps the water valve from opening. Often it is something small that was placed in the dishwasher and lodges under the float telling machine that it is full ... Zanussi 23 in. ZDT6252 Built-in Dishwasher

Water pours out the other end of the pump opposite the pressure hose connection. It has a clear plastic cap with a small **** in it. Looks like water should escape here but way too much water being pumped out.


... Pressure Washers

I HAVE A 2 YEAR OLD BOSCH DISHWASHER. WATER WILL NOT PUMP INTO THE MACHINE. IF I POUR WATER IN IT PUMPS RIGHT OUT. THE DOOR WILL NOT LATCH AND CAN PUSH RED DIFFERENT CYCLE BUTTONS ONE AFTER ANOTHER. YOU USE TO HAVE TO SHUT THE MACHINE OFF TO GO TO A DIFFERENT WASHING CYCLE LEE


Hello thereThere are a couple of reasons why a dishwasher will not pump water into the machine or even work once the water is in the machine i will post the possiable reasons and some troubleshooting tips for this in 2 different post's ... Dishwashers

Bosh SHU66C06 Dishwasher will not let water in. Water supply is on, timer goes through the cycles. When I manually pour water in the tub, it pumps it right out regardless of the cycle it is in.


YOUR UNIT IS STUCKIN DRAIN MODE YOU HAVE TO CLEAR THE WATER FROM THE BASE AND DE ACTIVATE THE FLOAT .you can remove the side panel an use a flshlight to see water in base. you probably have a leak in your hose. ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Asko dishwasher D5122XXL I've got the F2 light flashing. How do I reset it? Or do I have to get service people to do it? I think there's nothing wrong with the pump or drain, since I actually poured a jug of hot water in to the dishwasher. ( it's hooked up to cold water pipe)


... Asko D5122XXLS 24 in Builtin Dishwasher

The pump is working and drains the DW if you pour water into the drain. The problem is that this thing appears to be stuck in "drain" mode always pumping out not advancing through the cycle no matter where you turn the control knob to.


You probably have a stuck solenoid which routes the water either to the arms or out of the machine. It is located near the motor and routes to the drain line. Most are removable and may be disassembled for cleaning. If the control knob does not ad ... Dishwashers

Bosch SHV46C Bosch dishwasher (SHV46C13UC) doesn't "start". When I start the cycle, it makes a noise but doesn't fill with water. The drain pump is working because I poured water into the basin and watched it disappear. The noise that it's making is a constant low-toned rumble/hum. I sometimes would hear this noise at the end of a cycle when things were working fine.


Replace the fill valve that sound is it trying to open ... Bosch 24 in. SHV46C13UC Free-Standing Dishwasher

Asko D3120 I have resolved the problem of pum always running by tilting the dishwasher but now I have a new problem of the pump not draining the water in the bottom of the dishwasher. I thought it was clogged so I removed the screen and filters but did not stick my hand in the hole to clean... I used the plunger for at least 30 mins. Then I tried to pour a little CLR because I have hard water. NOTHING please help me


In the bottom where the filter are, you can see a yellow 'thing'. Remove this and stick one finger in an try to rotate the pump wing. Try to remove particals that is blocking the pump.\015\012Or there is something in the drain hose. Try to drai ... Asko 24 in. D3120 Dishwasher

We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

I have a Hotpoint FDW80 Dishwasher. The drain pump runs continuously, even though there is no water inside, I poured water in with a kettle and it does drain correctly. After a short while fault code AL01 appears. I have removed the base tray to check the "anti-flood" swithch and that is OK, even with the switch disconnected, I still get AL01. Any ideas?


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

On an AEG Favorit 64570 VI we have an error 20. Manual indicates a drainage problem, however when we pour in water, it gets pumped out without a problem. No obstructing in the exhaust tube. Next we checked the pressure sensor, by taking it out and blowing into it. It clicked as pressure was applied to it, so the inner switch worked. Everything is clean, but still we get an error 20. What does seem strange is that the appliance does not take in water. Any suggestions are welcome.


... AEG 23 in. Favorit 86070Vi Built-In Dishwasher

HI MY DISHWASHER IS NOT WORKING.IT APPEARS THAT WATER IS NOT ENTERING THE MACHINE.THE ROTARY DIAL IS STILL WORKING AND IF I POUR WATER INTO THE MACHINE THE PUMP WORKS LIKE NORMAL.THE MACHINE IS A BOSCH SGS4072AU ,THANK YOU


... Bosch 24 in. SGS4072 Free-standing Dishwasher

I have a Comet BXD 2525 G pressure washer pump which is giving me some problem. (Maybe) I hook the water up to pump and the pressure hose up to the pump, turn on the water and the water sprays out of the water connection at the pump. I check the hose to see if it was clog ok and the next was a the water connection ok. It's like the water is not going int the pump. When i start the pressure up the water come out of gun but no pump running like it should. The next thing i was going to look at i


The water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water. ... Comet Pressure Washers

Pw1700x - water pours out of the handset when trigger is either pulled in or not and the pump runs continuosly.


You need to rebuild your sprayer wand...you have an O ring out ... Pressure Washers

Fridgidaire FDB520RHS has water pouring out of the bottom onto the floor. Is there a pump inside that could be broken? We can't find a plug or clog anywhere.


... Frigidaire FDB520RHS Full Console Dishwasher with 4 Wash Cycles 4 Wash Lev

Frigidaire MDB202RBW0 hi. i bought a used frigidaire MDB202RBW0 dishwasher, and after hooking it up, it is pouring water from the smaller of the two holes coming from the side of the pump. i assume there is supposed to be a hose here? am i missing a part?


... Frigidaire Dishwashers

Hello, I have a Frigidaire FDB510, after a few minutes of running water starts pouring out of the bottom of the door.I have replaced the wiper or sweep seal at the bottom of the door, the gasket does not seem to be bad, (it actually does not wrap around the bottom of the door anyway). Am I not draining correctly i.e. float,pump, etc. I sure could use some advice. Thanks


Ckd spray arm be sure it is not binding on something also ck for possible split in spray arm look close some are almost invisable ..when water is pushed through spray arm the seam will sometimes separate..also watch for oversuds ... Frigidaire Dishwashers

When I power the Karcher 520M water pours from the handgun - there is now leak until pressure is applied. the pump does not cut out but I don't know if this is a problem with too much pressure causing the leak or too little pressure because of the leak. there does not seem to be a way to dismantle the handgun - is this correct Bill


Not too much pressure, a bad gun.Unfortunately you will have to replace the gun. About $65.00 Canadian ... Karcher 2500 PSI Pressure Washer

Model #gld5800l15cc doesn't clean dishes. doesn't seem to fill enuff before the cycle. the pump starves. for the heck of it I poured water into it manually and it worked fine. all the sparayers then had good pressure. I cleaned the inlet screen at the solenoid and its still the same. Help please!!!!!


Replace the level sensor in the tub of the washer. ... GE Dishwashers

Miele dishwasher machine running & doesn't stop when prog selector knob is turned to off, start/stop button doesn't stop it. Stops only using on/off button. Seems to be emptying as pumps out water when poured in manually. May be G646 SC


My O/H found a considerable amount of gunge in the inlet pipe; that seems to have solved it! Thanks for your interest.Enid ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Whirlpool dishwasher doesn't seem to fill with enough water despite good water pressure. Therefore, pump sounds like it is cycling from pumping water for about 2 seconds to going dry for 2 seconds to pumping water for 2 seconds to going dry for 2 seconds, etc. Spray arms rotate only for the 2 seconds when pump is actually pumping water. Dishes do not get clean.


... Whirlpool 24 in. GU2548XTPS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1241 seconds