Having problems with your Pressure Washers ?

Hello i have a s1800 simoniz washer pressure the pressure is realy poor, i have tried a lot of thing to fix it without success?


Answers :

Try pouring liquid TSP into the fresh water inlet and letting it sit for a couple of days
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hello i have a s1800 simoniz washer pressure the pressure is realy poor, i have tried a lot of thing to fix it without success?


Try pouring liquid TSP into the fresh water inlet and letting it sit for a couple of days ... Pressure Washers

Dishes have lots of residue on them. I have to scrub them with a scouring pad to get it off. I have done the citric acid thing and that did nothing. I have run the dishwasher without any soap in to "rinse" it out and when I open the door mid cycle there is lots! of soap in the water. I have done this about 30 times and there is still lots of soap


Hi,It seems like the dishwasher is not draining properly....Sometimes it will drain at the end of the cycle but not during the cycle....that is a circuit board issue....if it does not drain at all then you have other issues,,,, ... Maytag 24 in. MDB4100 Built-in Dishwasher

Hi I have a Blanco dishwasher BFDw8 which is having poor wash results in the top tray I have tried all the trouble shooting things in manual. Investigated further by opening door during wash cycle several times and discovered the top arm is not moving although water is still coming out of the arms. I did get a split pea particle out of the arm approx 2mm and have since had a mildly better wash and have used superior wash powder and rinse aid to try and help. Also have put a cleaner through di


\015\012\015\012Check the water temperature. Should be 125 to 140 F. \015\012\015\012Check pump re-circulation., Listen, see if it sounds like it is spraying the water around with enough pressure. ... Dishwashers

A part came flying out when I tried to use the handle to open my dishwasher.I now cannot open it without a screwdriver. How can I fix it? What part do I need to fix it.


If the handle is off then you only have to take off the outer door panel. then replace the screws. ... Dishwashers

E4 message have been trying to clear the e4 message by leaving machine switched off for 48 hours but without success. have checked the machine now drains properly (it does), is there anything else i can try ?


Take of the btwo black panels at the bottom of the dishwasher and put in a towel to soak up thje excess water this works for me everytime ... Baumatic 23 in. BDW13 Built-in Dishwasher

Hi, I have had a few issues with my ST663 machine. The current problem: the rinse cycle light keeps flashing and it doesn't start when you shut the door. I have tried holding down the right button but it beeps twice and nothing happens? Also tried holding both buttons down for a while and still no success. I got a new electrical board installed not that long ago so not very happy hoping it not a big issue. Do you have any other things that I could maybe do?


HiIf you have already tried to reset the unit by pressing the High Temp wash-heated dry button for 3-4 times in sequence then the problem is either with the door switch or the keypad itself that has gone bad and should be replaced. Hope t ... Dishwashers

Heavy wash light is flashing, after fat and debris put into dishwasher by children. Have tried using a dishwasher cleaner without success.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. To resolve this issue unplug\015\012the unit and then drain the water out of the overflow base pan which is loc ... Asko Dishwashers

Hello, my Bosch Classixx dishwasher SGS43E42EU/21 has me stumped. It starts by taking in water but when "filled" pumps out for a couple of seconds then refills for say 10 seconds more before another 2 or 3 seconds of pumping out. This cycle continues for ages without starting to wash. I've tried various things: - checked the Auto Stop valve isn't being activated by leakage (removing the polystyrene float and bottom tray makes no difference - there's no leak) - the valve seems to operate it


Hello Dave,\015\012\015\012Sounds like an overfill problem - the symptoms are consistent with a failed pressure switch. Water enters the dishwasher through a chamber which has a float arm connected to a small microswitch -this is the pres ... Bosch Dishwashers

We have a Kenmore Quiet Guard 3 dishwasher, model # 665-74363. The 'Heated/Dry" light is blinking. I have tried the various reset combinations without success. Also unplugged the unit for awhile. Any suggestions? Thanks.


When the heated/dry light is flashing that tells you there is a problem in that circuit. Which normally means that it is either the heating element or the thermostat. BUT could also mean that the float assembly is telling the control panel that wat ... Dishwashers

I have a honda GX240K1 on a BCS tiller. The engine seems to defy reason. I have adjusted the governor, set the max speed screw, adjusted the idle speed and have achieved some success but cannot seem to control max RPM's. The engine max's out at over 5K. I have tried about everything I can imagine yet nothing seems to fix it. Spec's say that it should idle at about 1400 Rpm yet it seems to idle best at about 1800-1900. I am using a EZ328 instrument to check the engine RPM and it's reading i


Hello. It sounds like the governor is either out of adjustment or in need of replacement. I agree that you should not run this in this condition or you will have a much larger repair to do. I would replace the governor. J. ... Honda 8 HP Engine

My Prima LPR450 slimline dishwasher has become impossible to programme as it bleeps and flashes at me and will not allow me to set a programme. Up until now it has been perfect. Ihave tried to find a manual /user guide but without success. It might help to know who actually maked prima dishwashers. Thank you


... Dishwashers

Hi. The dishwasher won't turn on any more. The "stop" light flashes and I have tried to re-set (as per the instruction book), but without success. It was working perfectly until yesterday. Not sure what has happened. Any ideas?


... Siemens 24 in. SL64A630GB Built-in Dishwasher

Indesit dishwasher will not start a cycle and the first (pre-wash) light keeps flashing. I have tried different cycles and switching the power off and restarting without success. Any suggestions?


... Indesit Dishwashers

Dishwasher problem It is a "classique" dishwasher , about 8 years old, but used only about 50 times max. The dishes are not getting out clean - the washing powder is smeared over them. Most of the dish washing powder (or tablet, tried it both) is not comming out of the powder compartment, despite the fact that we find the compartment open when the washing cycle is done. Sure it is just a "smal quick fix thing" but have not idea what it could be. Pleaseee help!


... Dishwashers

I have a Campbell Hausfeld Furniture Paint Sprayer - paint is coming out without me pressing the handle - continuously spraying. When I try to press there is no pressure it just flops back and forth. Can someone help as to what I need to do to fix this? Thank you


The paint is too thick try thinning out the paint would be one possibillity clogged tip/filter. Also what happens sometimes is when using latex it drys fast so sometimes it starts gumming up the springs so it doesnt allow the trigger to close up all ... Pressure Washers

My dishwasher will not turn on and the Start/Resume light will not stop blinking. Is there any thing you can suggest to fix this without my calling and paying for a service call? We have stopped, restarted and reset the unit as well as cleaned out the soap tray. We have also switched off the electric to the washer as well to no avail. Really cannot afford another service call again so please help us out. Thanks. Chris


Reset the control again. Then change out your heating element.\012\012That should fix it good.\012\012Have a great day! ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

My Kenwood dishwasher KDW24FI/B has worked fine for approx 2 years. But now when I put my dishwasher on, the cycle never seems to end. After a few hours of running I opened the door to find the tablet hadn't dissolved but lots of steam coming out. I tried 2 more times and the same thing happened. The pump is working and everything seems ok. After reading the manual I have noticed the salt and rinse aid lights are iluminated. I have never put salt or rinse aid in since I had the dishwasher so thi


Lol is it a stereo or a kenmore, dishwashers dont use salt, but water softeners do ... Dishwashers

My daughter has inherited a Heller HDW12 dishwasher with the house she bought. It has been operating OK for some months, but recently the door has jammed. I have tried to open it without success. From my examination it appears to be the lock on the top of door that is malfunctioning. Your advice to overcome this problem would be appreciated. Thanking you ...Dennis Edwards


The lock could be faulty or the wiring to lock could be loose or broken. You can try to unplug for a while, in meantime of being unplugged, press and hold some buttons to drain all the power out and see if it resets itself. Then wait half hour and pl ... Dishwashers

Samsung DMR57 We bought a Samsung in June and have been trying to get it to work properly ever since. It is very quite which is great, but like the other person wrote the thing keeps coming on even when the child lock is on. We have had a repair man out twice but it they haven't fixed it yet. The dishwasher is right under the counter we use to prepare food so we often rub up against the controls. The power comes and and it starts the machine on whatever cycle it used last, or rinses the dishes.


... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

I have a whirlpool dishwasher thats a quiet partner 2. the cancel drain light keeps blinking and nothing else is happening. i try to unlock it and then the normal light starts blinking also and still nothing happens. i called a local repair shop and they said i need to change the control board so i did and its still does the same thing. can you give me an idea of where i need to start to fix my problem?


Can you here the pump running or check to make sure there is no water in the base... ... Dishwashers

Honda engine turns 3/4 then locks up under pressure? Cant pull start. Tried without pull rope, and same thing? Is this a valve stuck? How much for repair?


... Honda Pressure Washer PSI 3000

Bosch Dishwasher I have a stainless steel Bosch dishwasher, I made the "mistake" to try to see if I could fix the jammed handle from the door. Unfortunately, (did not realize the top panel comes off without opening the entire door). I removed the screws from the door frame (Inside panel), and the door springs/latched got loose. I would like to put it back together, but I dont have any diagrams on the door to make sure all parts are in place to put the door back together. I have been havin


Hi ED,\015\012\015\012It sounds like a real problem here. If the springs are still in one piece, my best guess is to to remove the springs from the door. Then attach the springs to the dishwasher body first, then reattach the spring to the door. Not ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would


... Siemens Dishwashers

I am trying to fit an outer door to my Neff compact built in dishwasher. I have the correct fixing kit, but it comes without instructions and I have been unable to source any. Any advice or guidance would be much appreciated. Richard Hine


See this videos:God bless you ... Dishwashers

Karcher 2.56 keeps pulsing on and off whenever high pressure nozzle is attached. I have tried different nozzles and same thing is happening. when i press the lance without any attachment it works fine


Make sure you have bled all air from the system. Also make sure you have sufficient water supply; if house water pressure is too low or if your hose is too long or doesn't allow full flow, you may not be getting enough water to the unit. ... Karcher Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1118 seconds