Having problems with your Pressure Washers ?

I have a 1/2") Air


Answers :

Does the drive move if you try turn it manually, if it does not strip the unit and check the bearings. If the motor and vanes are seized the air will just vent out of the exhaust. If it turns, Dismantle the trigger and air inlet valve and check that for sticking, leaking or broken parts.
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a whirlpool dishwasher Quiet Partner IV. Every 3/4 months I have to reset it because it will not turn on and perform a wash cycle. The appliance repair people only reset it and charge me $40.00 and do not give me the code. I found the code on the internet but now that code is not working ''High Temp, Air Dry, Air Dry, High Temp, Air Dry, Air Dry.'' Any other suggestions?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

I have a Whirlpool Gold Quiet Partner III (Model GU1200XTKB0). I have used it previously on "Normal" cycle and I always keep it on Air Dry. Last night I used the "Pots and Pans" cycle and it seemed to work fine. But this morning the Air Dry light is flashing and if I press a cycle key the Rinse Only light starts to flash as well. Nothing works. I have made sure that the console is not locked. Any suggestions? I do not have a Heated Dry button, only Air Dry. Thank you.


... Dishwashers

The dishwasher is in the middle of the cycle air dry indicator goes out lock indicator goes air dry goes out. Then dishwasher hesitates lock light goes out air dry indicator comes on. This is repeated throughout the cycle


... Kenmore 15634 Built-in Dishwasher

I have a 7 hp B&G craftsman Pressure washer , if I place an air filter on it ,it wound't start or run , if I remove the air filter it would run like a champ, but after 10 mints , oil would shoot out off the carb like a running faucet , why is it not running with the filter on,.Now am not so sure if the air filter is the correct size , because when I put it on it seem to be a bit on the taller size rather than a perfect fit, thanks for your help , in Hollywood , Reinaldo Roman .


First,It sounds like the air filter is full of dirt preventing air from flowing through, starving the engine of air.As for the oil shooting through, are you certain the oil is coming from teh carb?. Makes no sense the engine w ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

The overflow air drain on top of the sink that is connected to two hoses under the sink is leaking. It leaks out the top onto the counter. I took it abart but am afriad I did not put it back together right. There is a rubber ring that I think must be for sealing and I put it directly on the counter and then screwed down the air valve over this and water s coming out of the air flow valve and all over the counter.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

GE profile dishwasher - water is filling the air gap and is all over the counter. I took the cover off air gap. Nothing there. What should I do to correct this?


... Dishwashers

Air gap does anyone know if washington state code require an air gap for a dishwasher


... Dishwashers

Dishwasher expelling water through air gap into sink We have disconnected the hoses to check for obstruction and have replaced air gap assembly


MY DISHWASHER AIR GAP IS SHOOTING WATER INTO THE KITCHEN SINK WHY ? ... Dishwashers

Dishwasher Model Kenmore # 665 16829000 Dishwasher "Quick Rinse" was blinking and no other buttons would work. Received FixYa solution below: "Check out the console assembly. take off the inside cover and the plastic over the electronics, just remove the two screws holding down the circuit board, pull it to the side, then blow plenty of air through the two holes on either side. The holes that you need to blow air into are not on the circuit board, but on the plastic underneath the circuit boar


Hi\015\012If the control board detects that a key is stuck in the depressed position, the dishwasher operation will be suspended and the control will flash the light for that key until the condition corrected. If a key without a light is ... Dishwashers

Clean water coming out of air duct when dishwasher is draining; have to put towels around the air intake so it willnot flood counter.


... General Electric GSD4060NSS Built-in Dishwasher

Jenn-Air dishwasher will not drain - Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher


Hello there:I am assuming it washes OK\015\012\015\012First remove the kick plate.on the front bottom \015\012Is the pump running when it should be draining?\015\012Is The solenoid (Wash/drain) pulling down when it shoul ... Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher

I have a troy built pressure washer leaking gas from the air filter i looked around for advice and hurd bang against the carb and it will realease the float valve i did it and it worked but should i clean out the fuel in the filter area or the filter will it harm it as it is or should it be okay? the filter was soaked in gas dry now and when it happened the gas flowed from the air intake (behind the filter) if i need to clean out in there how do it do it and if i need a new filter


Definetly replace the paper filter and yes Lowes will carry them.if it does not leak now, I would leave it alone or you will be installing a nine dollar kit.The briggs kit # is 294260 is you choose to do it anyway ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Whirlpool dishwasher model GU1500XTLSO Control panel is mostly not responsive. Can enter "control lock" mode by pressing and holding "air dry". If I press air dry again in this mode, the green button flashes three times. Does this mean anything? I would really appreciate some help.


... Whirlpool Dishwashers

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers

I have an Asko D1322, about 2 years old. All is good with the washing but the dishes when it finishes are still very wet. The fan appears to be running and I'm getting a small flow of air out the vent in the bottom left of the door. Does the fan need any maintenance? I was wondering if this might improve air flow and get rid of the condensation quicker.


... Asko D1876 Dishwasher

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

Whirlpool dishwasher will not drain. All hoses are clear. I replaced the air gap too. The dishwasher will drain into a bucket when I detatch the hose from the air gap, but not into the drain/disposal when I replace it.


Http://www.partselect.com/repair.aspx?appliance=dishwasher&part=water-wont-drain\015\012\015\012\015\012\015\ ... Whirlpool GU2400XTP Built-in Dishwasher

Need a new sink- now THE SINK has 4 holes to accomodate hot cold water faucet and an air gap thing that is hooked under the sink to dishwasher and garbage disposal- can we not rehook that air gap kit and just get a sink with three holes for faucet only?? a quiet wash whirlpool model DU7800XS_3 -need info. linda


Yes you just need to run the hose to the top of the counter hieght to create a high loop. Basically does the same thing as an air gap. Here is a video showing this\015\012 ... Whirlpool GU2400XTP Built-in Dishwasher

Coleman mobile home furnace...Model number DGAA077BDTB...The furnace about a month ago started going out ( flash code- Combustion Air switch stuck closed)We replaced the thermostat on the wall and it stopped doing it and ran fine then last night it stopped again ( Combustion air switch failed to close) and when i got up the furnace was working and now for the past few hours it refuses to do anything...I am on a very very tight budget...and need some idea of what is wrong and do i need a professi


I had the same errror code on my coleman furnace (3 flashes combustion air switch failed to close) but at first didnt realize there was even a light that gave codes..Anyways long story short, after searching many forums one guy mentioned about the fu ... Dishwashers

We have a miele G665 SC dishwasher. Cycle is fine but when it starts drying water now comes out of the vent on the front of the machine where previously all we'd get was hot air. It creates quite a puddle of water so it's not just the hot air condensating it's more than that. Hope you can help. Regards Paul


Cleaned pipe again and seems to be OK for now - seems to be a bit of an issue with this model as this is the second time this has happened! ... Miele Dishwashers

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

LG LDF6810ST had OE error. Disassembled found no obstructions blew air through and vacuumed hoses to air gap and to disposer, no obstructions. Never heard pump run when starting cycle, so replaced drain pump. Still doesn't run. Looked at the service manual, and the only other suggestion is repair circuit? Is this the circuit on the bottom right of unit or the pcb up top? Wires and connections all look fine. What else could it be. Any suggestions appreciated!


Hi,Usually my First Response to this Common Error is :-Most likely pump trap is clogged up. Access it behind small door at front. Drain water out through small hose that is there otherwise water will be all over the floor when ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Jenn-Air Expressions' Built-in Range. Two ovens top & bottom. Display unit on front fades out to blank. Display Unit called "Single Oven Display" NP-3; Date Code is 23-96 Robertshaw Jenn-Air BRK


... Jenn-Air JDB1105AWW Built-in Dishwasher

Poor drying, mold building up in the tub. The condensing drying system is not working well. I pulled the unit out and removed a panel on the left side (facing washer). Saw that the plastic box that appears to be set up for moist air removal and vents to the tub had considerable mold in it at the top of one of the passage ways. Looked like it might be blocking air flow. Could this be a cause of poor drying? Can this unit be removed and cleaned? Also soap isn't dissolving. Bad board controllin


Hi.Poor drying is often caused by a faulty moisture sensor. If there is mold covering the sensor housing , that can be cause for the problem. Regarding the door detergent drawer problem, that is often caused by a defective doo ... LG LDF6810ST Stainless Steel Built-in Dishwasher

When dishwasher drains the water not all the water is drained. Some stays standing at the bottom and starts getting an odor after awhile. This is a replacement dishwasher in a 35 year old house. How important is the air release part in the draining situation? I was told by someone that the newer dishwashers have the air release part which was not hooked up on this dishwasher when installed last year. Are there some other possibilities of things that can be checked. Model Number is DU


... Whirlpool DU1055XTS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0151 seconds