Having problems with your Pressure Washers ?

I have a cat pump that overheats and the pump oil is full but still overheats and melts the oil cap


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a cat pump that overheats and the pump oil is full but still overheats and melts the oil cap


... Pressure Washers

I have Honda power washer 3000 psi...i bought new red cap for oil and oil is coming out red cap on cat pump


... Pressure Washers

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

I have a Honda pressure washer with Cat Pump 3dx29gsi, it runs rough when I pull the trigger and after 5 min of running, oil starts to spit out of small hole on red fill cap on pump


Sounds like you need to open the pump and inspect the pistons and seals. It appears that the seals & or pistons are worn and the water is by passing into the crankcase of the gear box. A sure sign oil coming out of the filler cap & the oi ... Caterpillar CAT Pump Pressure Washer Pump Oil

What is the red cap on the cat pump for? And why is oil or some type of redish colored fluid coming out of it?


The red cap is for adding lubricating oil for the crankcase in the pump. If oil is coming out of it while it is running a seal in the head wore out and water is getting into the crankcase and displacing the oil. ... Northstar Professional Series Pressure Washer 4000 PSI

Where do you buy a oil cap for a dewalt 3800 psi power washer with a cat water pump # 67DX39G11


... Dewalt Pressure Washers

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

I have a John Deere 3800 psi pressure washer, it stopped having pressure in the middle of a job. No restrictions and still turns on and sounds great. Checked pump oil and it was a milkshake green. Changed pump oil and still doesn't have pressure.


... Pressure Washers

Pumpoil started to leak out after a few hrs of use. i have pump oil that i originally got over 12 yrs ago with the pump---is that unopened can still good? and how do you add and how much pump oil do you add? thanks----gary


12years doesn`t have the effect on oil that it does on women,so you should be right.has the machime ever done this before?is the oil white?i think you should drain the oil completely there will be an indicater the some where to tell you how mch,I don ... Pressure Washers

My Asko D1606 doesn't seem to be filling/retaining enough water to pump actively through the swing arms. When I add a litre or so of water in manually and hold in the door catch, I can see it appear to start working properly. The tablet is still sitting on the bottom of the dishwasher after the cycle has ended and the dishes are still dirty. The pump sounds all right and it is emptying fine. Also, probably due to the lack of water, the cutlery basket has melted right through, and I am sure any p


Check to see it the dishwasher has been pushed back ever so slightly. The water coming into dishwashers and exiting are on timers and if the hose is pinched this can affect it. Your dishwasher may appear to be in the same place but just pull it forw ... Dishwashers

Cat pump 3200 psi problem- plz help! I hook up the hose and no water will come out of the pump out let with or with out the hose the pressure waser hose hooked up!


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Had the Northstar 3000 psi Pressure Washer for 2 months and it started leaking oil from the pump during use. Took it to Northern and they are replacing the pump under warranty but said it was likely because I was using quick connects on my garden hose coupling and that was restricting the water flow making the pump overheat. They said never to use quick connects on the garden hose unless the opening is at least 5/8". Does anyone make such a quick connect? I hate having to screw the garden hose o


It is easy to check if your hose and quick connects are supplying enough water to the pump. Your pressure washer gallon per minuite requirements are printed on the machine and also on the pressure tips in GPM. Your post indicates 2.5 gpm but check yo ... Northstar Pressure Washer 3000 PSI

I have a JD 3300 psi 1150 Briggs n Stratton pw. It is leaking from the oil cap/ dipstick seemingly from high pressure. The cap dipstick is about 10 inches long, so this is a real squirt goin on. There is no rubber oring or gasket in the cap. I bought it from a pawn shop new, or at least seemed new as the hose and tips were still factory wrapped. Any ideas?


Either there is compression from cylinder getting into crankcase pushing the oil out or the oil level is too high. ... Briggs & Stratton Pressure Washers

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?


If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

Replaceing a water pump in a 2003 frieghtliner with a 3126 cat. have water pump loose from engine but will not come completely off. Does the oil cooler or the front accessory bracket need to be removed to get pump off?


... Caterpillar CAT Pump Pressure Washer Pump Oil

Oil used for Cat Pump on pressure washer?


It will be a 30 wt non detergent oil probably. You could contact a Rental store in your area they will have what you need. Hope this helps. 2rns4u <*{{{>( ... Honda Pressure Washer PSI 3000

Rkv 3.5G35 Pump is overheating so badly the plastic sight glass is melting. There was plenty of water and pump was running good until "back end" started overheating. Oil level was fine but it is now really black


... Annovi Reverberi RMV2.5G27D Pressure Washer Pump

My AR pressure washer pump is not spraying water out the wand. I noticed on the top oil cap is squirting oil out of the tiny hole. Please help


... Pressure Washers

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

Pump oil seeps out of its fill cap. - Comet GXD2527G Pressure Washer Pump


More than likely you have water leaking into your oil, making the oil float on the top and out of the vent. Eventually you'll only have water, and no oil. Drain oil and replace. You will probably have to replace the seals between pump an ... Comet GXD2527G Pressure Washer Pump

Water in the oil in catpump ? why ? - Caterpillar Cat Pump Pressure Washer Pump 3SP30G11


The ceramics and seals need replacing ... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Low oil pressure while car is in idle..check gauge light comes on. I had the oil pump replaced and the sludge cleaned up. The check guage light still comes on when car is in idle and epecially when the car is hot.


Sounds like your oil pump replacement was left too late.sounds like a worn engine due to oil starvation with the previous low oil pressure and sludge problem.to verify the oil pressure you need to fit an oil pressure guage. to ... Mi T M Pump Oil

Just finished a full cycle and the tub is still full of dirty water. can I cycle just the drain pump via the control panel or do I need a service tech?


You should be able to select cancel or reset to initiate a drain cycle. Also, drain begins at the beginning of every new cycle.St. Paul Appliance Rescue ... GE Profile PDW9880NSS Stainless Steel Dishwasher

Honda 11 hp, model GX340, Cat pump model 5DX40GL; Low on hydrolic oil need to know what type of hydrolic oil to use.


... Honda Pressure Washer PSI 3000

When the dish washer is done washing the bottom is still full of water. When you start the next load it pumps the old water out and washes the load. Never did it stay full of water in the past.


Since\015\012 the drain pump will pump the water out using the "cancel/drain" \015\012button, if it did not work then your problem is likely to be in the drain hose system or the \015\012garbage disposal downstrea ... GE GSD5610D Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0753 seconds