Having problems with your Pressure Washers ?

Water line not working

\015 The water dispenser has stopped working. On ocassion, it will sporadically work for a few days then stop again. Ice works fine. Double outlet water valve DOES vibrate (as if it is working) when depressing the water fill. I'm concerned there is calcium build-up past the double outlet water valve but before the ice/water dispenser. Filter was just replaced (I confess, we did this beyond the normal time frame to replace it). I tried to blow line clean from wall going to fridge, but it makes sense this part IS okay since the ice maker is making ice. It has to be this part or a clogged line. Any thoughts???\015

Answers :

The door switch controls a solenoid valve. I don't know exactly where it is. The solenoid valve is bad, or the switch is bad. If it works intermittently, it is more likely the switch - usually. However, if you are hearing a buzz, I would think that would be the solenoid valve buzzing, indicating a problem with the mechanical valve part of the solenoid valve. Likely, it needs to be removed, taken apart and cleaned.

If this has been helpful, please take a sec to rate me. Thanks!
Don
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Maytag Dishwasher I would like to know the proper water level after DW fills. Older Whirlpool units a quick guide was when water just covered heater. I have a new D/W and the water supply is difficult to access, there is a kink in the water line slowing the water flow. The D/W fills to bottom of heater, but because the unit is so quiet I can't determine if it is timing out or working properly. I intend to repair water line when counter work is done. Thanks for any help Gary


Newer Maytags should fill close or up to the heater not over. Sounds like your alright for now but I would get that water line fixed. ... Maytag 24 in. MDB8951AWS Stainless Steel Built-in Dishwasher

Magic Chef DU4K is not draining all the water. There's at least a gallon of water standing in the bottom. I have cleaned the air gap assembly and drain line completely. They were even sanitized in hot water. I do not hear the water draining like it use to. When it worked properly you could always hear water draining into the GD. Now I can hear any draining. Again, there is no clogging anywhere in the drain line assembly. Is it a bad pump. I don't know where to go next with this.


... Magic Chef Dishwashers

My dishes are filled with white residue from the hard water. I've tried vinegar to cut it and new rinsing agents but nothing works. Is there a filter to clean out any hard water deposits? Do I need to check the line for plumbing for hard water deposits? My water softner is working fine, my dishes are filled with white all over them. HELP!


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

No water The washer was working fine, but now it says it's running through the cycles, but no water? I made sure the water line going in was good. Could it be the little pump that connects to the water line?


Maybe the solenoid that lets the water into the DW is not actuating ... Kenmore 24 in. 15932 Built-in Dishwasher

Water line not working


The door switch controls a solenoid valve. I don't know exactly where it is. The solenoid valve is bad, or the switch is bad. If it works intermittently, it is more likely the switch - usually. However, if you are hearing a buzz, I would think th ... Pressure Washers

I have a GE Profile, GSD4930X73WW, dishwasher. The upper wash arm is not spraying well at all. I checked the water line from the pump to the upper arm and it's fine. I cleared the filters and cleaned the float. I also took the inlet valve off and cleaned the screen. Although the washer works better overall, the upper arm still does not work well. Nothing appears to be in the upper arm assy to clog water from spraying out. All seems clear from the turbid sensor (next to the pump) through t


... GE Dishwashers

Water is suppose to go throw and turn those spriklers inside the dishwasher but mine is not working.I love my Frigidaire but it is not working right.serial # TH24181756 and the other number is FDB956RBCO the O has an angled line throw it /.black on top and stainless on the bottom.It seams fill up with water and is hot and steamy and when it drains it drains great.it sound like its working but it is not cleaning the dishes,even simple derty dishes.Help Help.Daren K Chidester 13233 peter Kalama Dr


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDBS956CC Stainless Steel Built-in Dishwasher

Model FDB4315LFC2 Serial TH80658596 It is only 20 months old but Does not load with water. I have checked water line into white valve and water is flowing, but it does not come into the dishwasher. If I manually put water in the bottom of the dishwasher it works fine through the cycle until it is time to pump in more water. There is a sound but no water comes through the valve.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As you have already checked the water line for clogs/obstructions and the water is flowing but wont fill ... Frigidaire Dishwashers

My plumber just installed a new water supply line for my dishwasher. Now the pump comes on but no water fills up in the machine. If I fill the bottom of the unit with water, it works just fine. Even though the water supply is ON, it does not pump water into the 'box'. Thanks, Art


You don't know how many times I've heard and found the shutoff valve off or partly turned off. Water entering DW is from line pressure not pumping. Items to suspect (again) the water supply valve (would'nt be the first time a new valve is bad). The ... Whirlpool 24 in. DU915QW Built-in Dishwasher

I also have a dishwasher (AEG Favorit), and it does not heat the water anymore. It worked fine for last 3 years, and all sudden, it only washes dishes with cold water. Could you please help to solve this problem? The hot water line is fine and I do have the hot water to the sink next to the dishwasher. Thank you in advance for your help.


... AEG 23 in. Favorit 44070IW Built-in Dishwasher

I have a Kenmore dishwasher (363.16222100) that isn't getting water into the unit/tube. All the other cycles seem to be working fine. I've replaced to water inlet valve and it's still not getting water into the tub to start the wash. Checked the water line and it's fine. Any ideas?


The only thing left is to replace the main control board ... Dishwashers

The Bosch SHU9922uc is not spraying water. It worked fine this morning, tonight it starts off by draining like usual but after 30 minutes or so, I open to check it, and no water is spraying up. I've check the water line and the drain. Any suggestions?


... Bosch SHU9922UC Built-in Dishwasher

The water is not draining from machine, although the pump is obviously trying. It doesn't sound quite right. Kind of a growling noise. It can pump water into tubs when experimenting with ideas, but can't pump hard enough to pump the water into the sink. This is all done with the hose removed so we could check for debris in the line. I've checked the filters and they are clean and clear. This is a used machine a friend gave me, and it's been working beautifully until now.


Normal\012 0\012 \012 \012 \012 \012 \012 \012 MicrosoftInternetExplorer4\012 \012\012\012\012\012\012 /* Style Definitions */\012 table.MsoNormalTable\012\011{mso-style-name:"Table Normal";\012\011mso-tstyle-rowband-size:0;\012\011mso-ts ... Bosch 24 in. SMU40 Built-in Dishwasher

I have a Vikin Dishwasher Model DFUD042 and the arms are not circulating water. When we start a cycle it drains previous water then fills it up after that it runs thought its regular cycle but the arms are not circulating water we have tried cleaning drain checked lines etc. still wont work.


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Viking 24 in. Professional Series VUD141 (Ultra-Premium) Built-in Dishwasher

Have a hotpoint dishwasher, replaced the water valve and it doesn't seem to loading water. I disconnected both sides of the water line but still is not working. Any ideas?


THERE IS A FLOAT/FLOOD SWITCH ON THE FRONT LEFT SIDE INSIDE THE TUB. SOMETHING MAY HAVE GOTTEN UNDER IT OR IT IS GUNKED UP. THIS WILL PREVENT VOLTAGE FROM GOING TO THE WATER VALVE, THUS, NO WATER. ... Dishwashers

Hi, I installed LG dishwasher, control board is working, water is coming from the water line but when hooked up to the dishwasher and dishwasher is on, there is no water coming into the dishwasher....


It should drain a bit of water out before it fills when it first starts. if that water doesn't drain out then you may have a drain pump fault. You can test this by dumping a few glasses of water into the machine then starting it up ( you should hear ... LG Dishwashers

Miele dw flashes 5 times, water is draining. Suspect filter/valve housing at end of water inlet line. Their is a wire running to this valv so I imagine whatever solenoid that tells the valve to open and let water in is not working. Am I close? I cleaned inlet filter.


Which light is flashing? if the intake drain light is blinking and you dont hear the drain pump, it means water is not coming in. if the drain pump is running all the time, it means water has leaked into the bottom pan. behind the plastic toe ki ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Dd603h my bottom drawer will not take in water - the top works fine. when i change motor the top still works fine and the botom still has a problem. it displays a watertap with a line over it sincerely - jesper sorensen


The watertap with a line means the inlet water solenoid is faulty.\015\012\015\012YOu will have to replace it with this par ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My dishwasher hums and runs but no water is going into it. The water line is fine, working and correctly installed. Help?


Probably a bad inlet valve ... Kenmore 13599 / 13594 / 13592 Built-in Dishwasher

I have a Bosch SHX98M dishwasher and the top arm will not rotate. I can see water coming out of the holes when open during a cycle and I have made sure there are no obstruction for the arm or anything stuck in the arm feed line. I just had a technician here who was at a loss and did not think the pump was bad since alot of water is being pushed around inside. The bottom arm works fine.


... Dishwashers

The dishes in my dishwasher are not getting clean, particularly on the upper rack. It seems to be because the upper water arms are not spinning during the wash cycle. The bottom spin arm is working fine. I have cleaned out both upper arms as best as I could without removing them (above and attached below to the upper rack), as it does not appear that these arms are easily detachable. I am thinking maybe water is not making it up the line to the upper arms? I also have a lot of dirt in the b


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. First of all please check the\015\012Water temperature by using a thermometer inside the dishwasher to measure ... GE Dishwashers

The dishwasher was recently removed for floor refinishing and reinstalled. The bottom rotor works but the top rotor does not. I asked the re-installer, who worked for the moving company, if he had connected everything properly and he said there was just one water line going into the machine and assured me he had connected it properly. Is there something else that needs to be done to make the top rotor operational? Thanks. John M


... Jenn-Air JDB3610 Built-in Dishwasher

The top drawer of my fisher paykel dishwasher stops during the cycle and shows an icon of a tap with a line threw it (assume that means no or low water pressure). the bottom works fine so I assume water pressure is not the issue; is there a sensor that could be bad? Also, I did switch the controllers between drawers (good instructions on the fisherpaykelparts.net website) but the problem stayed with the drawer, ruling out the controller.


Did it fill with water? could be 1 of your water valves is faulty, or the little filter for the inlet water is blocked. please reply 4 more help. i"m sure i can fix this problem for you. good luck. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher not getting water in checked all the water lines, nothing clogged all other aspects of the dishwasher are working fine what could b the problem?


... Estate 24 in. TUD6700KQ / TUD6700KT / TUD6700KB Built-in Dishwasher

Water will not drain/pump out of machine. All other functions seem to work fine, but water does not drain out. Problem is not in drain line. The bottom of dishwasher is clean. I wet vacuumed it clean twice


Check for clogged pipe,drain pump or timer. ... Whirlpool 24 in. DP840D Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1293 seconds