Having problems with your Pressure Washers ?

Cannot get to the 4 bolts on a Honda GC 160 to remove pump


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cannot get to the 4 bolts on a Honda GC 160 to remove pump


... Pressure Washers

My pump is gone on my pressure washer. The honda engine is GC 160. The pump is a model VRX2527G. How do I pull the pump off the engine to replace it. I removed the four bolts from the pump housing, but the pump is still tight to the shaft. Please explain the removal process.


Hello,Your pump sits on a keyed shaft, versus a taper fit. This is good, since tapered shafts will require a puller to remove the pump.Since the pump is already bad, you have a few options available to you. 1) W ... Honda Pressure Washers

The dishwasher will not drain. The motor hums. We have tried to remove the central unit inside the dishwasher, but cannot remove the inner black disk --it has a bolt, but we cannot get a good grip to twist it out. We suspect that under the mesh covering is a lot of gunk that needs to be cleaned out.


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain ... Dishwashers

I have a Bosch SHU033A diswasher that is not draining. I have checked the lines but cannot figure out how to get to the drain pump. I have turned on its back but there seems to be no easy way to get the large white plastic bottom removed so that i can access the pump.


Hi\015\012\015\012\015\012 \015\012\015\012Thanks for using FixYa. First check whether the drain is not clogged or blocked and\015\012the line is not kinked. Check all the hoses for blockages & also clean the\015\012air gap. If you h ... Bosch Dishwashers

Hi I have a Siemens SE26T252GB/01 dishwasher which won't drain. (The "check water" light comes on). I have checked all the filters/drains and I think the fault is the drain pump which I would like to replace. I can remove the side panels but cannot remove the base to get access to the pump. Can someone help with instructions or a diagram please? Many thanks


... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

Removed lower spray arm of KitchenAid dishwasher and need to reinstall it. This installs over a spray arm nut that is a split ring. The nut goes over the outlet pump. I cannot get the nut to go over the outlet pump and then go inside the spray arm, which is 1/4-inch smaller in diameter.


... KitchenAid KUDS24SE Built-in Dishwasher

I have a ANNOVI pressure washer and I can not seam to get the engine apart from the pressure pump. All bolts are removed and the bludy thing will not come apart. The lock nut on the drive is not even


There may be no good news for you. Once those hollow shaft pumps seize to a engine shaft, they can be real buggers. In fact, they can be impossible. But before you give up and completely destroy the pump to remove it from the shaft -- the ... Pressure Washers

My 6 hp honda motor has become very hard to pull. It is on a pressure washer. I even removed the pump but still pulls hard.it runs if you can get it started but dosnt seem to be running at full power.I pulled the spark plug and it spins easily. Help!


When you remove the spark plug and it turns easily that means that the valves aren't opening properly. When the spark plug is installed and its hard to turn over, its because the valves (possibly just the exhaust valve) are sticking shut and the pre ... Pressure Washers

I need to clear out broken glass from the gray pan underneath where the water drains to, but I need to take the twirling water sprayer off first to get to the next piece that looks like it is bolted down, and I cannot see how to remove the twirling sprayer part. The piece in the center of it does not appear to be a screw off part, so I am at a standstill.


Hold the twirling sprayer part and unscrew the big round nut part just above it, then you will see a 3/8 nut,remove it and sprayer arm will come off ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My SGS55M72AU/65 does not get rid of its drain water, although that wee pump in the bottom is clearly working (which I could see after removing filters and pump cover). There is no blockage near the drain pipe connection, so I infer there is a blockage somewhere inside the dishwasher, in a place I can't get to without further instruction. I've removed most of the drain water and pulled the unit out, so I could lay it on its side and start taking screws out. But I much prefer to have some guidanc


Ok i am attempting to help you although i dont see your make of dishwasher but im using what i know without manual. to ensure there is a blockage in the dishwasher remove that hose you checked at garbage disposal or vent and leave it disconnected an ... Dishwashers

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

Cannot get access to Water pump to clear it.


I wouldn't recomend taking a dishwasher apart unless you know exactly what you are doing.\015\012Taking the spray pump housing off to clean it out can be very tricky.\015\012If you do manage to do it you will need a new jubilee clip for t ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

HI dishwasher will not drain if i remove all the water will run thro cycle and stops with a couple of cms of water left have tryed to find filter inside and failed, removed sides and can see a pump on right hand side can turn impeller easily, is this the drain pump? if not how do i get at pump and or filter. is it possible that plastic chamber on left hand side could be blocked assume this transfers heat Robert


... Bosch 18 in. SRS55L02 Logixx Slim-Line Free-standing Dishwasher

Asea Cylinda 1400 dishwasher leaking underneath. Found wash pump seal leaking. Have removed pump and motor but can't remove impeller to get to seal.


... Dishwashers

Kenmore dishwasher model 665.16033401 doesn't drain well. Drain pump comes on but drain water only trickels out slowly. Obstruction somewhere ? Removed rotating spray arm inside to try & get at the place where the drain water enters pump. Can't remove any parts beyond spray arm. Home: 330-865-4813 Cell: 330-608-3022


... Dishwashers

Fuel pump not working when trigger pulled, all temp. lights on. checked flow switches all ok and new fuel pump coil an stalk fitted. the burner will work if the o ring removed from bottom of stalk allowing fuel through so something is stopping coil from getting 24v(it does get a nominal voltage of 10v)... anyone got any thoughts


... Pressure Washers

Cancel wash working fine. when ready to wash get humming sound. pumpmotor not turning. A glass dish broke a week ago and work fine till know remove screen today found some small brokeb glass - like when a harden glass brakes? if something is in the pump how do i remove pump


In\015\012most dishwashers, the water pump is located under the lower sprayer\015\012arm. This component pumps the water through the dishwasher. The pump\015\012has two impellers, top and bottom. These, as well as other components,\015\012can become ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

The dishwaasher was not cleaning. the top and middle spray bars seemed starved of water. I removed the lower spinner and covers until I got to the pump cover and can't see how to remove the cover. I found bits of food and junk that were stuck on the intake. How to I get the pump cover off? I have found one screw but can't see how the clip in released.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Kenmore 13732 / 13734 / 13739 Dishwasher

Trying to access the pump for a SGS43T12GB/08, the Bosh help desk are saying remove a screw once the roraty arm etc has been removed. We cannot see anything, help on how to access the pump would be appreciated


Typical of the Bosch help desk, the instructions given to us related to the previous years model where access was via the filter etc.\015\012\015\012Managed to find, on a different website (sorry), a similar problem from 2005 in which you ... Bosch Dishwashers

I have a whirpool Quiet Partner III, and the top layer of glasses is not getting clean. I had a technichian out some time ago, and the problrem was caused by food debris trppaed in the filter in the wash module. He saud it was easy to clean that out, so I have removed the lower spray arm, but cannot undo the 4th screw that will allow me to take the grey round filter cover off to remove the food or paper debris. It is under the white flat pipe that delivers water to the wash module, and I cannot


I had same problem, would not clean well and fixed it. . I cracked open the door during wash cycle and used screwdriver to defeat the door lockout. The water from the bottom sprayer was only shooting half way to the top of dishwasher. To fix I remove ... Whirlpool Dishwashers

Due to the my Indesit IDL 530 dishwasher not draining properly, I turned it onto it's left side, removed the base plate and pump and checked for blockages in the pump and associated hoses, which were all clear. However in re-assembling it I have forgotten which way round to connect the twin wire plug to the base plate. I cannot find a relevant wiring diagram online and therefore cannot tell which is the correct way around. I then guessed and re-assembled it anyway, and as you might have g


Hi.There is more than one wire going from control board to the tub. If the connector can be plugged either way without forcing it, then usually does not make any difference the way you plug this determined connector. It will be usef ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Troy-bilt w/ rmv2.2g24 pump and honda gvc 160 engine fires but will not run until I remove the pump-pump turns by hand but is very stiff, can you help me ?


... Karcher 2500 PSI Pressure Washer

Dishlex Hi there, thanks for your quick response. I turned the unit off last night, and tried again this morning. I can see the wash pump on the side and it looks easy to get at, but the drain pump looks a bit more of a mission. are you able to expand a little bit. Should i remove the rinse pump and check that it's not obstructed by anything maybe?


Hi there, now I do not remember the original problem, if there is not water coming into the appliance, start checking the water pump. Also locate and check the water level floarting switch, that stop the pump.If water is not drained out, ... Kenmore 24 in. 15689 Built-in Dishwasher

Dishwasher model: se6 tie1 Fitted under kitchen work-top. Problem: After setting a program & switching on & closing door ? there is a normal sound from within but if door is opened there is no evidence of water being pumped in. I previously cleared food debris from the drainage pump area (including under the pump cover), checked the spray arms and checked the water supply was getting as far as the long in-take pipe. As it seems problematic to remove the (screwed in) dishwasher, I have not che


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1319 seconds