Having problems with your Pressure Washers ?

Gas leaking by carburetor in my Excell Pressure Washer Vr2500?


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Gas leaking by carburetor in my Excell Pressure Washer Vr2500?


... Pressure Washers

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

Excell 2600 leaks - Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer


... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Tthere is gas leaking from the carburetor on a Honda GCV160 pressure washer. Runs fine.


... Honda Pressure Washers

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

My pressure washer leaks gas from the GAS TANK. The plastic tank has a crack in it. It has been barely used. when I fill it with gas it runs fine, but the gas leaks out in a matter of minutes.


If you know where the crack is you can use JB weld to repair it. ... Pressure Washers

I have two DeVilbiss issues: First, on my pressure washer, I no longer get pressure on "high" mode from the hose. I prime the pump but it doesn't seem to be creating enough force for a high pressure. Second, on my generator, the gas from the gas tank leaks out. The tank is plastic or poly and don't know if it's a gasket issue.


... DeVilbiss Pressure Washer Hose 3600 Psi 25'

Excell vr2500 pressure washer ,no pressure, took off high pressure hose at bottom of washer , get water flow, but flow does not change when engine is running full throttle


Check the water filter ---high pressurehose must have bbackpressure to develop pressure so disconecting it wont acheive ,much ,if you have agood water supply ,oil in the pump--- adjust pressure by srewing the brass fitting that the pressure hose atta ... Pressure Washers

Troy Bilt Pressure Washer Model 01902 Leaking Gas from Air Filter


Try banging lightly on carberator with block of wood or something to free up float and valve!!!! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I have an Excell Pressure Washer Model VR 2522, it is leaking from the botttom but can find its exact location of the leak, have all the part but can't find the leak and don't know what area it's leaking from


Hi and welcome to Fixya. Your model has the A14527 Pump assy on it and they are notorious for the pistons leaking due to blow by and the 16 MM seal on the piston starts to leak near the drive shaft. \015\012In addition the O-rings #2950 that m ... Pressure Washers

Have a troy built pressure washer and the gas is leaking out help


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Have a troy built pressure washer and the gas is leaking out help


The float is stuck you can either take it apart and clean it or you might get by by just tapping lightly on the fuel bowl on the bottom of the carburator to unstick the float ... Pressure Washers

I have a troy built pressure washer leaking gas from the air filter i looked around for advice and hurd bang against the carb and it will realease the float valve i did it and it worked but should i clean out the fuel in the filter area or the filter will it harm it as it is or should it be okay? the filter was soaked in gas dry now and when it happened the gas flowed from the air intake (behind the filter) if i need to clean out in there how do it do it and if i need a new filter


Definetly replace the paper filter and yes Lowes will carry them.if it does not leak now, I would leave it alone or you will be installing a nine dollar kit.The briggs kit # is 294260 is you choose to do it anyway ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Unable to start gas engine on a NorthStar pressure washer


Disassemble and clean the carb. If it ran briefly with the starer fluid then gasoline is not coming through the carb. ... Northstar Pressure Washers

Do I mix the gas or straight gas for pressure washer excel vr2522


... Pressure Washers

I have a small model #157893C pressure washer. When I put gas in it, gas pours out of the carburetor filter. Where would I check for the problem?


... Pressure Washers

Gas leakes from air filter canister - Campbell Hausfeld PW2102 Gas Pressure Washer


... Campbell Hausfeld PW2102 Gas Pressure Washer

Gas is leaking out of the air filter - Briggs & Stratton Gas Pressure Washer 20244


Replace the needle and seat in the carb ... Briggs & Stratton Gas Pressure Washer 20244

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

Gas leaking out of carbuerator - Troy-Bilt 2700 PSI 2.3 GPM Gas Pressure Washer CARB 020487


... Troy-Bilt 2700 PSI 2.3 GPM Gas Pressure Washer CARB 020487

I have an excel pressure washer 11 hp Honda engine. water is leaking into the cat pump 4hp40gl causing the oil to become milky, after the washer sits overnight the oil clears up. Any and all help will be appreciated. Thanks


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Pressure washer leaks the gas before starting


Its most likely going into the oil from the needle valve in the carb not seating replace the needle and seat and change the oil ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Excell VR2500 Pressure Washer will not start


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1083 seconds