Having problems with your Pressure Washers ?

I have a Pressure Washer Keeps Blowing Fuse

\015 I have a Karcher 620 M Pressure Washer Was using it today for about an hour then the electric plug came out of the socket the unit then switched off. Plugged it back in and the motor started up for about 3 secs then stopped. Tested the plug fuse 13amp and it had blown replaced the fuse with another 13amp fuse and the same thing happend started up for about 3 seconds and blew the fuse again can you help.\012PS It wasn't plugged into an extention lead.\012\012Thanks Richard\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Pressure Washer Keeps Blowing Fuse


... Pressure Washers

Blow fuse thermalfagor glass washer it keeps blowing fuses


... Fagor LFA-019 SS Stainless Steel Dishwasher

Pressure washer keeps blowing out a high pressure O-ring


... Pressure Washers

When I connect my pressure washer to the kitchen tap the hose keeps blowing off, even when the tap is only slightly turned on. Is there a solution to this to stop the pressure building up?


... Karcher Pressure Washers

My Karcher 6.85 keeps fusing - Pressure Washers


... Pressure Washers

My Karcher k6.85 keeps fusing - Pressure Washers


... Pressure Washers

Bosch aquatack 110 pressure washer , keeps blowing my hose attachement off ?


... Pressure Washers

My Honda excell 2500 psi pressure washer keeps blowing the PULSE HOSE - Pulsation Dampener Pulse Hose. What is causing this to happen?


... Pressure Washers

Everytime i switch on my 6.80 pressure washer the fuse blows on the machine


This sounds like the bypass (unloader) valve is sticking and the internal switch it activates is being held in a half open position. This will blow a fuse. It could also be loose wiring inside. If you ran it with an extension cord you may have we ... Alfred Karcher Pressure Washer

Nilfisk alto e140.1 keeps blowing fuses


... Pressure Washers

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

I have a karcher pressure washer 1800 psi i bought from walmart it was running good until i had a power surge with the plug in. what can i do can i change the fuse in the plug or do i have to open the pressure washer up and replace a fuse.... thanks


You will have to take the cover off & look for melted wires or a fuse.\015\012if there is no fuse the capacitor may have been cooked.\015\012it should be a white cylinder.if it has been damaged it will have burn marks and may be swollen. ... Karcher PSI Electric Pressure Washer

Dishwasher 66513752K601 keeps blowing the thermal fuse. (Bi-Metal W10258275). I have replace the Thermal fuse several times. After i replace the fuse for some reason after a few months or less it will blow it out again. I have also replace the front panel assembly after it stopped working correctly. I would like to know how to test the dishwasher to find out the root cause of the fuse issue. I don't want to be replacing the fuse every time and don't have the $$ to buy a new dishwasher. Everythin


... Dishwashers

The fuse in the plug keeps blowing. Initially it would run for a while - sometimes 3 or 4 cycles - before blowing. It now blows the fuse the second that I plug in to the socket, even with the on/off button on the front of the dishwasher set to off.I'm keen to take it apart, but it's full of water as it blew mid-cycle. Is there a clever way to empty the machine without the power being on, or do I need bits of hose and sponges?A schematic blow up would also be extremely helpful.


Lower the outlet hose into a washing up bowl, it should then Drain. Check the heater to see if it is earthing you get to it by removing the right hand side panel. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Honda pressure washer keeps dying - Pressure Washers


... Pressure Washers

Karcher 720mx My unit keeps blowing fuses, every time i release the trigger it seems to have a power surge and blows a fuse. Any idea if it can be fixed?


... Pressure Washers

I started working with the Karcher KB4040 pressure washer and all was well for 1-2mins, then it sputered a bit and all power died. All hoses were still attached properly, it hadn't blown a fuse in my house and the fuse in the plug of the washer is working fine.When I switch it on I get nothing. Do you think the motor has packed in? I borrowed the machine from my neighbour who's away on holiday, so don't know much about age of the machine. Any advice much appreciated.


If the water is in anyway impeded, like kink in hose the unit turns off and goes into protection mode. That it it shuts down for a pewriod of time depending on how hot it may have got.\015\012When its rested try it again ensuring you definitely ... Karcher 1750 psi Electric Pressure Washer

My kitchenaid dishwasher keeps blowing the thermal fuse behind the door.. Have replaced it 4 times. Now it will run through one cycle and blow fuse. Any suggestions on what other part could be causing this problem?


... Dishwashers

I was using the pressure washer and it stopped having high pressure and motor keeps doing a varoom--- pause----varoom----pause and does not stop doing this even with the wand off. Does anyone know what to do? it is a karcher 1750 psi electric washer


This problem, where the unit continually switches on and off when the handgun is closed, is quite common. Unfortunately it has at least six different possible causes, only two of which are easily checked. \015\012\015\012The first thing yo ... Karcher PSI Electric Pressure Washer

The thermal fuse keeps blowing during a wash cycle. we have replaced the fuse twice. this keep happening


Clean the stator of your motor and bushing. ... Dishwashers

I have a karcher 3.80 md electric pressure washer that keeps running when not in use and the pressure is low. Any help please?


... Pressure Washers

North star petrol pressure washer. working fine, then no high pressure, checked water feed, water filter , pressure relief valve and gun nosall well work sometimes and keep working, when you release the trigger and try in again the pressure gone again. please help, many thanks, richard


Sounds like the regulator is sticking or is airbound. loosen the water connection and then tighten it back. Could also be that the trigger gun is faulty or needs adjustment. Hope this helped ... Karcher 2500 PSI Pressure Washer

My Whirlpool GU2400XTP dishwasher keeps blowing the fuse. It sat up for 6months because the control panel went out and I couldn't afford to get a new one. Finally replaced the panel and the thermal fuse blew during the first wash cycle. I tried to put a 15AMP fuse in it's place to check it out before I bought a new thermal fuse and it too blew during the first cycle. Any ideas?


Are you replacing the wires along with the fuse? It is important to change the wires too as they are usually the cause for the fuse blowing. Be sure and get the fuse kit that includes the wires. \015\012\015\012Is your water too hot? Hot ... Whirlpool GU2400XTP Built-in Dishwasher

Thermal fuse keeps blowing


Mr. Larry (guru?)\015\012The thermal fuse is just that It doesn't protect the circuit from over current although it certainly can open in that case. It is there to protect the board from overheating , thus the term thermal. The dishwasher c ... Dishwashers

Fuse The fuse keeps blowing. Sears replaced the fuse but is has since blown again. Sears said all power was within specs. Any suggestions?


Are you referring to the thermal fuse in the control compartment? There's a kit that does a small modification to the wiring. Make sure that was done. Part # is 8193762 should run around $20 ... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0654 seconds