Having problems with your Pressure Washers ?

Intermitent pressure cut out

\015 Generac model 1292-2 pressure washer. high pressure cut out intermitently\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Intermitent pressure cut out


... Pressure Washers

I have a bosch aquatak 1300si the pressure has dropped off considerably.It usedto cut out automatically when it reached operating pressure and only cut in again once you started to wash ,now it runs constantly but does not achieve enough pressure to wash effectively


... Pressure Washers

Karcher k2400hh pressure washer, water pressure cuts out.


Hello cikanek:\015\012\015\012Try this:\015\012\015\012From your posting, I assume you have removed the splash cap and the nylon bypass valve cover. Connect the water supply to the pump and connect the high pressure hose and w ... Honda Karcher G2400HH-R Pressure Washer

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

My Karcher 411A seems to have lost pressure. Behaviour is this, when you press the water release on the spray gun you get 100% pressure for like 10 seconds and then it seems to dwindle down to 30-40% of its total pressure. When the pressure cuts down I can hear more noise coming from the gun sprayer aswell. So not sure if the problem is in the gun or the main pump unit ?


Sounds more like a clog on the intake side. Check the filter and the hose on that side. ... Pressure Washers

My Karcher high pressure sprayer is delivering intermitant pressure.Every 15 seconds or so it developes high pressure for only about two seconds. Why is it not delivering a constant high pressure stream?


Check that the water supply is constant , it sounds like the pump might be pushing out more water than can be delivered , or it could be a dirty inlet filter ... Karcher PSI Electric Pressure Washer

My 3.99 Karcher pressure cleaner seems to keep going on,off,on,off when i release the trigger.It used to keep going momentarly when the trigger was released until the pressure built up,then cut off until the trigger was pressed .Now it goes on ,off,on,off and has decreased pressure.


Hi! robcarrollDid you purge the air from the pump before starting the motor.InMrFixIt ... Karcher 2500 PSI Pressure Washer

When I power the Karcher 520M water pours from the handgun - there is now leak until pressure is applied. the pump does not cut out but I don't know if this is a problem with too much pressure causing the leak or too little pressure because of the leak. there does not seem to be a way to dismantle the handgun - is this correct Bill


Not too much pressure, a bad gun.Unfortunately you will have to replace the gun. About $65.00 Canadian ... Karcher 2500 PSI Pressure Washer

Unit starts with good pressure then cuts down to small stream then goes to good pressure and back to low pressure


... Craftsman Pressure Washers

My karcher pressure washer is switching on and off when the wand is not being used. the pressure should hold but it appears to cut in and out every 2 secs. the machine works o.k. when pulling the wand trigger but i think the pressure is slightly reduced.


Unfortunately these little units have this problem commonly, 9 times out of 10 it will be the plastic head on the unit will be cracked and leaking slightly... it builds up pressure then leaks out and tries to build up the pressure again ... Karcher K2.26 Electric Power Washer

Pressure cuts in and out won't stay at full pressure


See attached link ... Karcher G 2600 VH Gas Pressure Washer

Starts but does not keep running. checked oil & its full. do you need water pressure at the pump? I know it has a low oil pressure cut off.


First: check and change the spark plug and do a oil change (OIL IS NOT THE PROBLEM BUT IS GOOD TO DO IT) then do a test with fresh gasoline.\012Second:check all fuel components (LINES,CARB,ETC...)\012Third:if any of this fix the problem ... Dewalt DPD3100 Gas Pressure Washer

Pressure washer cuts off when I pull trigger on wand. I changed the oil it is getting better but seems the oil sensor is cutting it off.


Float may be sticking in carb. ... Karcher 2500 PSI Pressure Washer

Sporadic pressure The pressure on my washer cuts in and out continuously, two seconds of power followed by two seconds of nothing. I have tried to take the lance off to see if it is blocked, but it seems to be stuck fast. Any help would be welcome, thanks in advance.


OK. Pulsing on and off is quite common. Unfortunately, it can have several possible causes.\015\012\015\012If the  machine pulses while you are squeezing the trigger, and there is water coming out of the jet, then most probably the jet is ... Karcher K2.26 Electric Power Washer

My kew alto force pressure washer would normally cut out and start again in about 30 minutes. now it will not start at all. i have dismantled the pump from the housing and everything looks ok even the pressure switch is very clean. Could it be the on-off switch that is faulty. any help would be appreciated. fg


... Pressure Washers

John deere A 16 pressure washer electric, pump faltering, intermitent pressure changes, motor seems okay running independently. Are parts for A16 pumps available?


... Electric Pressure Washers

I have a 2700 axial pressure washes it look like it to much pressure on it and then cut off


... Apache 2700 PSI Axial Pressure Washer Pump

No spray At low pressure have a slight stream of water. When I pull the nozzle back to go high pressure it cuts off completely. Cranks/runs ok.


I have a G 2600 VH psi which isn't listed here, I have need to order a part that isn't listed, this part goes into the detergent tank that monitors the difference between types of nozzle is attached to hose, what is it call? ... Honda Maxus Pressure Washer MX5222

The pressure washer is cutting off when i pull the trigger to wash. The honda engine seems fine. it just stalls when i try to pressure wash.


... Pressure Washers

My karcher 2.54 every time i switch on it cuts out the pressure washer seen to be working ok water running ok but when i connect the trigger gun and switch it on the power cuts out


... Karcher K2.26 Electric Power Washer

No water pressure. feels like it is developing pressure in the pump but wont deliver more than a small stream and then enging cuts out like it is bogging down


Sounds like it could be just a main jet bloked in your lance. Please remove the jet and see if you have a good water flow when pressing the trigger. ... Honda Maxus Prosumer MX5223 Pressure Washer

My Troy Built pressure washer shuts down when I turn on the water. Is the pressure cut off valve that might be frozen?


Hold the trigger of the pressure nozzle open. Turn on the water . Wait to see water coming out of the pressure wand.Then try and start the engine. They can get air locked. ... Karcher 2500 PSI Pressure Washer

When i turn my pressure washer on it works for a few mins then smoke comes out of it and it cuts off. i bought it last year and only used it once and this happened when i have tried to use it this year. its a karcher pressure washer thanx


Sounds like a motor problem. ... Karcher K2.26 Electric Power Washer

I have a craftsman w/ honda model # 580752060 pressure washer. Started washing & after about 10 min. lost all pressure, no water comes from nozzle while engine runs. Cut off engine & nozzle sprays


You have a clog somewhere ... Craftsman 2600 PSI Honda Powered Pressure Washer

Excell pressure washer 2600 5hp honda runs bad when it gets warmed up then just cuts out


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0620 seconds