Having problems with your Pressure Washers ?

I got a homelite electric pressure washer it won't start


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Karcher K5.86m pressure washer and the electric motor wont start. I've done the obvious like fuse in the plug etc. It was working fine one day, then got it out again and everything seems fine except the pressure pump wont start when I press the on button.


... Karcher Pressure Washers

I got a homelite electric pressure washer it won't start


... Pressure Washers

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

Electric pressure washer wont start


... Pressure Washers

Can't start the Honda GX160 5.5 HP Electric motor on my Chore Master 2400psi Pressure Washer. Got gas (checked through feed line), new spark plug, switch on, gas, choke ok, throttle a bit funky (about 12 years old on loan from a friend unused for 5+ years, no manuals). Recoil string sounds close to kicking over, but pretty half-heartedly ...


Is there an oil sensor unit if it is going bad it tells the engine the oil low and engine wont start. I had same problem with my pressure washer, i just unplugged the sensor unit and it started fine ever since ... Pressure Washers

I accidentially sprayed water on the pressure washer motor and got it wet and the pressure washer stopped and won't start up. Will it start back up after things dry out or is the motor broke?


Yes it most likely will, BUT you need to dry OFF ALL electrical items well.\015\012\015\012Check also that you haven't dislodged anything from the system.\015\012\015\012If it still will not go, you may need to use WD40 or similar water d ... Pressure Washers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

DeWalt DP3750 pressure washer wont start. The last


... Dewalt 3700 Pressure Washer

Karcher pressure washer WONT START - Pressure Washers


... Pressure Washers

Pressure washer got wet and will not start - Briggs & Stratton 2200 PSI Gas Pressure Washer


... Briggs & Stratton 2200 PSI Gas Pressure Washer

Pressure washer won t start - Homelite Pressure Washers


... Homelite Pressure Washers

Pressure washer will not start - Electric 1600 Psi Pressure Washer


... Electric 1600 Psi Pressure Washer

Homelite soap dispenser - Homelite Pressure Washer. EZ Clean 1600 psi 1.3 GPM Electric Pressure


... Homelite Pressure Washer. EZ Clean 1600 psi 1.3 GPM Electric Pressure

When I turn on the shop force 1750 electric power washer I get water pressure in intermittent time frames. For example, it may run for a second then stop for ten seconds, then start again for three seconds then stop for 3 seconds then start for a half a second then stop for five seconds etc. until ?. This type of pattern continues for at least ten minutes, which is when I give up. I have tried adjusting the the water hose pressure, high, low. middle, nothing changes. This happen when I have the


The usual cause of this is sticky Orings in the water admitance valve.\015\012\015\012Take the valve apart and clean the bore with crocus cloth wrapped around a rod and replace the Orings and lube with a bit of plumber's grease and reasse ... NIB Shop Force Universal Pressure Washer Accessoriesnib

Wont start I have a North Star pressure washer that has been in storage for three years.It has the Honda motor GX 160 5.5 I put in new gas changed the oil, air filter,and spark plug.But it wont kick over. Im not sure how to work the levers upon starting it.Theres one for gas, choke,idle,and of course an on switch.Please help


Tip a cap full of fuel in top of the carb to start intitially, check for spark as common fault is on/off switch, If no spark, link the 2 wires on on/off switch together. ... Pressure Washers

Excell pressure washer wont start - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


Check gas, off/on switch,spark plug and magneto for spark ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Honda 11.5hp pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Why wont my generac pressure washer start - Pressure Washers


... Pressure Washers

Hondar 2500 pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Troy-bilt pressure washer 2350 psi wont start after use


... Pressure Washers

Homelite pressure washer won't start after warmed up


... Homelite 308451006 Pressure Washer Wheel 12 X 2 "

My Karcher K9.8 electric pressure washer started


Not Simple.\015\012\015\012I have the same Problem, the leak is from the seam of the Manifold or on the pressure side of the Pump and the hose housing. In my case there is a small crack in the seam of the Manifold Housing. A manufacturing def ... Karcher 1750 Psi Elec Pressure Washer

I have a Husky gasoline pressure washer. The honda motor starts but stalls because the pressure by-pass (not the right term) doesn't seem to open and builds up pressure. I haven't tried to remove any parts yet. I think grit has got in but don't know for sure. The pump looks pretty simple and the part I want to remove for cleaning looks like a plastic hexagon nob. Will this access the by-pass or is it something else.


I think you're right about the knob, but try this:Open the water to the washer. Leave the line open, and hold the trigger down to get all of the air out of the supply and discharge lines. While still holding the trigger down on the spray gun, ... Pressure Washers

I have a Kracher K 4000 GS pressure washer and it seems to have been fine until today. When I start it and squeeze the trigger there is nor pressure, water comes out but as it would normally from the hose. The engine does not even seem to be under load. I used it the other day and got pressure when I picnhed off the soap hose but that did not work this time.


... Karcher G3025OH Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1043 seconds