Having problems with your Pressure Washers ?

Soap wont feed thru hose on pressure washer. - Pressure Washers


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Soap wont feed thru hose on pressure washer. - Pressure Washers


... Pressure Washers

Soap feed The soap feed hose on my Karcher 2650 does not suck up the soap into the washer. I pulled off the connector piece that the hose is connected to. I can blow through the hose. There is a little metal finger thing that you can tell pushes up into place when the water pressure is high. It seems like it is supposed to drop down and allow some soap through when the water is running. I found a loose(attached to nothing) gasket, looks like a little donut. It was just free floating in t


I fixed mine works good too, watch my video step by step i put it on youtube ... Karcher G2650HHR Gas Pressure Washer

I have a Husky pressure washer with a Honda 2600psi engine. Problem is, no water will come from the pressure hose. I connected the water w/out the pressure hose and water flows thru strongly. I then connected the pressure hose w/out the wand and water flowed thru the hose fine. When I connect the wand and pull the trigger, nothing. I have replaced the wand and that was not the problem. Please help.


Check the quick disconnect to the wand these are spring operated and can get stuck ... Pressure Washers

Husky HU80722 model Water flows thru the washer. Have disconnected all hoses, checked filter screen it is clear. Reconnected hoses, Engine runs fine home water pressure fows through washer. Still not producing any pressure.


... Northstar Pressure Washer 3000 PSI

I have a Kracher K 4000 GS pressure washer and it seems to have been fine until today. When I start it and squeeze the trigger there is nor pressure, water comes out but as it would normally from the hose. The engine does not even seem to be under load. I used it the other day and got pressure when I picnhed off the soap hose but that did not work this time.


... Karcher G3025OH Pressure Washer

Briggs and Stratton Troy Bilt gas pressure washer one year old. I can get water thru pressure washer and bleed the air, water comes out the hose just fine until I start the pump. Then, I lose all water flow. Pump runs fine but when it's running, no water goes through.


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a Ridgid 3300 PSI pressure about 1 year old. Works great on pressure but stopped dispensing soap its not stopped up but just wont pump soap out of container, the hose does not have a hole in it


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

We have a Karcher G2500VH pressure washer. If you start the engine with the trigger pulled on the spray wand it will run at full pressure until you release the trigger. after that, when you pull the trigger it will not have any more pressure than the water hose feeding it. Does it have an internal unloader valve? What is the part number?


Hi, Karcher calls the unloader valve a spill valve, this is a link to a full drawing/parts listing , and your fault description might well be a sticking /seized unloader(spill ) valve hope this helps ... Karcher 2500 PSI Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

The soap will not dispense--how can I fix it? ... My Aquatak 150 pro x wont draw detergent from the two small detergent tanks at any ... soap not pulling on low pressure. opposite water going thru pick up into container The check valve on the .


... Bosch AQUATAK 150 PRO X Pressure Washer

Comet 2.5 Gpm pressure washer pump wont **** soap anyone know what you have to do to make it start sucking soap


I have found many comet pumps to be plumbed wrong from the factory. Look on the side of the soap injector and look for the flow arrow, make sure its in the right direction. If it has worked in the past,then take it apart and replace the spring, check ... Comet GXD2527G Pressure Washer Pump

Pressure washer wont **** soap


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I have a honda 2600 pressure washer. After running fine for a couple of seconds the water will stop flowing out the tip. It is receiving water,but will not flow it to the pressure hose. I even disconnected the pressure hose and no wate was flowing out. When I shut the pressure washer off it would then flow water to the hose again. Please help


This is a symptom caused by a sticking Unloader valve. The Unloader valve is inside the pump outlet body under the large black knob. \015\012Example picture : ... Honda Black Max 2600 PSI Pressure Washer

Water is coming out of the soap suction hose - Karcher PSI Electric Pressure Washer


There should be a ball check valve in the soap suction hose lets soap in keep water out poke a paper clip in the hole a few times soap will build up there and make the ball valve leak ... Karcher PSI Electric Pressure Washer

Northstar pressure washer will not mix soap to send out hose


... Northstar Pressure Washer 3000 PSI

Soap dispencer wont work - Karcher Pressure Washers


It will only work if you have the soaper nozzle attached ... Karcher Pressure Washers

I have a 2200 Troy Pressure washer, I cannot get it to draw a detergent solution. I am using the black soap nozzel, i have a new siphon hose. any ideas?


Dismount the bolt that is use to connect the soap line.Turn on the washer and test if you fill if is "suction" intake air.Sometimes it becomes clogged so see if anything is clogging the suction .Is that not work the suction system is bad. ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Can't get soap to feed into system - McCulloch FHH18A Electric Pressure Washer


I have a SIMONIZ S2000 electric. I bought the unit about 8 weeks ago used it once. On the second use yesterday the unit didn't work as well, the pressure seemed only a bit better than hose pressure and soap did not dispense at any pressure. SO.... af ... McCulloch FHH18A Electric Pressure Washer

HONDA PRESSURE WASHER WILL NOT PULL SOAP..SPRING TURNED IN FEED


... Honda Maxus Pressure Washer MX5222

My fridgidare dish washer work except it wont drain. i vacumed the line is clear. and the bottom of the dishwasher drain is clear . i vacumed all the water thru the hose. is thi a bad pump? and what is the part #


... Electrolux EDW7505HSS Dishwasher

I have a Craftsman pressure washer model 580.752020. I ordered a pressure hose according to the manuals parts list (203961GS) but does not match the original hose I removed from the washer. A hose #31


... Craftsman Pressure Washers

DeWalt DP3750 pressure washer wont start. The last


... Dewalt 3700 Pressure Washer

Water coming out of the soap dispenser on the pressure washer


I would suspect a piece of debris is caught under the injector ball valve. It may also be clogged with soap if you failed to flush it clean after the last use. Disassemble the valve and give it a good cleaning. Be careful as there is a small ball bea ... Karcher PSI Electric Pressure Washer

Pressure Once I have the powerwasher started and going (water to it before starting) i can't get it to go to full pressure it will prime up like it's going to go to full pressure give me just a shot of full pressure then go back down to probably half pressure and remain there then prime again for a second then back a coninues cycle! Maybe there's a seal or something somewhere I should look at. Hose and pressure from house is good, the seal whee the hose attaches to the bottom of the washer is ne


This is usually a problem with the "dump valve" defective in not being able to hold the pressure but only able to release it prematurely as it should only do so when to much pressur is built up inline. Only recommend qualified pump tech. But check pu ... Coleman Pressure Washers

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1279 seconds