Having problems with your Pressure Washers ?

How do i drain the oil from a honda gcv 190 - Pressure Washers


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do i drain the oil from a honda gcv 190 - Pressure Washers


... Pressure Washers

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

I have an Honda 415 GCV 135 pressure washer 2200PSI how do I change the oil where?


... Honda Pressure Washers

How to drain the oil from a simoniz 2600 honda gcv 160 5.5 preasue washer


... Honda Black Max 2600 PSI Pressure Washer

My Honda gcv 160 is leaking oil - Honda Black Max 2600 PSI Pressure Washer


... Honda Black Max 2600 PSI Pressure Washer

Where is the oil drain plug located on a Homelite 2700 psi 2.3 GPM Honda Gas Pressure Washer?


There is drain plug, surprisingly. You basically have to tip the washer over to the side opposite of the exhaust. I like to take the wheel off first. It is much easier this way. You don't want oil to get in the exhaust Or you could get something lik ... Homelite Ut80993 Honda Gas Pressure Washer

Where is the oil drain plug located on a Homelite 2700 psi 2.3 GPM Honda Gas Pressure Washer?


... Homelite Ut80993 Honda Gas Pressure Washer

We have a Honda GCV 190 gas pressure washer. It starts up okay and runs for 20-45 seconds and then stops. We have changed bot the gasoline and the oil but run into the same problem.


Check that the fuel tap is on ... Honda 2500 PSI Gas Pressure Washer

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

No soap to power washer honda gcv 190 - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

I have an excel pressure washer 11 hp Honda engine. water is leaking into the cat pump 4hp40gl causing the oil to become milky, after the washer sits overnight the oil clears up. Any and all help will be appreciated. Thanks


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

What causes pressure washer to spit oil - Honda Pressure Washers


... Honda Pressure Washers

Honda engine oil leak pressure washer - Pressure Washers


... Pressure Washers

I got the pressure washer started - lots of smoke etc after not having used 3 years. I then poured in wrong oil to top it off - my brother's chain saw bar oil. DARN. After 3-4 minutes it started rattling and stopped. Can't pull the chord to get started. Did it seize the engine? I have drained all oil. Can I try using a cleaner, light weight oil to try to unlock it?


Nope! you have blown the seals and most likely the cylinder is full of water. You will need to take it to the repairer to have it cleaned checked and new seals fitted. $200 ... Karcher 1750 psi Electric Pressure Washer

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

There are 2 different places to add oil to my 3500 Honda engine pressure washer (cold). Do I use SAE 30 for the motor oil and gear oil for the other oil?


You can use sae 30 in the motor and hydraulic oil or gear oil in the pump.\015\012just note that there may be two oil filler holes on the motor. ... Honda Landa PG 3500 PSI Pressure Washer

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

Honda GCV 160 5.5 pressure washer dies when I pull the gun trigger


... Pressure Washers

My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it


Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

I have a troy build pressure washer model number 020337 Do I need to change the oil in the pump, and if yes how do I drain it and what kind of oil. I know how to change the engine oil


The pump requires no maintenance and no oil change. It is lubricated for life. ... Karcher 2500 PSI Pressure Washer

My honda pressure washer runs put there is no pressure when i pull the trigger. we have checked the oil and everything, the water comes out just no pressure.


Check to see if you have an obstruction in the hose or tip. If clear you have a problem with the unloader valve. This valve sometimes gets stuck and continually recirculates the water not allowing you to build pressure. Sometimes you can remove and c ... Honda Maxus Pressure Washer MX5222

I have a Coleman powermate clean machine pressure washer 2500 psi 2.36gpm and has a 6x200 honda 6.5 horse motor. I just bought at a garage sale.It started just fine when I got home and in less that 2 minutes quit. It says the engine will stop automatically when low on oil. what kind of oil should I use and for the pump what kind of oil do you use?


... Coleman Pressure Washer PW0881800

WhaT KIND OF OIL do we use in a Honda gx340 pressure washer?


... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0899 seconds