Having problems with your Pressure Washers ?

Briggs & stratton 6.0 hp pressure washer won't start

\015 I replaced spark plug, and nothing.\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Excell pressure washer wont start - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


Check gas, off/on switch,spark plug and magneto for spark ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Craftsman 2500psi 2.3 gpm briggs and stratton pressure washer wont start


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

Have a Husky Pressure Washer 2200 psi, HU80931. I don't have an owner manual. It has set for about a year. When I started the washer there was very little pressure. Did some cleaning and it was a little better, but now there is no pressure and I am having trouble keeping it started. Can you help? The washer was purchased at Home Depot and it has Briggs and Stratton the the washer too. Thank You, RJ


Look at eReplacementParts.com and the parts diagrams ... Briggs & Stratton Pressure Washers

Briggs and stratton sprint 3.75 pressure washer wont start and spits oil out exhaust


... Pressure Washers

Engine wont start. - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


REMOVE plug and put on to lead and rest plug thread on to a good earth on engine and pull starter cord ,, if spark you have fuel problem ,,If no spark try a nother plug if still no spark remove cowling and Flywheel assy and the spark coil is under t ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Just bought a new Briggs Stratton 6 75 pressure washer. i put in a half a tank of gas in the tank and it started up. i ran the pressure washer until it was out of gas. put more gas in now it will not start.


Assuming you tried choking it when you tried to start it, verifiy its getting gas,if not tap lightly on the bowl of carburator. if it is getting gas, check for spark ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Pressure washer got wet and will not start - Briggs & Stratton 2200 PSI Gas Pressure Washer


... Briggs & Stratton 2200 PSI Gas Pressure Washer

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Briggs and Stratton Troy Bilt gas pressure washer one year old. I can get water thru pressure washer and bleed the air, water comes out the hose just fine until I start the pump. Then, I lose all water flow. Pump runs fine but when it's running, no water goes through.


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Troy bult 2700 pressur washer won't start - Briggs Stratton 198347gs Pump Assembly Kit For Pressure Washers


... Briggs Stratton 198347gs Pump Assembly Kit For Pressure Washers

Craftsman pressure washer wont stay running - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

Power washer won't start - Briggs & Stratton Power Products 1539 Pressure Washer


Have you checked for spark? You can remove the plug, touch it against the block and crank it and see if you have any spark (best done in as dark a place as possible). If you don't have spark, start by replacing the plug.\015\012\015\012 ... Briggs & Stratton Power Products 1539 Pressure Washer

I have a Briggs Stratton Model# 020228 Gasoline Pressure washer with a Faip Brand Pump. The engine starts, the water supply goes thru the pump under its' own pressure. When I pull the trigger on the handle, there is not increase of force nor does the pump engage. I had this same problem several years ago and sent it to a dealer for service. His service tag indicated a stuck unloader. Where is the unloader located on this pump. The indentification on the pump is MTPV90736 191693 Order # 52


... Briggs & Stratton Pressure Washers

My briggs and stratton pressure washer model 020206 starts and runs good but no water pressure coming out of gun...any solutions?


... Pressure Washers

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Two problems please: craftsman 2150psi briggs and stratton engine washer, will not start when hot. and secondly, i was washing with regular pressure, then noticed a pressure drop at the nozzle, then the unit shut down. no water leaks at the manifold. water supply was strong. any ideas?


Nozzle dirty, clean out with small diameter wire. ... Pressure Washers

Pull start locked up on briggs and stratton pressure washer


... Pressure Washers

Craftsman 2400psi 6.0hp briggs & stratton pressure washer won't start


Try and start it with starting fluid if so rebuild the carb ... Pressure Washers

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

My pressure washer a briggs and stratton 550 won't start


Hi and welcome to FixYa. I am Kelly\015\012First off make sure the oil is full in the crank case. \015\012Remove the spark plug and check for spark with the Engine on / off switch ON. \015\012If there is good spark then turn of ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Briggs and Stratton 2200 PSI / 5.50 Pressure Washer won't start no spark


... Briggs & Stratton Pressure Washers

Troy bilt 020245-1 wont mix detergent - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1407 seconds