Having problems with your Pressure Washers ?
Troy bilt pressure washer series 675, why does oil comes out of the air filter?
\015 Oil is coming out of the air filter, there is a tube from the enigne to the air filter. Is it an overflow line?\015
Repair Help & Product Troubleshooting for Pressure Washers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Troy bilt pressure washer series 675, why does oil comes out of the air filter?
... Pressure Washers
Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking
You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer
My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.
I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer
I have a 7 hp B&G craftsman Pressure washer , if I place an air filter on it ,it wound't start or run , if I remove the air filter it would run like a champ, but after 10 mints , oil would shoot out off the carb like a running faucet , why is it not running with the filter on,.Now am not so sure if the air filter is the correct size , because when I put it on it seem to be a bit on the taller size rather than a perfect fit, thanks for your help , in Hollywood , Reinaldo Roman .
First,It sounds like the air filter is full of dirt preventing air from flowing through, starving the engine of air.As for the oil shooting through, are you certain the oil is coming from teh carb?. Makes no sense the engine w ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
Troy Bilt power washer 020293- Oil in air filter
That is incorrect. if the oil has been over filled, it will saturate the filter element by way of the crankcase breather tube. it is the small plastic pipe that connects to the bottom of the filter housing. check the oil level. these machines take ve ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
Briggs and Stratton Troy Bilt gas pressure washer one year old. I can get water thru pressure washer and bleed the air, water comes out the hose just fine until I start the pump. Then, I lose all water flow. Pump runs fine but when it's running, no water goes through.
... Briggs & Stratton Prosumer 20324 Gas Pressure Washer
Troy Bilt Pressure Washer Model 01902 Leaking Gas from Air Filter
Try banging lightly on carberator with block of wood or something to free up float and valve!!!! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer
My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it
Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000
Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!
If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer
Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav
... Homelite Pressure Washers
My pressure washer leaks oil out the air filter. I have removed the filter and it still pours out. it only happens when i engage thw hose.
Hi and welcome to FixYa, I am Kelly. \015\012 [ First check and make sure someone did not over service the engine oil level. ] #1 Cause of oil blow by that happens out of the blue. \015\012\015\012This is happening ... Karcher 2500 PSI Pressure Washer
I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.
Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke
... Craftsman Pressure Washers
My pressure washer is blowing white smoke and i found oil in the air filter
... Karcher Pressure Washers
Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.
... Pressure Washers
Karcher Pro Line HD3000 pressure washer ...engine keeps cutting out when spray wand is at full power.. fresh gas, oil is good, cleaned air filter, inlet water supply is strong
... Karcher G3025OH Pressure Washer
My pressure washer doesnt seem to run properly. i have changed the fuel,air filter,spark plug and the oil. It will start but runs poorly.
Ok the first thing you need to check is if the spark is fireing. To do this you need to remove the plug plug it into the spark plug cap hold it on the cylinder head pull the engine over it will pull easy and see if you have a blueish spark jumping th ... Briggs & Stratton 2200 PSI Gas Pressure Washer
Wont start I have a North Star pressure washer that has been in storage for three years.It has the Honda motor GX 160 5.5 I put in new gas changed the oil, air filter,and spark plug.But it wont kick over. Im not sure how to work the levers upon starting it.Theres one for gas, choke,idle,and of course an on switch.Please help
Tip a cap full of fuel in top of the carb to start intitially, check for spark as common fault is on/off switch, If no spark, link the 2 wires on on/off switch together. ... Pressure Washers
I borrowed my nieghbors power washer. It worked the first day all day. In the morning i filled the gas with a fuel stabiler, and 30 oil. I may have over filled it. Upon turning it on the oil started leaking from the air filetr compartment. It starts, but then smokes starts to fume and all the oil leaks. Did I break it or is it a easy fix. I cleaned the filter housing. Also the filter was soaked with oil. should i get a new filter and install it or what is the solution. need help.
You will need to get a new filter, and drain some of the oil out of the machine. If you over fill these this will happen. 90% of the time nothing is broken. ... Karcher 2500 PSI Pressure Washer
I have a troy built pressure washer leaking gas from the air filter i looked around for advice and hurd bang against the carb and it will realease the float valve i did it and it worked but should i clean out the fuel in the filter area or the filter will it harm it as it is or should it be okay? the filter was soaked in gas dry now and when it happened the gas flowed from the air intake (behind the filter) if i need to clean out in there how do it do it and if i need a new filter
Definetly replace the paper filter and yes Lowes will carry them.if it does not leak now, I would leave it alone or you will be installing a nine dollar kit.The briggs kit # is 294260 is you choose to do it anyway ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer
I have a 2300 psi gas pressure washer, campbell hausfeld, runs fine but water comes out the nozzle like a hose , no high pressure. inlet filter is clean and when you pull the trigger on the nozzle water comes out like a hose but no pressure
If you no longer have High Pressure coming out while machine is running, it's a pump issue. ... Campbell Hausfeld PW2575 Pressure Washer
I think I added too much oil to my pressure washer. It lost pressure after about 20 minutes, then smoke came our where the exhaust area is. I immediately turned it off. Then I noticed oil dripping from the oil filter. What do you might have happened and what should I do?
Drain the oil until the proper level is reached....let the unit sit for awhile until cool and then remove spark plug and clean it....i think it should be just fine....good luck ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle
My Karcjer 2.94 pressure washer is not reaching out put pressure. The motor comes on every now and again. The motor doesn't come on when I pull the trigger. I have cleaned the filter and checked water supply. They appear ok
... Pressure Washers
I'm using a Dewalt 2800 power washer and someone set it on its side. And now it will not start. The air cleaner is full of oil. I think there is oil in the carb. I took the air filter off and almost get it to start. Any help?
Take the air filter off and wash in petrol.allow to dry,and put back on. then take the fuel bowl off and clean.turn fuel tap on and drain fuel from carby for a few seconds.turn fuel tap off.put fuel bowl back on.then take spark plug out and turn moto ... Dewalt 3800 PSI Pressure Washer
Oil plug on troy bilt 020240 pressure washer - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer
... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer