Having problems with your Pressure Washers ?

Craftsman Pressure Washer Model #how do I adjust the unloader on my craftsman model 580752810 pressure washer, Just replaced it and it has considerably lower pressure than before.

\015 The pumo assembly blew one of the "O" Rings from the unloader housing. I replaced it with a kit with a new unloader, and new check valves.now it sprays but has lower pressure than before. From the spray pattern and volume I would say it is about half the pressure. Can the unloader assembly be adjusted or does it have to go to a Sears repair center.\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Craftsman Pressure Washer Model #how do I adjust the unloader on my craftsman model 580752810 pressure washer, Just replaced it and it has considerably lower pressure than before.


... Pressure Washers

I have a craftsman power washer Model 580761800. Motor starts no pressure until you lower the idle.


... Craftsman Pressure Washers

Craftsman pressure washer model 580.752520 - Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

I have a Craftsman pressure washer model 580.752020. I ordered a pressure hose according to the manuals parts list (203961GS) but does not match the original hose I removed from the washer. A hose #31


... Craftsman Pressure Washers

Honda pressure washer model # exhp3640-1 3600psi 0=13hp has low water pressure out of triggers motor does not engage for higher pressure


... Pressure Washers

I have a craftsman w/ honda model # 580752060 pressure washer. Started washing & after about 10 min. lost all pressure, no water comes from nozzle while engine runs. Cut off engine & nozzle sprays


You have a clog somewhere ... Craftsman 2600 PSI Honda Powered Pressure Washer

Craftsman model 580-768332 psi 2400 - Craftsman Pressure Washers


... Craftsman Pressure Washers

Good afternoon - I have a Whirlpool model LSR7233EQ0 washer. The washer works fine in regards to draining, filling, lower agitator works...however, the top agitator does not engage and almost sounds like grinding. However (I know you are not supposed to do this), when the machine is in the wash cycle, I push sideways on the top of the agitator and it then does engage and agitate. When I release pressure, the top agitator does not work. Thanks for your help, Michael


Whirlpool uses a split agitator design. The upper portion is called the auger, while the bottom is called the agitator. Between these components is a agitator cam assembly. This problem is commonly caused by worn agitator dogs or the agitator cam ass ... Dishwashers

I need a manual for a craftsman pressure washer model 919-769010


... Pressure Washers

Craftsman pressure washer model 580 767300


... Pressure Washers

Craftsman pressure washer model 580.762012: pump does not work


... Pressure Washers

Need manual for Craftsman high pressure washer model 580-768310


... Pressure Washers

Craftsman pressure washer model 580 752360


... Pressure Washers

Won't start - Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model


... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Rockworth Powertask Pressure Washer : model no AROW4P seems to rev flat out, hav to put choke in middle to use so not to fast revs. Im sure it used to rev higher and lower according to use of lance. could it be something to do with 3 valve things if so how could i tell if ok. put clean fuel in. oil level ok.another problem is when switched on water comes straight through lance,trigger makes no diffrence. please help


... Pressure Washers

Torque foe head bolt on Craftsman High Pressure Washer 7.0 Horsepower 2900 PSI 2.3 GPM Model Number 580.752410


... Pressure Washers

I have Craftsman 6.75 horsepower pressure washer model no. 580.7527000 I starts and then shuts off.have change spark plug. still runs a short time and dies.


Replace the gas, check the air filter is not clean. ... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Owners manual for Craftsman pressure washer model No. 580.767100


... Craftsman Pressure Washers

Craftsman model 580.752020 electric pressure washer. First time I used it worked for about three minutes then the motor stopped. I cannot get it to start again. Plugged into a 15 amp gfi circuit which did not trip. The light on the plug is red as per instructions. Unit is beyond warrenty. What to do?


Turn off water and machine electrics.remove high pressure hose from front of machine, this may be tight if there is still pressure in the system.turn on water, when water comes out of machine hose outlet turn on machine. does the ma ... Electric Pressure Washers

Pressure washer model 580.768310 craftsman service manual


... Pressure Washers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

Craftsman pressure washer model number 580753400 carburator repair diagram


Http://www.karcher.com/int/contact.htm\015\012\015\012use this link to contact karcher, they will email you a diagram. ... Pressure Washers

Users manual for a craftsman pressure washer model 580 761800


... Pressure Washers

The torque for head bolt for Craftsman High Pressure Washer model # 580.752410 7.0 Horsepower 2900 PSI 2.3 GPM


... Pressure Washers

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1422 seconds