Having problems with your Pressure Washers ?

My clarke pls 190 pressure washer wont start, i have renewed spark plug, checked oil level, etc


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My clarke pls 190 pressure washer wont start, i have renewed spark plug, checked oil level, etc


... Pressure Washers

I have a Baldor 6000W generator with a gx340 11hp engine. I have drained the tank and carb and put new gas and sea foam in it. Also I have replaced the spark plug and fuel filter. The engine will start/run as long a I spray starting fluid in the carb. But it will not continue to run without it. Also I just checked the oil level and that is good. Please help!!!


It sounds like the engine is not getting enough fuel for it to run. First check that you have the fuel tap in the on position. If the fuel tap is on then the carby might be blocked or the needle & seat are not working properly. Turn the ... Honda 8 HP Engine

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

My gas power washer will not start. I filled the gas, checked the oil, set the choke, made sure it was on, changed the spark plug, checked the air filter, and drained any water. When I pull the cord to start I don't even get a putter. Anything else I can try or do I need to take it to a service place.


Will it run if you pour a small amount of gas in the carb? If so, it's a fuel supply problem. Most likely a stuck closed float needle. ... Honda Maxus Pressure Washer MX5222

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Bought unit new last summer. Used it once last summer and once this year. It started fine both times. Today, it will not crank. I have replaced the spark plug, checked the air filter (it is clean), gas tank is full and added oil. Why won't it crank?????


Unable to crank? Do you mean unable to start?If you leave gasoline inside tank over long period of time, that will 'gum-up' and ruin carburetor.To prevent problem, put additive in gasoline or empty gas from tank:: under gas tank sho ... Craftsman Pressure Washers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

My zanussi zdf131 has not caused any problems during the last year or so since i purcheased it, but now all the dishes etc come out with a "bloom" of white over everything. I've checked all filters etc, run several cleaning programmes but I've now noticed that the salt level does not seem to be going down. I check it every week & refil but this time the salt has been in the reservoir for several weeks & doesn't seem to have changed - could this cause the problem & if so why is the salt level not


... Zanussi Dishwashers

Won't start I have checked the spark plug and I have good saprk. I have checked the fuel sysstem and the primer bulb injects fuel. I have removed the head and cjecked for engine damage and all cycle correctly. Vaves opne on time piston shows no dmagae. side walls are smooth and not damaged. This engine was working fine but the pressure washer needed some O rings replaced. I have tried to start it with and without the pump attahced. Evrything on the engine looks fine. I removed the spark plug and


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?


If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

Have a PD2800 that has started to leak oil. lowered the oil level slightly but it started to again leak oil after just a minute or two of running from a cold start. Oil seems to be coming either from around the oil drain plug or from underneath the motor mounting plate. any ideas? Richard


Hi,There is a nice Troubleshoot article :-http://www.the-power-washer-advisor.com/pressure-washer-pump-repair.htmlHope i helped you.Thanks for using "Fixya". ... Dewalt Pressure Washers

My BE Honda 5.0 2900 psi pressure washer has oil in air filter. I believe it is because my buddy left it tilted to the side in th ecar when he borrowed it. How can I fix it? It is probably low on oil as now due to this. How much oil does it take? As there is no dip stick to check the level, Do I need to empty it all out and refill it


Hi there ibharti sounds like gx 160 honda ohv engine \015\012\015\012replace the air filter if it has been wet with oil, , remove the float bowl and check for oil in the carb, blow the jets out, top up the oil to the point o ... Honda Pressure Washer PSI 3000

Checking pump oil level ic2 pump, intermitant pressure loss


... Pressure Washers

I do need the igniter for the burnner / my igniter i think it is the wrong one , it is too shot and the spray of oil do not fire/ i think the 'plugs' is little short to ignite on the spray , comes on and off / but i have sparks all times, only dos not get fire , do i need longer plugs !!!do go under the noze of spray!!


Send me a email at [email protected] I am an dealer for Northstar and many other brands of pressure washers. I need the model number off the machine if you have it. I can get you th ... Northstar Gas - Powered Wet Steam & Hot Water Pressure Washer 2700 Psi, 2.5 Gpm

Out of the blue our Jen-aire jdb1105aws doesn't want to power up. No lights, no cycles etc. Checked the plug etc and no tripped fuses. Any thoughts appreciated.


If there is power present on the controller but not outputting to the circuits then it is possible toi have the controller faulty which can be getting error messages/fault messages from the sensor or a failure of the main board.. ... Jenn-Air JDB1105AWS Stainless Steel Dishwasher

Unit shows no signs of life. Removed rear plug to check that 118vac present @ rear plug. No other lights/sounds, etc. Circuit breaker has been cycled.


... Bosch SHE68E15UC Dishwasher

I had gas problems cleaned the carb,brass tube,filter many times. engine would start run for 20 to 40 sec.start to hunt than stop oil is new at correct level even unplugged the level device, the same results. ordered a new carb. installed it same results taken cap off tank to check if it is not a vent problem.I have tried everything, HELP


Try to start it and then start spraying with it to make sure that your pressure relief valve is working. My son-in-law had this problem and it was because the pump built up so much pressure that the engine couldn't overcome it and it would stall out ... Honda Pressure Washers

Engine starts, but when i push in the choke, it kills. i just replaced the spark plug, drained the gas and oil and replace with new gas and oil. Starts fine when choked, but when i push in the choke, it dies.


... Honda 50 W Ar Pump 2500 Psi 25 Gpm Pressure Washer

My Karcher 2400 PSI pressure washer is not starting after about 5 years. What type of spark plug and gap should I change the old out with and what kind of oil do you recommend. I don't think I have ever changed the oil but way less that 50 hours on the machine. Thanks


... Karcher 2500 PSI Pressure Washer

Bosch dishwasher causes short circuit trip when door closes. Plug and socket checked and ok, water outlet checked and no blockages. Panel lights come on ok when machine switched on, able to select washcycle etc ....trip happens immediately door closed.


... Bosch SHU5315UC Dishwasher

John Deere 3300 PSi pressure washer shutting off while in use.Everything appears fine Oil level,Gal level,Air cleaner ok etc.. May run 2 minutes or 12 minutes then spudders a bit then Bang "Off" as if i turned it off.May or may not restart after a couple of pulls.


John Deere will replace the cap for free; they acknowledge the vendor who supplied Briggs & Stratton gas caps provided faulty caps. Call 1-888-228-3068 then 1 (English), 2, 1 and a technician will ask you for model number and Serial Number ... Dewalt 3800 PSI Pressure Washer

My dishwasher will not drain. it goes through the first 10 minutes of a program then i get the OE error code. i have checked my hose for kink or clogged-there is none, i have made sure it was level. i would like to get the filter off but it looks like i would have to take the drain pump out from the bottom to check if any thing is plugging it. was just wondering if anyone has any tips that would help. thanx


1)check the drain pump working\015\0122)check any block from drain pump to drain hose. ... LG LDF6810 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0942 seconds