Having problems with your Pressure Washers ?

How do I replace the leaking gasket on my HPW2201 homelite pressure washer


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I replace the leaking gasket on my HPW2201 homelite pressure washer


... Pressure Washers

I have a karcher 4.6 pressure washer that developed the usual fault.... drop in pressure and leaking from the cylinder head. I have replaced the cylinder head and the attached control chamber. The pressure is now good again and the leak is fixed. Unfortunately now when the trigger on the lance is released the the machine does not switch off automatically. I have bled the machine by letting water run through it


... Karcher Pressure Washers

I have two DeVilbiss issues: First, on my pressure washer, I no longer get pressure on "high" mode from the hose. I prime the pump but it doesn't seem to be creating enough force for a high pressure. Second, on my generator, the gas from the gas tank leaks out. The tank is plastic or poly and don't know if it's a gasket issue.


... DeVilbiss Pressure Washer Hose 3600 Psi 25'

RY80940 The valve under the pump is leaking. I think it is a pressure release valve but I am not sure. I tightened it when I had to re attach two bolts that were holding the motor on the metal case then it worked for awhile then it started to leak and I lost all power. Should I tighten or loosen it or is there a washer that needs to be replaced?


... Pressure Washers

I own a 3800 psi pressure washer since two weeks. For the second time now the tip of the extended nozzle is leaking and makes it unusable. I have already replaced it the first time but today it happened again. This would be the third tip that needs to be replaced in two weeks.


Sounds like that wand or tip under engineered OR INCORRECT WASHER TYPE ... Pressure Washers

My power washer sprung a leak down in the pump housing with a gasket between two cast pieces of the pump. Is this just a simple matter of replacing the gasket and also what may have caused this? It is factory reconditioned unit directly from Briggs and has only been used four times.


... Briggs & Stratton 3000 PSI Pressure Washer

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

I have a 1750 huskey electric washer gun leaks when pressure water is on can i replace o rings


... Pressure Washers

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

My Karcher K730 MXS pressure washer was leaking water out of the rear of the gun handle. I bought a replacement hand gun and the new gun is doing exactly the same!


... Karcher Pressure Washers

Remove&replace gas tank on a homelite 2600 pressure washer mod# ut80522


If you are in the UK we have found these parts to be available from Ryobi but they dont often make the engines... identify the engine as this is who will make the fuel tank ! ... Homelite Pressure Washer. 2600 psi 2.3 GPM Gas Pressure Washer UT80522

Have a homelite 1700 pressure washer with broken two mixture spray handle. What do I replace this handle with?


... Pressure Washers

Campbell Hausfield Pressure washer model 1549. After a few years of storage, I cannot prevent the powerful spray leaking from the connection between the Gun and the Lance. I replaced the O-Ring, and tried other means unsuccessfully. Spray from the joint is almost as powerful as spray from the lance nozzle. The Briggs and Stratton engine has been cleaned and operates well. The pump operates well. But the lance connection refuses to seal.


Hello,Most likely, the housing has split and seal is not being made. There is a chance that the hose is leaking where the fitting is crimped on (my experience, but different pressure washer). Are you able to see a leak when turned off b ... Campbell Hausfeld Pressure Washers

HPW2201 starts and then stops - Homelite Pressure Washers


... Homelite Pressure Washers

The power washer leaks fro the base when pressure is applied. I removed the bottom housing and the round gasket that houses the bearing is badly damaged. I would like to obtain a repair manual and possibly order some parts. email [email protected]


... Pressure Washers

My homelite 2200 pressure washer leaks fuel outta the air filter area. There's a brass, looks like a bulb, fittting underneath it with holes for 2 brass screws, only one screw is in there and the other empty screwhole is where the fuel pissin outta. Just bought earlier today, when I ran it, I only got a few minutes usage. Should there be a screw there perhaps? Is it missing?


... Homelite Pressure Washers

Had the Northstar 3000 psi Pressure Washer for 2 months and it started leaking oil from the pump during use. Took it to Northern and they are replacing the pump under warranty but said it was likely because I was using quick connects on my garden hose coupling and that was restricting the water flow making the pump overheat. They said never to use quick connects on the garden hose unless the opening is at least 5/8". Does anyone make such a quick connect? I hate having to screw the garden hose o


It is easy to check if your hose and quick connects are supplying enough water to the pump. Your pressure washer gallon per minuite requirements are printed on the machine and also on the pressure tips in GPM. Your post indicates 2.5 gpm but check yo ... Northstar Pressure Washer 3000 PSI

I have a Durabuilt model DB1303 pressure washer. The detachable arm connecting the adjustable nozzle has sprung a leak. Can you locate a replacement...if so how much?


Http://www.kwpressurewasher.com/Pressure-Washer-Accessory-c4.html\015\012\015\012Maybe these guys can help... ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Rotary shaft seal leaks oil - Homelite 308653006 678169004 Pressure Washer Pump 2600


... Homelite 308653006 678169004 Pressure Washer Pump 2600

I have a homelite honda pressure washer 3100 psi less than 2 months. I used it and after 2 week tried to use it again it ran fine but very rough on idle. Replaced gas and added stabilizer still rought


... Psi Pressure Washers

Have a home lite pressure washer model ex 21 wheni plug the pressure hose into mashine bad leak at connection and no pressure is there an o ring missing some where


... Homelite Pressure Washers

Owners manual Homelite pressure washer - Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer


... Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer

I have a Karcher 550M pressure washer and was using today when all of a sudden the water started to pour through the handle hence lost the pressure of the water. Is this a rubber washer issue or the gun needs replacing or simpler than that. To be honest although I have had the washer for about 3/4 years now It is hardly used. Also can I fix it and where would I purchase the allen key to replace. Thanks Brian


... Karcher Pressure Washer Gun 91120200 91120200

Craftsman Pressure Washer Model #how do I adjust the unloader on my craftsman model 580752810 pressure washer, Just replaced it and it has considerably lower pressure than before.


... Pressure Washers

Kenmore dishwasher door leaks replaced gasket still leaks model#665.15669992 gasket replacement sears #3376927


Check your overflow float inside the machine. it looks like a small hat or cone. it should move freely up and down. if it is stuck down, the water will continue to flow in. the gasket is designed to stop splashing water. it is not an underwater ... Kenmore 24 in. 15689 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1552 seconds