Having problems with your Pressure Washers ?

Troy built primer but has factory hole in it..WHY? it wont run unless i plug that hole with my fingertip!

\015 Why is this hole there?\015

Answers :

What is the model number?
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Troy built primer but has factory hole in it..WHY? it wont run unless i plug that hole with my fingertip!


What is the model number? ... Pressure Washers

Smasungdishwasher DMT610RHS error codeCE showsup. eventhough the is not locked in, it still runs with error code CE, but the water is not coming in. but the motor is running. unless I plugged out, it keeps running. I shut off, but not responding power ONOFF.no response to any button on the control pannel. but keeps running.


... Samsung Dishwashers

Model EXVRB2321 would run only with full choke, now wont start after cleaned carb,tank,what is the plug gap,I got a champion EZ start5843spark plug, replaced fuel line pvc boot, getting juice to plug and compression is 60 to 62 lbs psi.


... Briggs Pressure Washers

Stored for a year. i changed the spark plug and the fuel. i also cleaned the carb. water runs through the pump. but it wont stay running. it wants to start but only runs for a few seconds. i think it might be a fuel flow problem but im not sure.


Sounds like the float my be partially stuck closed. It allows enough fuel to run a few seconds then the engine uses it faster than the float lets the fuel back in. I would remove the float bowl and flip the float up and down a few times to make sure ... Honda Pressure Washer PSI 3000

My honda gx240 8 hp wont run unless I choke it


... Honda 8 HP Engine

Pressure washer wont run unless choke is on


I have a Karcher pressure washer w/ a 5hp Honda engine. It only will run while the choke is pulled out and only runs at about half the rpm's. When the choke is pushed in.. it coughs, sputters and shuts off. Can you tell me how to fix this.... ... Karcher 2500 PSI Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Asko d3120 i hear the dishwasher running ( the cycle i s not running just the sound of it )and it wont shut off unless i unplug it i cleaned out all the water and the drain hose is clear i pressed the on/off button together with the cycle on button to no avail.


If what is mentioned is correct to me, the motor or pump is running at times and you can hear the humming when the machine is plugged on. Your resetting also does not help to get the machine to run the program. It seems to me that the error is in the ... Asko 24 in. D3120 Dishwasher

Hello i have a Honda GX160 and the engine will only run on choke if i close it the engine just splutters and thats it. it wont run at the norm i have replaced the carb the tank the air filter and the spark plug and know luck i have no more ideas as to what the problem really is thanks jord


Ii know you must have replaced the fuel filter. Did you replace the fuel line? It is obvious it is not betting enough fuel or it is out of time. Have you tried adjusting the jets on the carb? Have you checked the timing? There is a crankshaft key-way ... Honda Pressure Washer PSI 3000

Hobart LX30 Hey I just bought a Hobart Lx30 and we don't have a power source that can handle the 50 amp requirement. We got it at an extremely good price so we are trying to work around it. I was told that disconnecting the water heater would allow it to work in a standard 120 volt outlet. I did that and now I have another issue. The machine wont run unless the water is 160 degrees. How do i disconnect the sensor that restricts the temp so that I can run the machine at a lower temp?


Hopefully you took the suggestion to run the correct 50 amp 208-240 service to the unit.Converting the unit to an LX30C has a couple of pitfalls. The LX30C is connected directly to the incoming water supply, which should run 120-140 degre ... Hobart 24 in. LXIH-3 Built-in Dishwasher

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Water wont drain, I have removed drain hose from back of machine run cycle and still nothing more than a trickle. I am guessing its plugged but im not sure of the best way to test or clear the plug. its a bosch


Im a old bosch tech and your problemis in the drain pump. remove 1 screw in the bottom of the unit and you will take off the plastic door, spin propeller and remove obstruction that will do it. if this helps send me a 4 thumbs up post thanks ... Bosch 24 in. SHU43 Built-in Dishwasher

My top drawer of my Fisher and Paykel dish washer wont close tight. It seemed to be jammed and not closing unless it was pushed closed hard and then it jumped a bit now wont close tight and has no resistance at all. If I hold it closed and start it it will run but I think the lids not closing tight?


Make sure the unit is level. Remove drawer. On the inside of the cabnet there are the drawer runners on iether side. Behind these there are a pair catches. If one or both of these are latched back when they shouldn't be, ie. when the drawer is open, ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

HOW DO I FIX MY HUSKY MODEL HU80520 PRESSURE WASHER, IT WONT STAY RUNNING AFTER REPLACING THE SPARK PLUG? WHAT IS THE RIGHT SPARK PLUG FOR THIS UNIT?


... Pressure Washers

Troy bilt pressure washer 2350 psi wont stay running after use


... Pressure Washers

Ihave a Troy bilt pressure washer starts fine will not stay running unless I keek my hand on the handle


The pressure relief valve is stuck take it apart and clean it ... Briggs & Stratton Pressure Washers

Troy bilt pressure washer 2350 psi wont stay running after use


... Pressure Washers

Troy built pressure washer will not run unless the choke is out


... Pressure Washers

Pressure washer wont idle and run


Check the pressure replace valve or a bypass valve ... Karcher 2500 PSI Pressure Washer

Engine wont stay running unless i put my hand over carb then it stay runnin cleaned carb gas is flowing fine engine is on a morta mixer


Hi and welcome to FixYa. I am Kelly. \015\012When you said you cleaned the carb did your remove the float bowl? Here is what you need to do: \015\012\015\0121. Fuel selector off\015\0122. Remove float bowl mounting s ... Honda 8 HP Engine

My troy bilt pressure washer only runs a few seconds then dies.I thought the pump was plugged so I removed pump.While pump was off I ran the engine in case it was a fuel issue,The engine ran fine.Whic


... Pressure Washers

Pump runs continuously...wont turn off unless power is turned off at wall.


... Asko D3122XL 24 in Builtin Dishwasher

Asko d3330 f2 problem have had before and hose was holed,this time flood cleared up left to dry still have f2 and running unless power turned off


... Asko 24 in. D3350 Dishwasher

I have a Bosch Exxcel dishwasher which runs the drain pump constantly even with the door open and despite there being now water in the machine at the cycle wont start. I have checked the warer amtrix and the ffed hose to the sump for blockages. The float switch operates OK but when the water drains down the float drops and the water is pumped in, then the float rises and water leaks out and the drain pump kicks in again and no more ater will come in unless you push the float down. Inside the bas


I am not sure about this model but most models run a drain cycle for a set period at the start of a wash cycle and then move on to normal filling and cycle of machine provided the various switches are at the low level it will carry on to its set cycl ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

The water doesn't spray out and the paddles don't turn during the entire cycle leaves soap running down the door. The washer is a Crosley CDU450V model. I have already checked to make sure the holes in the paddles aren't plugged.


Lower arm does not spin ... Crosley CDU450 Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1147 seconds