Having problems with your Pressure Washers ?

Honda gcv160 gas leaks out when running


Answers :

Hi james
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Tthere is gas leaking from the carburetor on a Honda GCV160 pressure washer. Runs fine.


... Honda Pressure Washers

Honda gcv160 gas leaks out when running


Hi james ... Pressure Washers

My Honda pressure washer engine model GC190 is leaking gas from the carburator when running. How can I repair this problem


... Honda Karcher G2400HH-R Pressure Washer

My pressure washer leaks gas from the GAS TANK. The plastic tank has a crack in it. It has been barely used. when I fill it with gas it runs fine, but the gas leaks out in a matter of minutes.


If you know where the crack is you can use JB weld to repair it. ... Pressure Washers

Honda CU2400 1-MHC has been sitting in my parents garage for about 2 years. It was used once or twice. It looks new. I tried to start it and it wouldn't. I drained the gas and put new premium gas in it and it started but it won't stay running and the pressure is not what it should be. It doesn't clean as well as the electric one I used last time. So, my problem is, it won't stay running and when it is running it doesn't have enough pressure. Any ideas???


After sitting that long, I'd guess the carburetor linkages etc., are partially seized and the governor is not operating as it should to allow proper RPM's when under load. Real good chance carburetor is gummed up good too. I'd get carb serviced, but ... Pressure Washers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

The washer will run about 2 min. then die. i have checked the oil, air filter and gas. it has good presure when running then it acts like its out of gas by stalling and dieing. Problems with Mi T M 13 Hp, Honda Ohv, Compressor, 3500 Psi 3.7 Gpm, Belt?


It is possible that the oil pressure switch is not functioning properly or you have a lighter oil in the machine than is recommended.Post a comment if you need more assistance. ... Honda Pressure Washers

8 hp honda on cement mixer starts on first pull but shuts down as if it is running out of gas. I put fresh gas in it and cleaned the filter and bowl of the carb.


If it has a fuel filter. check that. change the spark plugs. ... Honda Pressure Washers

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Look for plugged filter anywhere in fuel line. ... Pressure Washers

Honda gas power pressure washer runs for awhile then cuts off.


Did you pour all of the old gas out before you started to use it. Sometimes condensation builds up in gas tank when stored. You need to dump old gas an put in new gas. ... Honda Karcher G4000RH Pressure Washer

I have a Northstar pressure washer powered by a honda GC160 engine. The last time i used it, water leaks from the bottom of the unit, whether it is running or not. When running, the pressure is fine. I have felt underneath and it appears that the water is coming from the second opening from the rear. Is there a pressure relief valve there. I have a manual but cannot find any descriptors for underneath the motor.


This is a piston seal issue. You can get a kit to rebuild the pump. ... Comet AXD 3020 G Pressure Washer Pump

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

I have a Honda 5.5 hp pressure washer and it wont keep running I bought it off craigs list they said the last time it ran was almost a year ago I took off the carb and sprayed carb cleaner threwout but didn make a difference I cant seem to see any jets juist the float needle and that was clean if I pour gas in the carb it will run for a for about 5 seconds and but wont stay even if I choike it. does anyone have a answer


Try soaking the carb for 15 minutes in gasoline. If you have a plugged port just sparying may not be enough to clean it ... Honda 2500 PSI Gas Pressure Washer

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

NO PRessure i have a Honda gcv160 5.5 dt2400cs CRANKS RUNS FINE AS LONG AS TRIGGER IS pulled to let water trough it has no pressure soon as you let go pressure starts building then it kills the motor will not run unless you hold handel


Hi It sounds to me like your unloader valve is stuck, this is the thing that is meant to move up and down when pressing the trigger.Please remove the unloader valve assembly and check for damage. If no damage is found then grease and lubricate this p ... Honda Pressure Washer PSI 3000

We have a Honda GCV 190 gas pressure washer. It starts up okay and runs for 20-45 seconds and then stops. We have changed bot the gasoline and the oil but run into the same problem.


Check that the fuel tap is on ... Honda 2500 PSI Gas Pressure Washer

Honda motor wont stay running ,carb not getting enough gas to stay running


As it is gravity fed you would need to remove thfuel line from the carby to check that the fuel is geting to that point,if not removanf clean fuel .bowl and filter . if ok. then a carby service is in order ,they are not difficult but you do need comp ... Pressure Washers

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a black plastic pressure relief valve starts blasting hot water. appreciate whatever insight you can give. Thx


It sounds like an air lock. Try this: With the machine off, connect the hose to the washer and let it run for several minutes to get all of the air out of the hose, and to purge any air out of the pump. Shut off the water, and connect the high pre ... Briggs & Stratton Pressure Washers

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

My 5.5 HP-GX160 HONDA ENGINE Will run only the amount of starting fluid/gas in the carberater ! With aircleaner off ! I drained the gas and put new gas in! it starts so it has spark! PLEASE HELP??????


... Pressure Washers

Honda GCV160 5.5 on a pressure washer runs only intermittently


The problem is the plastic float in the carburetor, it's not adjustable and after sitting up with gas in it it distorts. Save yourself the trouble and buy a new one, you can get them online for $15-$20. ... Campbell Hausfeld Pressure Washers

Honda gcv160 pull handle stuck in


... Honda Pressure Washers

Honda gcv160 pressure washer is leaking water


... Honda Pressure Washers

How do i fix an oil leak on a honda GCV160 pressure washer?


... Pressure Washers

I have a Honda ,gas powered power washer and when I squeeze the handle the water pump kills the motor. I've let the engine run until warm and it still can't take the water pump engaging. It's a three year old washer.


... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0925 seconds