Having problems with your Pressure Washers ?

Where does the wire-stop attach in a Briggs and Stratton 5.5 hp engine

\015 How to attach a wire-stop\015

Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where does the wire-stop attach in a Briggs and Stratton 5.5 hp engine


... Pressure Washers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Hi I have briggs and stratton quantum xm 50 engine on a garden tiller and the engine starts fine, but after a minute or two stops and turns of by itself, than again starts without problem but again after one minute stops. Any suggestions?


Try loosening the gas cap and see if it runs longer. Vented gas caps tend to get plugged and will prevent fuel flow to carb ... Pressure Washers

Engine Stops after 10min run time - Briggs & Stratton 020272 Elite Series Portable Gas Pressure Washer


Check the breather hole on the gas cap.\015\012run the engine with the cap off and see if it still stalls. ... Briggs & Stratton 020272 Elite Series Portable Gas Pressure Washer

Briggs and stratton engine hunting - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


What is the question??? ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Looking to change engine oil - Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur


... Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur

Gas leaking from carb on Briggs and Stratton engine


`v already answerd this,are you slow? with oil in the sump you can do no damage by running the engine with abit of smoke,it will clear up very quickly. i find it hard to believe youhave done the things you claim if you dont know what a carby bowl is! ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Engine lockup I have a craftsman power washer with a briggs and stratton 850 series engine, craftsman model 580752220, the engine will not turnover unless i remove the spark plug, it has electric start and will turn over with no problem like this but if i put my finger over the plug hole it locks up immediatly


Sounds like the intake or exhaust valve is not opening. ... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

The engine starts just fine. Everything goes okay until I pull the trigger on the spray gun and then the engine stalls out within 2-3 seconds after the water starts coming out. It is a 2700 Briggs and Stratton engine.


One thing I have found about pressure washers...you need to run water through the hose and everything until you get all the air out...or they will bog down and such until the air is out. ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

I have a briggs & Stratton 675 series engine in a Craftsman front wheel drive rotary mower which won't start. It was fully serviced and used 3 times this season but now it won't start. It


If it has hit a object, the flywleel key is partially sheared, and needs to be replaced. they are very inexpensive,CHEAP. this will through the engine out of time just enough it wont start. ... Briggs & Stratton Pressure Washers

Briggs & Stratton engine loses power


Hello herb1007If it is running it would burn any oil off the top of the piston. (that got there when you tipped it). It sounds like you carburetor needs cleaning. There are sprays on the market that sometime help with this. ... Briggs & Stratton Pressure Washers

Briggs & Stratton 6 horsepower engine


... Pressure Washers

Have a Craftsman 2550 MAX PSI, 2.3 MAX GPM, Briggs & Stratton Powered Pressure Washer seems like the engine is ceased how can I fix it? need a copy of the manual with exploded pic of engine


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a 6.75 hp engine on a Briggs and Stratton power washer. I need the torque setting for the engine bolts.


... Briggs & Stratton Pressure Washers

Briggs and Stratton 6.5 hp engine


... Pressure Washers

Does briggs and stratton make the engine for dewalt pressure washers


If it is a DPH it has a Honda engine. If it is a DPD it has a Dewalt engine that is made by either Honda or is a Chinese copy of the Honda engine. I looked at a photo of the engine and it looks like a Honda engine not a Briggs engine. Look on the eng ... Dewalt 3800 PSI Pressure Washer

Briggs and Stratton pressure washer will not spray water. The engine is fine but water does not flow.


The nozzle on the end of the spray wand has a very small hole in it that can be easily clogged by any sort of debris that comes through the water supply.If the nozzle can be removed, just take a pin & clear the hole from the outside & rinse i ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have a 2550 psi pressure washer with a 6.75 hp briggs and stratton engine with ready start. i wont start. has gas and oil plug looks good. any solutions?


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a murray lawn mower powered by briggs and stratton, i'm trying to fing a manual on the internet but it says to put my model number, and on my engine it says that my model number is lev100 but nothing on the internet comes up, i need help. it also has a date (1995-1998). i don't know how many horse power it is.


The model numbers on a briggs engine are stamped into the metal cover above the spark plug and are the first 6 digits the rest are engine codes and type. ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Hello, I have a Craftsman Clean N Carry® 2150 psi Gas Pressure Washer w/4.0 hp Briggs and Stratton Engine. My problem is that I can't get any water to come out of the nozzel. What can I check to fix the problem? Also, where can I get a book to look at for parts and problems?


... Pressure Washers

Two problems please: craftsman 2150psi briggs and stratton engine washer, will not start when hot. and secondly, i was washing with regular pressure, then noticed a pressure drop at the nozzle, then the unit shut down. no water leaks at the manifold. water supply was strong. any ideas?


Nozzle dirty, clean out with small diameter wire. ... Pressure Washers

I have a briggs & stratton pressure washer that every time I engage the spray hose my pressure washer stops. Why???? I have left it running for a couple mins. before engaging, doesn't seem to help


PROBABLY the valve that admits the water to the pump is sticking. USUALLY bad O-Rings. If the valve sticks closed, the pressure won't build up. If it sticks open, the washer will stall. Most other problems are engine problems due to bad gas, carb ... Briggs & Stratton Pressure Washers

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0985 seconds