Having problems with your Pressure Washers ?

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

I have a problem with a bosch dishwasher i put in a kitchen 10 years ago. knob on left side buttons on right , stainless steel interior. i dont think client has ever used it. he must have put in new disposal but did not clear knock out. he went to use it with regular dish liquid.it started to leak and foam. he left me a note to look at it. 10 hrs later its still running and water is everywhere. i disconect from disposal and pump water into bucket but now can not get water to go in to it. tried b


First check that the valve under the sink is turned on sorry have to put this part in next thing to check would be the inlet water valve and assure that you do have power going to the valve if you dont then you would look at the float switch as the p ... Bosch Dishwashers

Troy Bilt pressure washer model 020209 will not build pressure-have checked all screens and intake in pressure hose and garden hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help.


A leaking gun will kill all the pressure. You may need to repair or replace the gun ... Briggs & Stratton Pressure Washers

Water is leaking from inside the pump and i see no damaged plastic from the outside.the motor keeps on even after i release the pressure gun and most of all ther is no or less pressure when i trigger the pressure gun.please can you suggest what parts do i have to change for it to be fixed 10x


Hello. The internal seals need to be replaced. Obtain the Karcher rebuild kit I got from pressureparts.com\015\012 \015\012J. ... Karcher Quick Connect Nozzle Set

I have GE GSD2300r00bb, it was working just fine the other day no unusual noise, today we tried to run it, just a little bit into the cycle, i heard a strange stalling noise that sound like the motor is stuck or something, i put a camera(in a ziplock bag) in the dishwasher to see if the blade is spinning, no spin, the water did squirt for about 1 sec then stop but still leaking out somewater. Is it the motor or the water pump. I just got this dishwasher about 1.5 yrs. Is this something i can fix


... GE GSD2300RBB Builtin Dishwasher

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

HAVING LEFT MY KARCHER B602 OUT OVER WINTER ,IT STARTED BUT LEAKS FROM INSIDE THE CASEING. TOOK CASE OFF AND FOUND PLASTIC PIPE HAD COME OFF PUT THIS BACK ON STARTED MACHINE AND PIPE CAME STRAIGHT OFF. WATER WILL FILL SOAP BOTTLE IF PIPE IS HELD ON WITH WIRE, BUT STILL NOT MUCH PRESSURE FROM GUN. ACN YOU HELP WITH THIS PROBLEM.


... Karcher Pressure Washers

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

I noticed water leaking underneath my dishwasher through the floor joists to my basement. It was a small but steady drip through the joists. I turned off the water to the dishwasher and the leak stopped. I looked inside the dishwasher and there is still some standing water inside the dishwasher, but I cannot see anywhere that water is standing under the dishwasher. I am wondering if the leak is at the pump or at the door? But I see no evidence of the seal leaking.


This is probably the line that goes from the water inlet valve on the bottom of the dishwasher up to the valve leading into the dishwasher itself. It is probably a black corrugated rubber line. This is an extremely bad design, but the solution is s ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My karcher hds 745 is running but just won't build up pressure, this occurred after a really cold few weeks this winter and I hadn't put anti-freeze through the machine to winterize it. There's no water coming from the bottom of the machine when it's running as i've read that if the pump seals are faulty water will escape from the pump etc. The machine motor runs ok but no pressure is acheived on the gauge whatsoever. Any help would be appreciated. Thanks in advance Paul.


... Karcher Pressure Washers

I have a water leak on my smeg di612ca - i have replaced the drain pump with a new one as i thought this was the culprit but it still appears to be leaking water from the inlet of the drain pump into the base - any ideas? many thanks


... Smeg Dishwashers

Karcher k3.68m leaks from the pump area. If I turn it on without holding the trigger down on the wand it will not blow pressurized water. If the motor is idle and the water is turned on then it leaks a lot from the pump area. What part should I replace?


... Karcher PSI Electric Pressure Washer

Hotpoint hda3440g02sa leaves a little water at the bottom of the dishwasher I have checked the check valve have even replaced I have put a high loop in the drain hose and still no help it leaves just a little water I hate to put a new pump because I have on this type of dishwasher before and still no help


Hi\015\012\015\012 \015\012\015\012When the dishwasher leaves just a little water and drains\015\012maximum then I would say that it is fine & the drain pump is also working\015\012fine. These units are designed in such a way tha ... Dishwashers

When I power the Karcher 520M water pours from the handgun - there is now leak until pressure is applied. the pump does not cut out but I don't know if this is a problem with too much pressure causing the leak or too little pressure because of the leak. there does not seem to be a way to dismantle the handgun - is this correct Bill


Not too much pressure, a bad gun.Unfortunately you will have to replace the gun. About $65.00 Canadian ... Karcher 2500 PSI Pressure Washer

Hello, I have a problem with our Miele G646SC Plus dishwasher. It starts its cycle OK, draining out any residual water, taking in fresh water and doing the initial rinse. After about 5 minutes it then stops with the "inlet/drain" red light flashing. The detergent is still in the holder and the water is still cold. The filter at the bottom of the compartment is clean, the drain pump spins freely. I've also checked for any leaks in the bottom of the machine that would trip the styrofoam/microsw


Hi\015\012\015\012 \015\012\015\012The light flashing means an issue while draining. You would need to check for air\015\012gap on the dishwasher, it may be clogged. It prevents dishwasher\015\012from drain ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Hi i have a bosch model no sgs53e02au australia 2 weeks ago put a wash through over night woke up in morning noticed still making noise opened up the door of dw still making noise sort of brrrrr noise constant not stopping unless press botton off would turn off still had water in bottom rang company they told me to clean filter which i did found glass particules took water out with sponge clean it rang back they told me to get a piticuler tool size 20 to unscrew and pull out pump sat there unscr


... Bosch Dishwashers

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

We have water leaking around the top of the pressure pump on a BM 80913 2600PSI pressure pump. Is there a parts list/manual for this item?


Http://www.mastertoolrepair.com/black-bm80913-p-39651.html ... Honda Black Max 2600 PSI Pressure Washer

Problem with AEG 24in Favorit 40630 Free-Standing Dishwasher When I'm turn on the machine the top and middle signal light are flashing and the pump working for some time and stop. I know this device detects water leaks and is a polystireene float / micro switch that puts the machine in pump out mode. But there are no water under the float! Alex


... AEG 24 in. Favorit 40630 Free-Standing Dishwasher

E1 fault code Dishwasher runs for about 5 minutes. Water fills up at bottom of unit and then machine seems to pause then fault code E1 appears then water is pumped out from bottom of machine. There are no leaking pipes and drain is installed correctly. I installed a new wash pump and fault still appears.


Hi,\015\012I think both the heater and thermostat / trip switches need to be checked.\015\012If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out.\015\012Heating elemen ... Dishwashers

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

On an AEG Favorit 64570 VI we have an error 20. Manual indicates a drainage problem, however when we pour in water, it gets pumped out without a problem. No obstructing in the exhaust tube. Next we checked the pressure sensor, by taking it out and blowing into it. It clicked as pressure was applied to it, so the inner switch worked. Everything is clean, but still we get an error 20. What does seem strange is that the appliance does not take in water. Any suggestions are welcome.


... AEG 23 in. Favorit 86070Vi Built-In Dishwasher

Whirlpool dishwasher top spinner and top rack spinner is not putting out water or very little and not spinning. I have taken apart and cleaned everything including the sump / chopper, can't find any blockage in the tubes that deliver water from the pump to the spinners. Is the Pump or Motor done? how can that be it's less than 5 years old? Its a Whirlpool Quiet Partner I Model DU1055XTPQ3


First, confirm that the holes are not blocked on these arms. (I did not want to assume you have done this.)Then check the impeller on top of the motor stem for being loose or worn/damaged - to rule the impeller out. If it is fine, then ... Whirlpool 24 in. DU1055XTP Built-in Dishwasher

Water pump I have a porter cable pressure washer model# 2425. I let my presure washer in the garage during the winter(no heat) and now i have a probem with the pump. I start the motor everything is find but when i put the water in the motor stop. Can you help me


... Pressure Washers

Kenmore Dishwaher 58715142400 leaking from round looking pump on bottom. It was not draining so i unclogged the hose and put it back on. now it is leaking from a pump or something where it doesn't look like water should be at all


May be blocage in the exit pump ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1439 seconds