Having problems with your Pressure Washers ?

What of oil to change on the 2700 PSI Brigg &

\015 What of oil to change on the 2700 PSI Brigg & Stratton enigine? On a "Generac pressure washer" and also what type of oil and how to change the oil on the pressure washer pump. \015

Answers :

Id your engine model and consult the briggs site........
the oil in the pump is filled during assembly so it doesn't have a nice pair of fill and drain plugs

briggs :
http://www.briggsandstratton.com/eu/en/
Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What of oil to change on the 2700 PSI Brigg &


Id your engine model and consult the briggs site........the oil in the pump is filled during assembly so it doesn't have a nice pair of fill and drain plugsbriggs : ... Pressure Washers

Looking to change engine oil - Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur


... Briggs & Stratton Murray 020456 2400 PSI 20 GPM 190cc Briggs Stratton Gas Powered Pressur

Change oil briggs - Mi T M Mi-T-M CM-1250-0MEH NA Chore Master 1250 PSI Chore Master Pressure Washer CM-1250-0MEH


... Mi T M Mi-T-M CM-1250-0MEH NA Chore Master 1250 PSI Chore Master Pressure Washer CM-1250-0MEH

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

Troy built 2350 psi 2.0 gpm. pressure washer. starts onne then dies. will not start again. has briggs and straton motor. has been sitting up for the winter. have changed spark pulg. checked air filter that is clean, has oil and gas.


... Pressure Washers

My Karcher 2400 PSI pressure washer is not starting after about 5 years. What type of spark plug and gap should I change the old out with and what kind of oil do you recommend. I don't think I have ever changed the oil but way less that 50 hours on the machine. Thanks


... Karcher 2500 PSI Pressure Washer

Why is oil coming out the side of my pump, I just changed the oil and it started doing this? I own a Porter Cable 4,000 PSI.


You didn't state your model number so I don't know exactly which type pump you have. With that; there is no 'oil pressure' in power washer pumps. The internal parts work in an oil bath/splash environment and the pump body is vented, usually at the ... Pressure Washers

Changing oil in 1750 psi excell pressure washer


... Briggs & Stratton Pressure Washers

Oil I have a Briggs and Stratton 2200 psi pressure washer. It doesn't specify an oil ~ other than to show a photo of synthetic pressure washer oil manufactured by them. I can't find that specific brand anywhere, what can I substitute it with? Ace hardware was stumped.


Remember when your searching for something you can't find the internet is always your best bet. You should also use a good search engine; www.bing.com is one of the best search engines I have ever used. I searched some stores that have the oil your l ... Briggs & Stratton Briggs Stratton 2000 Psi Pressure Washer Freeshp

Gas got into the oil through carb. changed oil. rope won't pull. 13hp briggs on a generator.


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Cannot figure out how to remove the oil plug to drain the oil. Label points to a spot that looks like it might be a plug, but can't figure out how to remove it. It is a 2500 psi Mdl VR2500 Briggs & Stratton engine Honda Power Washer. Ken from NH


Should take a 3/8" socket extention ... Pressure Washers

What oil do i use to chane oil - Briggs & Stratton 2200 PSI Gas Pressure Washer


For normal usage I would reccomend straight 30 weihgt oil.If you are planning on using it during colder temperaturesI would switch to 10w-30. thanks ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Change oil on karcher 1900 psi - Karcher 2500 PSI Pressure Washer


... Karcher 2500 PSI Pressure Washer

I have a John Deere 3800 psi pressure washer, it stopped having pressure in the middle of a job. No restrictions and still turns on and sounds great. Checked pump oil and it was a milkshake green. Changed pump oil and still doesn't have pressure.


... Pressure Washers

How much oil does it take to change oil in the briggs and statton power washer


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have DeWalt3750 psi pressure washer, its been long time since I used it, now that I wanted to use it, I can not start it. I already changed the oil and filled it up with new oil but still can not start, What is wrong with the washer? thank you


Here is the long answer with everything we learned while using a power washer twice a day for years::This assumes you did not turn power washer over or on its side to drain oil, or dirty oil will flow into carburetor requiring complete carburet ... Dewalt 3800 PSI Pressure Washer

Started by Craftsman 2700 PSI , 2.3 GPM Briggs & Stratton Powered Pressure Washer for first time in 9 months. Added new oil, and gas. started but is smoking from muffler and is dripping what appears to be oil near the exhaust end. I shut it down. What could this be due to?


The first thing I would check would be the oil level, to make sure you didn't put in too much oil. If the oil level is correct, it could be a stuck piston ring, letting oil blow by the piston, and out the exhaust. If this is the case, you are going ... Craftsman 2700 PSI,2.3 GPM Briggs & Stratton Powered Pressure Washer - Ca. Model

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

How to change oil in a pressure washer


From the manual CleanShot 2050 Briggs and Stratton\015\012\015\012Change Pump Oil\015\0121. Drain engine oil and fuel from pressure washer\015\0122. Use an 8 mm allen wrench to remove black pump oil cap between high pressure ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I change oil on my 3700 psi honda motor pressure washer motor and pump and after i done that the tigger rope is to hard to pull looks like some who is pressure some where can some one help me whit this problem .. thank you


Most likely has nothing to do with oil change. Have someone hold the trigger on handle open to relieve pressure on system/pump , this will make engine turn easier when you pull rope. ... Karcher 2500 PSI Pressure Washer

I have a Karcher 3000 psi with Honda GC190 6.0 engine - Oil Change


... Karcher 2500 PSI Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

How do I change oil to pressure washer? - Karcher 2500 PSI Pressure Washer


At the bottom of engine you will notice a plug take it out and oil will draine out .... replce it then fill at top where u see oil dipstick ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0600 seconds