Having problems with your Pressure Washers ?

Husky hu80432 when pressing the trigger the soap will not come out


Answers :

Repair Help & Product Troubleshooting for Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Husky hu80432 when pressing the trigger the soap will not come out


... Pressure Washers

Karcher K3.92 M 1750 PSI poweer Washer motor won't start. Followed Reset/Test/Reset sequence with cord plugged directly into outlet. Light on cord near Reset comes on when Reset pressed down but goes off when Reset released (Normal?) Switch ON and trigger pressed releases water stream but no motor action.


They are sensitive to large extention cords. My father in laws pops reset when a small cord is used. If internally shorted- motor will continually pop the reset even plugged direct to outlet. Check voltage at outlet. ... Karcher 2500 PSI Pressure Washer

I have a Husky pressure washer with a Honda 2600psi engine. Problem is, no water will come from the pressure hose. I connected the water w/out the pressure hose and water flows thru strongly. I then connected the pressure hose w/out the wand and water flowed thru the hose fine. When I connect the wand and pull the trigger, nothing. I have replaced the wand and that was not the problem. Please help.


Check the quick disconnect to the wand these are spring operated and can get stuck ... Pressure Washers

Hello there.My Karcher pressure washer motor constantly runs with no pressure coming out of trigger gun.I have tried another gun with the same result.The motor should stop/start when you press gun.The model is a 350M plus VPS. Could you please help.thanks


The valve that admits more water to be compressed is stuck. It is likely the O-Rings on it need replacing. No water to the pump, no pressure!\015\012\015\012The motor will stop when pressure is up to the designed pressure. ... Karcher Pressure Washers

I have a Husky HU80722 pressure washer 2600 PSI with a 160 CU IN engine. It runs great but when I pull the trigger the water does not come out under pressure. Please let me know what I need to do.


... Honda Pressure Washers

Hi I have a karcher 2020b. When power is on it sounds like it is on... When I press the trigger almost no water comes out. When this happened unnoticed oil on the floor afterwards. I have cleaned the filter, the nozzle and flushed the water through to get rid of a possible air lock to no avail. It also smelt slightly of burning plastic - any help would be appreciated. Thanks


... Pressure Washers

I have a Kracher K 4000 GS pressure washer and it seems to have been fine until today. When I start it and squeeze the trigger there is nor pressure, water comes out but as it would normally from the hose. The engine does not even seem to be under load. I used it the other day and got pressure when I picnhed off the soap hose but that did not work this time.


... Karcher G3025OH Pressure Washer

Karcher k2.35 pressure washer, motor is running, water is flowing, but when you press the trigger only a fine jet of water comes out.


... Karcher Pressure Washers

I have a Husky 2600 Psi 2.3 GPM Honda powered gas pressure washer. When i turn it on the motor runs fine, But when i squeeze the trigger the water is not pressurized when it comes out. How do i fix this problem?


... Honda Pressure Washers

Pressure water comes and goes wen I press trigger , that happens some times not old the time


... Karcher 2500 PSI Pressure Washer

Gas Husky 2200 No pressure Confirmed water coming through pump and wand. When trigger pulled water discharging out rear of manifold.


... Pressure Washers

Husky 3000 pressure washer, Axial Cam Pump Diagram , need to take apart to clean caked soap out. model# HU80432


... Pressure Washers

Kskarcher k 320 ,replaced the elbow inlet and after that it does not work . with water connected the stream of water comes when the trigger is pressed but no pressure or the pump does not start . Any


... Karcher Pressure Washers

Hi experts, My Indesit IDL530 dishwasher never seems to run on any of the 5 programmes. On pressing the power button, the red light comes on and on pressing the start/reset button, the light signalling washing comes on and not the one showing water intake. But even then nothing progresses and just a buzz with that wasing indicator on shows for a second and goe off. But today only the buzzer sounds when pressing down the start/reset button and no indicator comes on atll. Will be great if you coul


... Indesit Dishwashers

Karcher 3100 pressure washer, motor runs fine but when I squeeze the trigger on handle, high pressure pump won't come on unless I remove tip and water is coming out of wand without restriction. Help anyone have any ideas? It did come on once but when I let go of trigger it wouldn't come back on.


... Alfred Karcher Quick Connect Nozzles 2600 3100 Psi 5 Pack

Have a Karcher kb4040 that continues to run constantly even when the trigger isnt pressed. Also water flows out of the detergant hose when im not pressing the trigger. Pressure seems down slighlty, not much. This happened after i ran water out of trigger gun with no lance attached, machine switched on. Seems to leak from trigger handle aswell. Many thanks in advance


This is two things. One is the back flow check valve to the soap line is leaking. The other is the pressure switch on the output side of the pump. ... Pressure Washers

Water coming out of the soap dispenser on the pressure washer


I would suspect a piece of debris is caught under the injector ball valve. It may also be clogged with soap if you failed to flush it clean after the last use. Disassemble the valve and give it a good cleaning. Be careful as there is a small ball bea ... Karcher PSI Electric Pressure Washer

What do i need to do for my soap magic. It stoped working on me. I put new batteries in it and filled it up with soap. The light comes on and it acts like it is going to work but no soap will come out.


... Dishwashers

I have a Kitchenaid Dishwasher Model KUDC25CHSS1. (Manual says KUDC25CH). The Delay Hours button is stuck on 2 hours. The manual says to cancel it, press it until no lights are on, but when we press it, the Child Lock light comes on. I tried pressing Energy Saver Dry to cancel the Child Lock, but that didn't cancel it. I tried turning off the circuit breaker for 5 minutes, but the same light(s) come back on when I re-set it.


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

When I pull the trigger on the pressure washer no water comes out, but when I take the attachment off, water comes out just fine. It seems as if the trigger isn't working or there is a blockage in the tip. How can I know which it is?


... Ace Hardware Pressure Washers

Dishwasher whirlpool GU2475XTVY - I've tried the high temp/heated dry/high temp/heated dry sequence- most lights come on ... i've tried it with /without open door / pressing cancel, etc. after pressing sequence only FIVE lights come on (rinse, high temp, sani, heated dry, cancel. after the


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My kids put liquid dish soap (not for dish washers) into the hole where you put special rinse product. We got all the soap out of the hole and took towels to dry out the tub, but F1 comes on even when the washer is turned off. We have the double tall dish drawer in stainless steel. Even though they did not put anything in the bottom drawer it too comes on by it self and shows F1. I can not find our manual. Please help. Thank you so much. Kim Toth


You can download the user manual but that may not help you solve the problem.\015\012\015\012I can see that there has been foam ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I suspect that water is not coming out of the spray arms.  Dishes are not coming out clean.  In addition, soap dispenser is not getting rid of all of the soap.


Check to make sure the water is getting hot and that the heater in the dishwasher is working. Check spray arms for clogged holes and debris. ... Maytag Dishwashers

May tag jet clean model number DWU 9921. Dishes not coming clean soap dispenser opens but soap soes not come out. Disges are still wet after heat cycle


Sounds like you have the stripped emacorator and pump head..\015\012http://www.appliancepartspros.com ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

I have Karcher 520m and when you press the trigger you can hear what sounds like a relay engaging but there is no water pressure, then it will fire up and work, but next time you press the trigger the same thing happens, I have been using it on harvested water, but even connected to the mains it does the same thing. Its now got to the stage it doesnt want to work at all.


The issue you are having is with the unloader valve in the pump. Now with the 520m it is a little bit harder to repair than with more gasoline powered pressure washers but it can still be done. It would be easier if I could just send you a email of t ... Karcher 1750 Psi Elec Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0987 seconds